Question about Isuzu Amigo

1 Answer

Sticking intake valve - Amigo Isuzu Cars & Trucks

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 475 Answers

Is it a sticky valve or is it a broken vavle spring?

Posted on Nov 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where is the EGR valve located on a 1997 Geo Metro 1.3 automatic? Where it has been mentioned is not where mine is, tho, theirs was a stick

I will post a picture so you can ID the valve. It is on the top of the engine bolted to the intake.

Dec 23, 2016 | Geo Cars & Trucks

2 Answers

2008 dodge avenger code p2004

Intake Manifold runner control stuck open - bank one:
- Intake Manifold Runner Binding Or Sticking
- Faulty Manifold flow valve
- Manifold flow valve harness is open or shorted
- Manifold flow valve circuit poor electrical connection

There is a factory service bulletin for this problem for 2007-2008 Dodge Avengers. (JS)

If you need further help, reach me via phone at

Sep 22, 2015 | Dodge Cars & Trucks

1 Answer

2009 chevyaveo stalls when startingup after fueling up

The evos sytem on chevys is the problem,,,evap operating system,,,evos,,, the vent valve soliniod, or vent valve purge,,on the intake of the engine is sticking in the open position,, i cant remember which its called but its the one on the intake,,, what happens is it sticks open position and when you fill your car with gas it pushes all the gas fumes into the intake,,, causeing a flooding ,no start , or hard start situation,,,if you cant or dont want to fix,it, you can leave your car running when getting gas it will be fine ,,which is the cheap fix,,,, the evos system has 4 componets,,, vent valve solinoid, vent valve purge, charcole canister, fuel presure sensor(top of fuel tank) all can be replaced for around 125 bucks if you do some seaching around and doing the labor yourself,,check out you tube,,,

Feb 20, 2015 | 2009 Chevrolet Aveo

1 Answer

What is egr valve

Exhaust Gas Recirculation Valve, Controls flow of exhaust gases into the intake manifold. Used for meeting emissions standards. usually sticks open or shut resulting in too much or too little exhaust being used in intake air. Makes car run crappy.

Oct 10, 2012 | Honda Ridgeline Cars & Trucks

1 Answer

1984 ford bronco II backfires through intake and dies changed plugs and wires distributor, cap & rotar, coils, and checked timing still didnt fix problem what could be causing problem?


May 12, 2011 | Ford Bronco II Cars & Trucks

1 Answer


.P1031 Intake manifold air control valve position sensor
Possible Causes - Intake manifold air control valve position sensor circuit open circuit
- Intake manifold air control valve position sensor circuit poor electrical connection
- Faulty intake manifold air control valve position sensor
- Intake manifold air control flap too tight or sticking a four thumbs up rateing will be appreciated thank you have a nice day

Dec 28, 2010 | 2005 Volkswagen Golf

1 Answer

1999 chevy cav 2.2 backfiring thur intake

here are a few things to check, egr system not working properly, vacuum leak at intake or manifold, damaged valve springs or sticking valves. all of the above will cause a backfire in intake.

Jan 12, 2010 | 1999 Chevrolet Cavalier

1 Answer

Stuck valves

stuck intake and exhaust vlaves???sometimes they stick and sometimes they are burnt,,,,either way you are gonna need a valve job but there could be more causing the valves to stick due to burning oil,,may need a new enigne or car,depending on what u want to do

Oct 01, 2009 | 1998 Saturn SL

1 Answer

1993 jeep grand cherokee, choking, pulling then stalled,

- Fresh Air Intake Hose: Clogged or Damaged FreshAir Intake Hose.
- Carburetor: Worn, Faulty or Damaged Carburetor.
- Mass Air Flow Sensor: Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit.
- EGR Valve: EGR Valve Sticking Open/Leaking.
- Idle Air Control Valve: IAC Valve Sticking or Faulty.

Good luck.

Aug 02, 2009 | 1993 Jeep Grand Cherokee

1 Answer

Missfire #1

Might be a sticking valve. If they stick, then they usually do it when the engine is cold. Hook up a vacuum gauge, then start the engine cold: if the needle bounces during the misfire, then suspect an intake valve is sticking.

May 05, 2009 | 2003 Ford F150 Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

260 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14423 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides