Question about 2006 Nissan Quest

1 Answer

Passenger side window goes down on it's own.

Unless the window is locked the passenger side window will not stay up.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,042 Answers

You need to replace the window winder unit. not the electronic switch but the motor/pully system which rolls the window up and down. if u can get the door panel off, you can replace it yourself for around $120, or you can macgyver a fix, without bying new parts. look for a loose cable on the winder unit, thats what will tell u that the winder unit is bad.

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 mazda 6 automatic 6 speed. The passenger window continues to roll down by itself while the car is in transit as well as shut down. I travel a lot. Here it goes again


You could try disconnecting the switch wires for the passenger side when the window is up. If the window stays put then simply buy a new switch or live without an opening passenger window.

Aug 21, 2014 | Cars & Trucks

1 Answer

Passenger windown wont roll up or down, motor good


If the passenger side switch is bad it wont complete the circuit to operate the window. Recommend trying a known good passenger switch.

Nov 10, 2013 | 2007 Chevrolet TrailBlazer SS

1 Answer

Electrical problems?


Reads like it is a problem for an auto electrician or someone with access to the vehicles wiring diagram - presumably at some point two circuits are crossing. More likely if it is a modern car, it maybe a bit of computerised hardware that needs a fix or replacement.

Aug 28, 2012 | 1997 Honda Civic

1 Answer

1993 Bighorn Passenger window not working


There could be a lock controller somewhere that is not working.
I don't have a wiring diagram for your truck.

Generally, the power window motors are grounded thru the doors, or the switches provide ground. In your case the motors are probably grounded thru the doors.
The master switch "overrides" the door switch so you have extra wires that do the same thing. The E wire probably gives the door switch power and the A and C are up and down. The B and D are override circuits from the master that bypass the door switch.
Sometimes the motor is grounded thru the switch then thru the door.

Jun 28, 2012 | Isuzu Trooper Cars & Trucks

2 Answers

Just installed a new power window switch on the passenger side it goes down but wont go up, but if you use the master on driver side it goes up and down confused. got a 2nd new switch and it did the same...


Is it TRYING to go up but can't? You could have high resistance in the ground circuit to the passenger switch. It takes a LOT less power to move the window down than it does to make it go up. There mak be good enough ground to the switch to make it go down, bt not up.

Since it works from the driver's door, this pretty much eliminates the B+ circits and the grounds for the driver's switch. Since the passenger switch itself has been replaced twice, I would think that eliminates the switch itself as the cause. The ground circuit to the passenger switch is the only thing left.

This theory can be easilly verified by running a jumper from Pin "J" BLACK wire at the passenger switch t the battery negative post. If the window now goes up and down from the passenger switch, the ground circuit needs to be repaired.

Aug 23, 2011 | 1991 Chevrolet C1500

3 Answers

My passenger side front door lock won't work and my passenger side remote mirror.


Both of those are controlled by the Passenger Side Door Module inside the door itself. It is necessary to read the data from your Body Control Module (BCM) to properly diagnose the cause of the failure.

Jan 29, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

1997 Jeep Grand Cherokee Laredo 4 x 2, windows and door locks work on driver side, but not passenger side.


sounds like an open power or ground circuit on passenger side,since the door lock and the window,lost its functioning.Both switches would have to be bad at the same time,which is not probable, to be the fault. Unless there is a saftey lock out switch on the drivers panel,controling the passenger side door lock and window.

Sep 02, 2010 | 1997 Jeep Grand Cherokee

2 Answers

07 scion tc passenger window wont roll down when lock by driver..


thats cause that what the lock is for so it wont go down

Jun 06, 2009 | 2007 Scion tC Coupe

1 Answer

2003 toyota camry se


You may have inadvertantly locked the passenger windows by pressing the little button to the right of the door locks (on the driver side). It's a push to lock/push again to unlock type button, so try pushing it--if it stays down, then that wasn't the problem. If it comes up, then try the window. I hope that helps

Jul 03, 2008 | 2003 Toyota Camry

Not finding what you are looking for?
2006 Nissan Quest Logo

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...