Question about Hyundai Elantra

1 Answer

I have a 99 elantra wagon changed front wheel bearings 3 times in 5 years

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 110 Answers

Maybe overtightning them put plenty of grease in

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change wheel bearings on 2001 xr 6 wagon front &rear please.


Not sure about your wagon, but many modern models do not have replaceable wheel bearings without changing entire hub assembly/

Feb 22, 2015 | Cars & Trucks

1 Answer

Not sure whats loose-solution to tighten everything ok or not ok


well if he tighten the wheel hub bearing nutt to tight it will cause the hub bearings to burn out.....But he is a tec write, So im sure he did it right. Also the noise from the rear mabe something you are heareing now because no noise in the front is gone and the back noise is heard at this point......
good luck to ya.

Aug 01, 2010 | 2009 Hyundai Elantra

1 Answer

I own a 99 hyundai elantra the car has a very bad grinding/vibration in the frontend the drive axeles were already replaced when i bought the car i checked the wheel bearings they seem to be fine so i...


You should check your wheel bearings again and check the front brakes and rotors. Pay close attention to the inner pads and the rotors. You can get a grinding vibration from hard spots in the rotors or the pads and these are often overlooked as a cause. Everyone goes to bearings or trans first, so it is not you everyone does it I've seen it happen for years. But pay close attention to the brakes, worn, hard spots or heat/burn marks all can cause this to happen.

Nov 15, 2009 | Hyundai Elantra Cars & Trucks

2 Answers

Wheels making binding noises when turning


I have this same problem with my 1996 Subaru Legacy 2.2 Wagon. There is a Subaru Service Bulletin #16-62-97 dated 5/16/97 with a Subject entitled "Transfer Clutch Binding And/Or Bucking On Turns". There is also an important follow-up to it numbered 16-64-99 dated 09/15/99 entitled "Revised Transfer Clutch Assembly Replacement Procedures" that should also be used should you decide to go ahead with the transfer clutch replacement.

I just got these Service Bulletins from my mechanic who got them from a Subaru dealer.
The estimate was about $700-$1000 to fix. This is more than likely the cause of the binding problem on slow, sharp turns.

Dan Hunt
Danbury, CT

Aug 04, 2009 | 1996 Subaru Legacy

1 Answer

"Humming" or "bearing" type noise in left front at highway speeds


That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.

Jun 10, 2009 | 2001 Hyundai Elantra

1 Answer

Front wheel bearing


This job is more than a none mechanic is able to do easily.

May 09, 2009 | 1998 Hyundai Tiburon

3 Answers

How to change front wheel bearing ford focus


You can do it yourself just take your time:
To change front wheel bearing.
1. Jack car up support with jack stands
2. take tire off
3. take caliper and brakes off
4. take rotor off
5. unbolt axle shaft nut at bearing hub
6. use a 3 lb slug with a block of wood
7. place wood on axle shaft and knock it in
8. back side 3 10mm bolts unbolt
9. front side have to pry off bearing hub Assembly only beacuse has dirt in knuckle hole.
10. clean hub knuckle and reinstall.
Its really not that hard or you could have them done for $900 and up. (I have changed alot of wheel bearing assemblies )Whats your e-mail I can send you a diagram if you want.

May 01, 2009 | 2004 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...