What part is on top of power steering pump and below air conditioner on a 1995 Ford f350 7.3 4x4 diesel

francisco navarro

• 241 Answers
• Posted on May 16, 2008

SOURCE: Replacing power steering pump 1992 ford tempo

take the belt off.
disconnect the hoses connected to it.
remove the bolts holding the pump.
remove and replace the pump
be sure that you tighten up well the bolts holding the new pump
connect the hoses
put the belt on
refill the pump
turn vehicle on " keep the pump's cap off
refill as needed while turning the wheel from one side to another
" do not overfill, watch out the level marks"
tighten the pump's cap on
ready to roll

SOURCE: can a 96 Ford Windstar Air Conditioner Compressor Pump Fit in a 98 Windstar?

The compressor is the same but it may have a different pulley and the plug may be indexed on the wrong side. If you have a set of snap ring pliers you can put your coil and pulley on that compressor or it may already be the same ones just make sure you put the plug where it is on your original compressor.

SOURCE: 1995 Ford Escort

might need to replace new drier or check if it is fully charged.
other wise need to evacuate all the old fluid and vacum system to makeit work beter.

SOURCE: How do I change a fuel pump on my 1995 Ford F350

Hi, I hope this helps...

1994-96 Engines
See Figures 3 and 4



Fig. Fig. 3: Details of the fuel pump assembly-1994-96 diesel engine



Fig. Fig. 4: View of the fuel pump-1994-96 diesel engine

1. Remove the turbocharger assembly.
2. Remove the fuel line banjo bolt at the pump.
3. Remove the fuel line fittings at the rear of the cylinder heads.
4. Remove the fuel lines assembly.
5. Loosen the two hose clamps at the fuel pump fittings.
6. Disconnect the water drain hose at the fuel filter.
7. Disconnect the filter and position it forward.
8. Remove the fuel pump retaining bolts, then lift the pump out of the crankcase bore.
9. Remove the fuel pump tappet from the crankcase bore.

1. Rotate the engine so the fuel pump eccentric is on the base circle.
2. Install the fuel pump tappet in the base of the fuel pump.
3. Replace the O-ring on the fuel pump base.
4. Install the fuel pump and bolt it in place.
5. Install the fuel filter and connect the water drain hose.
6. Connect the two fuel hoses at the front of the fuel pump.
7. Tighten the fuel line clamps and install the fuel filter retaining bolts.
8. Install the fuel line assembly and new seal rings at the rear of the pump.
9. Loosely install the fuel line fittings at the rear of the cylinder heads.
10. Install the fuel line banjo fitting at the pump. Tighten the fitting to 40 ft. lbs. (54 Nm).
11. Tighten the fuel line fittings.
12. Install the turbocharger assembly.

SOURCE: power steering pump on a 2001 ford windstar

There is a special tool for that. It should be available at most auto parts stores.