Question about 2005 Toyota Corolla

1 Answer

Daytime running lights do not work

Low & High head lights work when turned on. Where is the relay located?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

Fusible links and relays are located in the engine compartment next to the battery..

Good luck....

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

All of my running lights and blinkers work and high beams but no low beams on my 1997 Chevrolet TahoeA


Headlamps Inoperative - Low Beams

Step

Action

Value(s)

Yes

No

DEFINITION: This diagnostic procedure should only be used if the high beam headlamps are operating properly and the low beams are inoperative.

1

Did you perform the Headlights System Check?
--
Go to Step 2
Go to Headlight System Check

2

  1. Turn the headlamp and panel dimmer switch to the ON position.
  2. Move the headlamp dimmer switch to the LOW position.
  3. Backprobe the headlamp dimmer switch connector with a J 35616-200 from cavity A to ground.

Does the test lamp light?
--
Go to Step 3
Go to Step 5

3

  1. Remove the daytime running lamp relay.
  2. Connect a J 35616-200 at cavity G5 to ground.

Does the test lamp light?
--
Go to Step 4
Go to Step 6

4

  1. Re-install the daytime running lamp relay.
  2. Backprobe cavity B at the high/low beam headlamp with the headlamp dimmer switch in the LOW position.

Does the test lamp light?
--
Go to Step 7
Go to Step 8

5

Replace the headlamp dimmer switch.

Is the repair complete?
--
Go to Headlight System Check
--

6

Repair the open in CKT 359 (PPL) between the headlamp dimmer switch and the daytime running lamp relay.

Is the repair complete?
--
Go to Headlight System Check
--

7

Replace the high/low beam headlamps.

Is the repair complete?
--
Go to Headlight System Check
--

8

  1. Inspect for an open in CKT 12 (TAN) between the daytime running lamp relay and S120, repair as necessary.
  2. Replace the daytime running lamp relay if no open was found in CKT 12 (TAN) between the daytime running lamp relay and S120.

Is the repair complete?
--
Go to Headlight System Check
--

Jul 24, 2015 | Chevrolet Cars & Trucks

1 Answer

Running headlights not working need solution or is there a switch for lights


Head light have two relays.one for daytime and one for normal night. the daytime switching the light to serial circuit and if one bulb is out down both Leigh quit working. Inspect your light high and low beam for normal operation . Inspect your fuses . Swap the daytime relay with identical one.and under the dash is module for daytime running light. inspect the red/black wire for ground from light switch and light blue/ yellow for power from 15A ECU-B fuse
good luck

Jun 05, 2014 | 1994 Toyota Camry

2 Answers

Daytime running lights not working


Assuming this is an LX, check 7.5A fuses 9 and 5 in the driver's underdash fuse/relay box. Fuse 9 applies power to the DRL indicator light in the gauge assembly which connects to the DRL control unit. Fuse 5 supplies power to the DRL control unit when the ignition is on. Also check 100A fuse 41 in the underhood fuse/relay box which supplies power to the headlight relays. Setting the headlight switch to HEAD causes the headlight relays to close and apply power through 20A fuses 45 and 43 in the underhood fuse/relay box to the low beams. Low beam power also passes through the DRL diode to close the high beam cut relay and prevent high beam use during DRL operation.

Sep 23, 2012 | 2002 Honda Accord

1 Answer

Alero: low beams as bright as Daytime runners while brights work?


Look for the relay for the head lights,it may be bad.Also look for a bad ground.And check the bulbs too.

Nov 04, 2009 | 2003 Oldsmobile Alero

1 Answer

Relay box location. there is a problem with the drivers and pasangers window wont go up or down and the head lights dont work but the side lights will. therefore i think its the hrad lights


Fuse for window regulator (circuit breaker) on 13 position auxiliary relay panel. The wiring connectors are located at the lower left and right side kick panels. The auxiliary relay panel is located above the lower kick panel above the pedals.

Headlight fuse location:
#18 High beam right 10A
#19 High beam left 10A
#20 Low beam right 15A
#21 Low beam left 15A

Daytime running light relay location on upper (auxiliary) relay panel. This are the only ones using relays regarding your question.

From April 1999
Position 7, Relay #173

Through March 1999
Position 8, Relay #173

Oct 17, 2009 | 2000 Volkswagen Beetle

2 Answers

2007 pontiac grandprix low beam and daytime running lights wont work


If they work at night leave it alone
(Those ******* "Driving Lights" cost you gasoline to run.)

Sep 13, 2009 | 2007 Pontiac Grand Prix GXP Sedan

2 Answers

My 1991 Caravan headlights won't turn off and the highbeam indicator light stays on. I've been told that the problem is likely the daytime running lights module. Where is this module located in the vehicle...


Sounds more like a stuck high beam relay. Daytime running lights module appeared sometime after '99 year. The relay should be in the fuse compartment. Pull it out to check that it is only the high beam that is on. Pull the low beam relay and place in the high beam location. If it turns on the high beams again, then try the dimmer switch to see if they go out. If that has no effect, then there is a sneak path somewhere that is turning the relay on.

Sep 06, 2009 | 1991 Dodge Caravan

1 Answer

Low beam headlight /daytime light are not working


It's on the driver's side. Remove all the plastic & it's in there.Big rectangle, black box,about 1.5" thick,lotta wires.

Jun 22, 2009 | 1996 Chevrolet Tahoe

2 Answers

Low beam headlights don't work


I have e-mailed you 2 .pdf files, one is the complete headlamp diagram, and the other is the relay locations. Please advise if you need further assistance.

Toyota Ed

Dec 31, 2008 | 2005 Toyota Corolla

1 Answer

93 chev Blazer


perhaps i missed something here... lowbeams and daytime lights are about the same.... be that as it may... the merely obvious thing is that the low beams are burnt out.... next thing would be that the relay for the day time lights could be defective... it's often mounted on the firewall.

Robert

Nov 12, 2008 | 2001 Chevrolet Blazer

Not finding what you are looking for?
2005 Toyota Corolla Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...