Question about Mazda 323

1 Answer

The car dies under load, what causes this problem?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Mazda Master
  • 22,306 Answers

Could be number of things,some you could do yourself but expensive mistake if you get it wrong ---be prepared to lay the golden egg and take car to main agent.europeon model of later age most likely has encrypted software so no chance with boy racer sunday mechanic code reader .

Posted on Nov 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1986 Pontiac 6000 starts and idles great but soon as u put it in gear it dies,already replaced fuel filter any other ideas??

one cause that is unusual but will cause this complaint is the torque converter not releasing. the fuel pressure must be high enough to run the car under load(putting in gear). pressure must be 50lbs

Jun 03, 2015 | Pontiac Cars & Trucks

1 Answer

2001 chevy tracker serpetine belt slows down when under load, driving. what could cause that? ive replaced water pump, altenator, and tensioner but it still dies when driving. idling its fine. and when you...

This is caused by one of the things you already replaced , including the A/C compressor and power steering pump. Or it could be from a wrong size or over stretched belt.

Sep 21, 2011 | 2001 Chevrolet Tracker

1 Answer

While driving the car it will die. If you put the car in neutral, turn the key off, then restart the car. It fires right up. What would cause this?

tune up - cap,rotor,plug wires.plugs fuel and air filter- you are either losing spark or fuel under load

Apr 12, 2011 | 1991 Dodge Dynasty

1 Answer

Dies when under load or on long trips

fuel pump?? try unplugging the mas air flow sensor. its a 3 wire sensor in the air snorkle to the engine. They get dirty and cause it to run rough. Its very common

Jul 28, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

RX7 with 13b engine is hard to start, idles fine, dies on accel.

problem like this on garden tractor ,was weak coil ,-when engine at low manifold pressure[idle] spark could jump gap and fire cylinder ,higher pressure /under load-wouldn't fire...check color of spark -orange,yellow ,white spark=weak, blue spark is stronge,

Mar 22, 2009 | 1984 Mazda RX-7

2 Answers

2000 Safari, engine/trans stumbles under load. Already replcd...

Other problem areas to check are a clogged catalytic converter and rear axle gear oil level (Astro/Safari axle seals leak causing shuddering under load and eventually seizing).Also GM's have had strange intermitent engine and trans problems that dissapear after replacing the main fuses. Check with a GM dealer for TSB's for your truck.

Feb 05, 2009 | 2000 GMC Safari

2 Answers

Car engine dying 98 Honda

Check the main relay. They have been know to cause this problem when they get hot. Also check the Top Dead Center sensor.

Jun 26, 2008 | 1998 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides