Question about 1991 Jeep Cherokee Limited

1 Answer

Factory radio harness was cut Help Help Help!!!!!!!

I need a radio wiring diagram for a 91 Jeep grand Cherokee to see whats what because when I got my jeep the factory clips were gone for the radio. Thanks for your help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 150 Answers

I hope this helps there was only a grand wagoneer listed for 1991

Posted on Nov 19, 2008

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a radio color diagram for a 1996 jeep grand cherokee


1996 Jeep Grand Cherokee Car Stereo Radio Wiring Diagram.
Car Radio Constant 12V+ Wire: Red/White
Car Radio Switched 12V+ Wire: Red/Gray
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Blue/Red
Car Radio Dimmer Wire: Orange
Car Radio Antenna Trigger Wire: Green/Red
Front Speakers Location: Doors
Left Front Speaker Wire (+): Green
Left Front Speaker Wire (-): Brown/Red
Right Front Speaker Wire (+): Purple/Yellow
Right Front Speaker Wire (-): Blue
Rear Speakers Location: Rear Doors
Left Rear Speaker Wire (+): Brown/Yellow
Left Rear Speaker Wire (-): Brown/Light Blue
Right Rear Speaker Wire (+): Blue/White
Right Rear Speaker Wire (-): Blue/Pink

Sep 18, 2016 | 1996 Jeep Grand Cherokee

1 Answer

Replaced factory radio with aftermarket radio, now heat, ac, radio, controls not working (checked fuses, none blown)


was this a hack job?> cutting wires. (cutting harness wires?)
or did you use those nice install kits with the connector pig tails
that find the factory harness connector.
if you messed it up, only the FSM can save you now.
read the schematics.
see ZJ
here
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

no electrical tape allowed (heat shrink)
no wire nuts (horror to max on cars)
no cannibal splices. (the cut in to factor wires, nasty they are)
or it can be bad.

Feb 18, 2014 | 1993 Jeep Grand Cherokee

1 Answer

97 jeep grand cherokee no sound from radio tested radio out of car it works. old owner had amp under back seat and cut into speaker wires in harness reconnected but still on sound


You will need to trace the speaker wires to see if they are disconnected anywhere in the harness. are you sure the speakers are OK? Fopr wire locations on the radio try going to: http://www.installdr.com/ They list the pin locations and wore coding you will need.
Good luck

Feb 20, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Radio & anttena will not come on with ignition.


From the factory wiring there will be a red/white wire with a constant 12v and an ignition switched 12v wire which is red/gray. Hook those to corresponding wires on the aftermarket wiring harness. You may have the constant and switched wires backwards. Also the antenna trigger wire (usually blue on aftermarket radios) should be hooked up to the green/red wire on the factory harness.

For a complete wiring schematic check out www.the12volt.com

May 10, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Need wiring diagram at interior connector for installing '91 cher


I have the diagrams for you if you still need them. I need an email address though because I have it as a pdf file.

my email is bomber6509@yahoo.com

Mar 24, 2009 | 1991 Jeep Cherokee Limited

1 Answer

I need a wirng diagram for the tail lights in my 200 grand cherok


You dont want to cut your wiring for the tale lights on your jeep,
stop at a auto parts store and pick up a made for your jeep plug in adapter,
RD

Jan 12, 2009 | 2000 Jeep Grand Cherokee

2 Answers

How to remove factory radio


Removing the radio bezel is easy, which is the plastic surrounding the radio including the heater vents. Slide something thin, or your fingers underneath from the bottom of the bezel and gently pull towards you, carefull not to break any tabs. Once you have one tab out keep working all around the bezel until its off. You will then see the radio and how its mounted. There are 4 screws holding the radio in. Remove and put in the cup holder so you dont lose them. Pull the radio out towards you until you can reach behind and unclip it from the harness. You must also remove the antenna wire from the back of the radio. (before you begin its a good idea to unhook the battery)

To install an Ipod they sell the Ipac-chy, which is a can-bus unit. The unit clips into the radio harness then the other side clips into the car harness. They are around $80. It comes with a patch cable that charges the ipod as well. Look around online for the best price. Metra I believe has one too.

Nov 20, 2008 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

552 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...