Question about 2001 Hyundai Santa Fe

1 Answer

Speedometer not working

The speedometer isn't working and it's started buckin when it trying to go in gear...it's a auto.v-6 4-wheel drive

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check spd cable where it enter trans maybe striped

Posted on Nov 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does speedometer read 65, when I'm only doing about 35?


Circuit/System Verification
Important: If the suspect gage is the speedometer, the drive wheels of the vehicle must be raised and the transmission must be placed in drive or first gear.
  1. Ignition ON, with the scan tool, perform the IPC Gage Sweep Test in the IPC Output Controls. Verify that all gage dials move from minimum to the maximum value and back to the gage minimum value.
  2. ?‡'
    If the gage does not perform the IPC Gage Sweep Test, replace the IPC.

  3. Start the engine, with the vehicle drive wheels raised and place the transmission in drive or first gear. Verify that the speedometer value matches the scan tool Vehicle Speed parameter in the ECM/PCM Engine Data List.
?‡'
If the speedometer is incorrect, test or replace the IPC.

Sep 08, 2015 | 2008 Pontiac Grand Prix

1 Answer

TRANSMISSION


Fuse # 20 or 21 gets power through ignition. This fuse controls PRNDL indicator, speedometer, tach, & will cause transmission to not shift gears correctly. Ours took off in 3rd gear when put in Overdrive & only ran in 3rd gear. If we tried to manually shift thru gears (auto trans), it had 1st, 3rd, reverse. No 2nd or over drive. Replaced ignition. Fixed problem. Root problem was Electric motor that engaged 4 wheel low side was bad. Every time we used 4 Low side it threw power surge through ignition & blew ignition out. Good Luck.

Feb 06, 2014 | 1997 Chevrolet K1500

1 Answer

Hello, I have a 2002 dodge caravan sport. It was running fine,(it does need new exhaust and sway bar links) turned it back on, put in reverse and wheels wouldn't turn, lights on radio went off then on, all...


You appear to have seized something, this is not something that can be advised on line, you have to have your engine cover off before you try restarting, have someone looking for the problem, as I am following this, by using the comment bar will send me a message and we can go through this in more detail and find the problem

Dec 04, 2013 | 2002 Dodge Caravan

1 Answer

Speedometer not working 2001 hyundai santa fe 2.7 auto.all wheel drive


Did you change the plastic gear that goes on the vehicle speed sensor when you changed the sensor? Those wear out as well.

Aug 02, 2012 | 2001 Hyundai Santa Fe

1 Answer

2000 volvo S40 speedometer won't work, ABS light on, Starts out in 4th gear


I had same issues on my 99 S80, turned out to be the spline gears on the end of the CV Axles that send signal to Wheel Speed Sensors. Their is one on each wheel, but the ones that gave me all the issues where only the front two. Problem was had to replace the entire CV Axle to be able to get new spline gear, but was only about $60, so was worth it.

May 11, 2012 | 2000 Volvo S40

1 Answer

Odometer and Spedometer not working on 2003 Kia Sedona. Also a loud bumping noise when wheels are turned to the right. Are they releated? I just had they tie-rods replaced also.


If the bumping noise started around the same time that the Speedometer started acting up, then I'd say they are related. I'm not sure about the Kia setup, but if the speed sensor is telling the on board computer (ECM) one thing, but the wheels are doing something else, the computer is going to try to make the car compensate for what it sees from the speed sensor...

I had this problem on an Explorer.

With my Explorer, the problem was the worm gear on the inside of the transmission... but other things in that area are the Vehicle Speed Sensor (VSS) and the Drive gear for the speedometer...

The way I isolated the problem was to take out the speedometer gear and hook it to a cordless dril (electric2_bing.gif drills might spin it too fast). Turn the ignition to the "on" position, but do not start the car2_bing.gif. Have someone watch the speedometer from inside the vehicle as you spin it.

If the speedometer gauge works and stays constant, then you know your problem is with the drive gear or the worm gear on the inside of the transmission.

If it doesn't work, then you know that there is an electrical issue with the speed sensor circuit or something in the gauge cluster is broken.

Good luck

May 05, 2010 | 2003 Kia Sedona

1 Answer

1999 ford escort speedometer works but the odometer doesnt how do i fix it and where is it located thankyou ricky


The odometer has nylon gears. I guess your gears could have stripped out. You can find a cluster with similar miles to yours and put that in. You can try replacing the wheel but if the gears in the drive part are busted, they won't drive a new wheel. If the gears on the odometer are busted then it won't work at all.

Mar 04, 2010 | 1999 Ford Escort

2 Answers

Speedometer not workin at times. Not shifting into second gear.Then after sometime driving car shifts and speedometer starts working. Then car drives normal


wont shift out of first gear, engine races and speedometer isnt moving and all fluids are full on 2000 dodge caravan

Jul 15, 2009 | 1999 Dodge Intrepid

1 Answer

P0500, intermittant speedometer, after sitting 6 months


Sounds speedmeeter is going haywire. Like everything in today's automobiles they are made with plastic gears. Some can be unscrewed under the stearing wheel others are not. The problem with the brake light break pads were probably stuck.I would say that your speedometer is not removable to many people disconnecting them for low milage on vehicle when trading or selling.

Jun 12, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
2001 Hyundai Santa Fe Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63456 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...