Question about 1991 Toyota Camry

1 Answer

Locating and replacing a thermostat on a 1991 camry

I need help on locating and replacing a thermostat on a 1991 camry

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 89 Answers

You upper radiator hose connects to a flange w/ 2 screws on the engine. Unscrew the two bolts, i believe it's a 10mm, or a 12mm. Once opened, the thermostat should be there. Keep note of the orientation so you have no problems when putting a new one in.

Posted on Nov 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the thermostat located on a 1991 toyota camry


Follow top rad hose to thermostat housing. Thermostat inside.

Nov 26, 2010 | 1991 Toyota Camry

1 Answer

1991 toyota camry, where is the thermostat


most cases it is in the upper hose, follow it to the block the housing the hose goes into holds the t-stat. remove bolts, pull stat replace it and put bolts back in,

Oct 22, 2010 | 1991 Toyota Camry

2 Answers

With limited tools how difficult is it to change the thermostat in 91 camry.


all you should need is a screw driver, a pair of plyers, a ratchet, and some sockets

Nov 14, 2009 | 1991 Toyota Camry

3 Answers

Need to find location od thermostat on 93 camry


try these websites www.autozone.com and www.alldatadiy.com and you should be able to get the information you need.

Jun 30, 2009 | 1993 Toyota Camry V6

1 Answer

Need to change the thermostat on my camry


follow the lower radiator hose to the housing ...do not over tighten the bolts they are on an aluminum housing and the bolts will strip..dont put it in the wrong way ...the little pin that is on the valve should be up

May 07, 2009 | 1991 Toyota Camry

1 Answer

My auto transmission is slipping on my 1991 Camry Station Wagon


If it is slipping the forward clutch pack in the trans is worn out and u will need the transmission overhauled.

Apr 30, 2009 | 1991 Toyota Camry

1 Answer

02 camry 4cyl theromostat replacement instructions


DRAIN COOLANT
  1. REMOVE WATER INLET
    1. Remove 2 nuts, and disconnect the water inlet from the cylinder block.
  1. REMOVE THERMOSTAT
    1. INSTALL THERMOSTAT
      1. Install a new gasket to the thermostat.
      2. Install the thermostat with the jiggle valve upward. HINT: The jiggle valve may be set within 10° on either side of the prescribed position.
    1. INSTALL WATER INLET
      1. Install the water inlet with 2 nuts. Torque: 9 Nm (92 kgf-cm, 80 inch lbs.)
    1. ADD COOLANT
    2. INSPECT CHECK ENGINE COOLANT LEAK Follow your rad hose and you will see the thermo housing the thermostat is under that should be upper hose

Mar 27, 2009 | 1991 Toyota Camry

1 Answer

Over Heat


either an air pocket in your cooling system or waterpump is bad. for air pocket, jack up the front end of the car where the radiator cap is, start car, and keep adding fluid till full and blowing warm heat. note, might have to squeeze upper radiator hose to help get the air out. if doing that dosn't help any, odds are you need a new water pump.

Mar 09, 2009 | 1991 Toyota Camry

1 Answer

Changing a thermostat


Follow the big water hose on top of the radiator to the engine blogk. Where it goes into the block there should be 2 or 3 bolts to remove the housing. When you change the thermostat you should also change the gasket. I hope this helps.you.

Dec 07, 2008 | 1991 Toyota Camry

Not finding what you are looking for?
1991 Toyota Camry Logo

Related Topics:

436 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...