Question about 1998 Ford Contour

1 Answer

Heat don't workin 1998 for contour

Wihen you turn it on it makes a noise as if it wants to come on but don't

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 193 Answers

Sounds as if your heat vent door is hanging up or blocked. When the car is completely warmed up and the heater is on, feel around under the dash near the heater system to see if you can feel any warm or hot air coming out.
bill

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 1998 ford contour my windshield wipers wont work and a loud banging noise is happening even when they are off


It sounds as if the wiper linkage has come adrift, normally will require renewal of a link arm

Oct 20, 2012 | 1998 Ford Contour

1 Answer

1998 Contour, clicking noise coming from front wheel on drivers side as I'm driving(it's a consistent click)


With out hearing the noise it is hard to say but it could be a wheel bearing but most of the time a bearing will hum, this could be a bad cv axle or a brake brake hitting the bracket, try to drive the car and hit the brake a little and see if the clicking goes away, if it does then i would say it is in the brakes. if it does not then have the cv axle checked.

Oct 14, 2012 | 1998 Ford Contour

1 Answer

Breaks ligh doesn's workin a ford contour 1998.onlu in the midle,


check the bulbs and make sure there are no shorts in the wires

May 13, 2010 | 1996 Ford Contour

1 Answer

1998 Ford Contour rough idle when i turn my air conditioning on


Rough idleing, especialy when the air condition is on, is really quite normal for old cars. I drive a 96 corolla and when the airconditioner is turned on, the car will make a deep whining noise. It should stop when shifted into drive(automatic) or gear(manual) in most cases, it is not a serious problem. However, if you feel the idle is too rough, i would recommend fuel additives designed for highmilage cars. I use fuel injector cleaner. after many uses, my rough idle ended. If after trying this, you find the idle to still be to high or rough, have a talk with your local mechanic. Hope this helps

Apr 09, 2010 | 1998 Ford Contour

1 Answer

How do I replace the heat sensor and the fuel gage for 1998 ford contour.


www.autozone.com has a section on do it yourself, step by step instructions for many makes/models. also, look at www.chiltondiy.com

Mar 09, 2010 | 1998 Ford Contour

1 Answer

1998 ford contour 2.0 4 cyl automatic. made rattling noise in engine then stopped running.turns over but will not start. put on obd2 reader and came up with no codes


Does it seem to turn over quickly? If so i'd suspect the timing belt broke considering the rattling noise heard before it stopped.

Oct 22, 2009 | 1998 Ford Contour

1 Answer

98 ford contour 2.5- a loud roar from front drivers side of car


This sounding like an Idler bearing problem, Sounds like the idler bearing that supports your belt is either loose or needs replading. I say this because when you get the RPMs up on the motor the noise should almost disappear?

Aug 19, 2009 | 1998 Ford Contour

1 Answer

Runs when 1st started, cold engine. Slips when heated up. Makes a whining noise. Found that there was 1+ quart extra fluid in it.


DRAIN THE EXTRA QT. OF FLUID. DONT PUT EXTRA QT. OF FLUID IN THERE TO BEGIN WITH NEXT TIME.

Jun 17, 2009 | 1998 Ford Contour

1 Answer

Back wheel bearings noise


i have a broken down ford contour 1998 i dont know if it will help but when you replace the bearings you have to replace both at the same time or it will end up making the same noise again. go to the parts store, and get TWO bearings. replace them and it should fix the problem.

Oct 20, 2008 | 1998 Ford Contour

2 Answers

Over heating


replace thermastat to start flush cooling system out at same time

Aug 01, 2008 | 1998 Ford Contour

Not finding what you are looking for?
1998 Ford Contour Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...