Question about 2000 GMC Sierra

1 Answer

2000 GMC Sierra Power seat stopped working

The power seats stopped working i checked the fuse panel and the circuit breaker was hot so pulled out to prevent meltdown. The seat fuse was still intact.

Posted by on

  • 3 more comments 
  • fasnuf Dec 02, 2008

    Thanks for the advice, i'll check that out!!!

  • Anonymous Mar 23, 2014

    power seat stop working put new breaker in started working then new breaker went bad

  • Anonymous Mar 29, 2014

    Seat overheated, unplugged switch, pulled fuse but battery still went dead. Is there more than one fuse on this system?

  • Anonymous Mar 30, 2014

    location of power seat circuit breaker

  • Anonymous Mar 31, 2014

    i have checked all fuses and breakers and i cant see any melted wires.the passenger side works fine

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 99 Answers

Check the wires behind the seat control on the side if the seat, sometimes the wires will get pinched and short to ground

Posted on Nov 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 gmc sierra power seats not working


Lots of things can cause this. A circuit breaker(not a fuse) could be open, the seat control switches may have failed. The seat rails may need lubrication, the motors may be bound, the body control module may have failed. Test all of the above and you will find it.

Jun 05, 2014 | 2004 GMC Envoy

1 Answer

2004 GMC Sierra drivers side seat heater turnes on and off by itself


The seats are powered by a 30amp breaker which includes the circuits for the power motors.
The signal from the control switch goes to a door module then to a memory seat module, then to the heater elements.
It may be easier to disconnect the heating element for now, repairs will need a shop manual to test and trace the circuits.

Apr 29, 2013 | Cars & Trucks

1 Answer

My power seats wont work on my 2000 jimmy cant find fuses or circuit breakers for the seats can you help thanks john


there is a 25 amp circuit breaker for seats.should be marked POWER SEATS in the fuse block. the ORANGE wire at the switch gets power from that breaker, so check the ORANGE wire for power.

Sep 23, 2011 | 2000 GMC Jimmy

2 Answers

Power windows stopped working


If ALL the windows quit working, then it's either a bad circuit breaker or a short circuit. There are two fuse/relay/breaker panels: under the hood and under the back seat cushion. The power window circuit breaker is under the back seat cushion, near the battery. Remove the back seat completely, then remove the fuse panel top and inner cover. The fuse diagram is inside the top cover. Circuit breaker # 57 is the one. Pull it out. Use your voltmeter/multi-tester to check for continuity through the breaker. If there's no continuity, the breaker is bad and needs to be replaced. If it's good, then you have a dead short somewhere that causes the self-resetting breaker to uncouple when you attempt to operate a window. If so, the short will need to be traced down and repaired. Good luck.

Jun 27, 2010 | 2000 Buick LeSabre

1 Answer

On my 2003 yukon I have no heated front seats working and no power seat for the drivers side.


Look in the fuse box on the driver's side of the vehicle on the outboard side of the dash under the triangular cover which snaps off and on. This panel is not visible when the door is closed. If you have your owner's manual, look on page 5-104. This is where the fuses and relay/circuit breaker descriptions, layout, and specifications begin. This section runs to page 5-111.
You are going to check fuse number IGN3, a red plastic, stab-in miniature 10Amp fuse. It has an "S"-shaped element visible through the side of the fuse body. If the element is broken or burned, replace this fuse. DO NOT use a replacement fuse of ANY other rating; use an identical 10Amp fuse ONLY.
You are also going to look for the "Center Instrument Panel Fuse Block," located under the instrument panel, to the left of the steering column. You are going to check the device labeled "30A CB Seat." This is driver and passenger seat module circuit breaker. This circuit breaker is an automatic resetting device, replacement is necessary only if there is no other problem, and it will not reset.
If only the driver seat is affect, the problem is not the CB Seat; check the wire harness and connector under the seat. There is almost no clearance under the seat, and it may needs be removed to check this. There are four 14mm or 15mm bolts, one at each outboard corner of the seat, the front ones under snap-on plastic covers, which anchor the seat to the vehicle. These bolts are installed with an anti-seize anchoring compound which make them difficult to remove, but aside from elbow grease, there is no other trick to removing them.
Good luck, and if I have helped you, please remember to comment/vote.

Feb 21, 2010 | 2003 GMC Sierra 1500

1 Answer

Power seats and seat heaters right windows not working 2006 gmc


check your fuses. The circuit may have been overloaded by the window motor.

Feb 08, 2010 | 2006 GMC Sierra

1 Answer

2000 GMC Jimmy Power seat stopped working


Left side of the dash, to the right of the IP fuse block. Its a 25 amp circuit breaker, an aluminum cased breaker. CHECK FOR POWER ON THE SEAT SWITCH "A" TERMINAL AND GROUND ON THE "D" TERMINAL. IF YOU HAVE POWER AND GROUND THE SWITCH IS BAD.

May 27, 2009 | 2000 GMC Jimmy

1 Answer

Power seat not working


go here for help

http://autos.groups.yahoo.com/group/villagerquest/

Circuit Protection
Power is supplied to the seat motors through the 30A POWER WINDOW fuse. The fuse is located in the LH engine compartment fuse junction panel and is hot at all times. The circuit breaker is behind the interior fuse junction panel and prevents current overload and component damage.

Mar 28, 2009 | 1998 Mercury Villager

1 Answer

2000 GMC Jimmy Power seat stopped working


both my power seats are not working at all ..it first started with driver seat , to make seat move forward and back tilting the recliner was working then it went out ..not working either..then after a month later my pasenger seat stopped working as well... what might be the issue..please reply

Jan 23, 2009 | 2000 GMC Jimmy

1 Answer

Seat Belts/Front Seats


seats use heavy corrent & use relays instead of fuses. check relays in fuse panel. see chart on cover or owner manual for location.

Also, this is for 96 villager seats.

Circuit Protection
Power is supplied to the seat motors through the 30A POWER WINDOW fuse. The fuse is located in the LH engine compartment fuse junction panel and is hot at all times. The circuit breaker is behind the interior fuse junction panel and prevents current overload and component damage.

go to this site for more help

http://autos.groups.yahoo.com/group/villagerquest/

Aug 24, 2008 | 1994 Mercury Villager

Not finding what you are looking for?
2000 GMC Sierra Logo

Related Topics:

681 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...