Question about Chevrolet Impala

1 Answer

Installation of chev bel air headliner

Are there, or do you have any instructions regarding the installation of a 1955 chev bel air headliner? and for a 1958 chev impala? (headliner as well)

Thanks, Leo Medd.

Posted by on

  • yadayada
    yadayada May 11, 2010

    To old for on line instructions to exist. but this kind of job is for the pro, not the DIY mechanic, have done it myself, looked terriable.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

J'aimerai entrer en contacte avec pour l'achat de votre vehicule

Mr Kakou

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removing headliner


James, Check the attached links,instruction and guides on head liner removal. You can also google search your vehicle.Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Automotive Headliner Removal
Replacing your car headliner in 5 easy steps
How to Install Headliner
Installation Bow type Headliner Part 1 Removal and Preparation

Jul 03, 2016 | Cars & Trucks

1 Answer

Low oil press AFTER oil/filter change


sounds like your pump is failing, or it could be the sending unit giving a bad reading. Has nothing to do with having changed the oil .

May 05, 2014 | 1958 Chevrolet Bel

1 Answer

Had headliner recovered in my 2004 Chevy Tahoe, now rear vents won't blow air through. What happened?


When the headliner was recoverd they probobly had to remove the whole headliner and when it was installed its a possibility that the ducts are not aligned properly for the a/c vents.

Sep 12, 2013 | 2004 Chevrolet Tahoe

1 Answer

Need instructions and diagrams on how to install a factory a/c unit on a1960 chevy bel-air


You may want to look into joining a forum. With that kind of community there is usally somebody always there that can help, and continue to help, with these types of things.
One forum I know of is Classiccar.com.

Sep 05, 2011 | Chevrolet Impala Cars & Trucks

1 Answer

The engine will not start when the motor is hot it's it's like there is no power to start it, but when the engine cools down the motor starts and runs fine


selonoid problems most likely on chev.hot start problems since 1955.you can install external starter seloind to correct problem or try and insulate seloind

Aug 24, 2011 | 1995 Chevrolet Astro

1 Answer

Humming sound coming from the small speaker over my head ?


That "speaker looking thing" above the drivers head on the headliner is a part of the climate control system.

Here is the GM bulletin regarding it if you are running in to these issue:

Document ID# 1639237

Subject: Buzz Noise From Headliner Above Driver - keywords ac air aspirator cover fan grille HVAC interior microphone sensor speaker temperature vent vibration #PIT3511 - (03/29/2005)



Models: 2000-05 Cadillac Escalade

2002-05 Chevrolet Avalanche

2000-05 Chevrolet Silverado, Suburban, Tahoe

2000-05 GMC Sierra, Yukon, Yukon XL, Yukon Denali

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in the PI.

Condition/Concern:
Dealer or customer may comment that they have a buzz or vibration noise emanating from the headliner in an area that looks like microphone or a speaker.

Recommendation/Instructions:
The plastic escutcheon grill, which is round and about the size of a half dollar and located just above the driver to the left, is the interior ambient temperature sensor. The sensor is used in conjunction with the automatic HVAC (C68). On occasions, this sensor has been known to make a buzz or rattle sound. The sensor uses a small fan to pull air over the sensor. This buzz noise may be intermittent.

Although it may not be possible to alleviate all of the buzz or noise from this sensor, Engineering has found that if the sensor is installed incorrectly that it may bind and cause the fan to make a buzz noise. Remove the sensor and while doing so check for any binding. Reinstall the sensor and re-test. If the noise is still present, the sensor itself may be noisy and require replacement.

Mar 31, 2010 | 2004 Chevrolet Silverado 2500HD

1 Answer

Headliner removal


this is not an easy repair w/o damaging the headliner. There is nothing up there except maybe a roof brace. Check the luggae rack again by trying to move all the peices. One must be loose.
there are 27 steps!
If equipped, remove the overhead console.
  1. Remove the screw and disconnect the electrical connectors
  2. If equipped, remove the electronic compass sensor.
  3. If equipped, disconnect the auto dimming interior mirror connector.
  4. Remove the interior/map reading lamp. For additional information, refer to Section 417-02 .
    • Upon installation, make sure the notch in the headliner aligns with the tab on the interior/map reading lamp bracket.
  5. Disconnect the roof opening panel electrical connector and the wire connector pin-type retainer.
  6. Remove the gimp around the roof opening panel.
    1. Remove the sun visors. For additional information, refer to Sun Visor in this section.
    1. Position aside the door opening weatherstrips
  7. NOTE: Installing the LH side sun visor clip will support front of headliner while working on headliner.
    Install the LH side sun visor retainer clip.
    • Loosely install the screw.
  • Disconnect the electrical connector and the wiring pin-type retainers on the A-pillar.
    1. Release the upper B-pillar trim panel clips and position aside the upper B-pillar trim panel.
    Release the C-pillar trim panel clips and position aside the C-pillar trim panel
    1. Remove the rear upper headliner trim panel.
    2. Remove the D-pillar trim panel.
    Vehicles with rear climate control
    1. Remove the rear auxiliary A/C controls.
      • Disconnect the electrical connectors
    2. Position aside the LH rear quarter trim panel.
    3. Disconnect the electrical connectors.
    4. Remove the pin-type retainers and the upper air duct.
      • Push down on the air duct, tilt the top outward and pull upward to remove the air duct
    5. Remove the lower air duct.
    6. Disconnect the electrical connector located at the C-pillar.
      • Release the wiring harness pin-type retainers.
    7. : To prevent damage to the coat hanger retainer, use a 3/16-inch flat-blade screwdriver for this step. Remove the third row coat hooks.
      • Open the access cover.
      • Insert a screwdriver into the coat hook slot and turn the screwdriver 90 degrees so that it engages in the plastic component slot. This will spread the steal attachment clip wings to allow the plastic component to disengage. The steal clip will stay engaged in the sheet metal.
    8. Remove the rear headliner pin-type retainer.
    9. NOTE: An assistance is required to help support the center of the headliner for the remaining steps.
      1. s2n~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: To prevent damage to the coat hanger retainer, use a 3/16-inch flat-blade screwdriver for this step.
        Remove the second row coat hooks.
        • Open the access cover.
        • Insert a screwdriver into the coat hook slot and turn the screwdriver 90 degrees so that it engages in the plastic component slot. This will spread the steal attachment clip wings to allow the plastic component to disengage. The steal clip will stay engaged in the sheet metal.
      2. Remove the LH side sun visor retainer clip.
        • Open the access cover and remove the screw.
      3. NOTE: Rear seats must be folded down and front seats reclined back for this step.
        Tilt the RH side of the headliner upward and remove the headliner from the rear of the vehicle.
    good luck

    Dec 14, 2008 | 2002 Ford Explorer

    1 Answer

    Firing order 1955 gmc 100


    I have a 54 bel air customer brought in for me to install engine, but I do not know the firing order or the mark on distributor cap, could you please let me know what they are please, thank you very much. It is a straight 6.

    Jul 18, 2008 | 1983 GMC C1500

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    273 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    60792 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6811 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...