Question about 2006 Nissan Murano

1 Answer

2006 nissan murano headlight out

Can the bulb be replaced or does the entire assemble need to be changed?

Posted by on

  • 1 more comment 
  • Anonymous Mar 17, 2014

    Adjust the front headlights on Nissan Murano

  • Anonymous Mar 17, 2014

    Adjust the front headlights on Nissan Murano

  • Anonymous Mar 17, 2014

    i have a headlight for my 2007 nissan murano can i use it for my 2001 volkswagen passat

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 73 Answers

Bulb can be replaced. You can buy at Walmart or your local parts store. I recommend replacing both. They are rated for the same amount of run hours and will usually fail within the same month.

You can also buy from this link.
http://www.partsgeek.com/gbproducts/YN/B18919-HEL-P8040.html?utm_source=google&utm_medium=ff&utm_term=06+2006+Nissan+Murano+Headlight+Bulb+Hella+Nissan+Headlight+Bulb&utm_content=YN&utm_campaign=PartsGeek+Google+Base

Posted on Jan 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

07 Murano headlight went out, replaced bulb, still doesn't work, now what?


If fuses are good, most likely the 'ballast' is at fault.

Dec 24, 2013 | 2007 Nissan Murano SE

2 Answers

I have a 2006 nissan murano, it has high intensity lights. during inspection they replaced the left bulb, the part cost $180. The light still didn't work, now their telling me the ballast is bad and I need...


Since you can buy that headlight bulb for $70-80 with a lifetime warranty I think I would give the bulb back, get a refund and go elsewhere. I may be wrong and don't mean to accuse wrong doing but something doesn't seem to be on the up & up.

Nov 17, 2010 | 2006 Nissan Murano

2 Answers

How do i change headlight on a 2003 Murano


To change the headlight bulbs, you will need to remove the wheel liner cover to gain access to the back of the headlamp assemblies. Then you can pull off the screw cap / cover that seals the bulb into the headlamp assembly for the bulb you want to change. Once the cap is off, you will need to disconnect the harness from the back of the bulb. With the harness off, you will then need to either twist a black lock ring to release the bulb, or you will need to push on a metal lever to release the bulb (this varies on models and high and low beams).
Install in the reverse order....

Nov 16, 2009 | 2003 Nissan Murano

2 Answers

I don't know how to take off the head light lens cover on my nissan maxiuma


Probably not a lens cover at all. It's just a 1 piece plastic headlight. It you are wanting to replace a bulb , they go in from the back . Open the hood and you should be able to see where the wires to the bulb go in the back of the headlight.

Nov 06, 2009 | 1997 Nissan Maxima

2 Answers

How do you replace a burned out bulb (not an entire headlight) on the passenger side of a 2006 Suzuki Forenza


open the hood and look for the rear side it will be a coupler turn type deal ..twist it out and remove old bulb and re-installation is reverse procedure

Sep 22, 2009 | 2006 Suzuki Forenza

1 Answer

2006 Elantra; Does the entire headlight assembly


On these the bulb unscrews from the back

Jul 14, 2009 | 2006 Hyundai Elantra

1 Answer

How do you replace (get at) the Fog Lamp Assembly (Driver Side)?


you have to remove the splash shield under the bumper and the entire light comes out from behind the bumper.

May 12, 2009 | 2005 Nissan Murano

3 Answers

2006 beetle headlight will not stay lit


I have this same issue. I don't have a solution, however, I will say this. In the headlight assembly, there are two things that you must do to release the entire assembly for it to slide out. First is a little hex stud that is just inside the hood. You turn it one way to unlock it, and the assembly slides out a bit. Then you have to press on a lever, and pull out the entire assembly. When the whole thing goes back in (after replacing the bulb) the assembly is pushed into the wiring harness. In order to keep the assembly in good contact with the wiring harness, you have to lock the hex stud. However, it is VERY tricky to get the hex stud re-locked. If you turn the opposite way, you can go too far and it will unlock again. If you shine a light into that area, you will see below the assembly there is a little metal piece that gets pushed out when you turn the hex stud. Keep playing with the hex stud until it's in the correct position, and that should keep the assembly from sliding forward. If it doesn't stay (ie you get it to lock but it giggles free), you might have to have the assembly replaced (~$300). One of my headlights is really temperamental, the other is better behaved. Unfortunately, I'm probably looking at replacing the headlight assembly. After a year of battling it!!! :(

Feb 08, 2009 | 2006 Volkswagen New Beetle

1 Answer

Head light 2005 altima


you have to remove the bulbs from inside of the hood in the engine compartment. in some cars you have to remove some "pins' and remove the entire headlight assembly.. You then remove the holder where the lightbulb is located and replace the bulb.

Nov 13, 2008 | 2005 Nissan Altima

Not finding what you are looking for?
2006 Nissan Murano Logo

972 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...