Question about 2003 Dodge Dakota Club Cab

Open Question

2003 dakota 4dr. jack access

How do i get at the jack under the rear seat. seat folds up to see jack but can't get at it without backrest folding down. how does it fold. no levers or buttons visable.

Posted by on

  • walzers Dec 15, 2008

    with the 2004 model Quad cab.. I can see it but very hard to get at.

×

5 Suggested Answers

  • 1 Answer

SOURCE: Rear seat won't fold down (60 part of 60/40 seat)

I had the same problem on my '03. The seats would not fold down using the latch release as I had always done. So I tried a combination of pulling up on the side latch AND the top latch and the seat folded down. It really doesn't FIX the problem but circumvents offending  defective part. I will use this method until it doesn't work then I might shell out the $$$$$ to the dealer.

Posted on Jul 01, 2008

  • 1 Answer

SOURCE: rear seats folding

there are two locking tabs located in the trunk (up high, near the hinges) that prevent them from comig down
one for each seat...

Posted on Feb 06, 2009

mechanicm639
  • 253 Answers

SOURCE: hOW DO THE BACK SEATS FOLD DOWN

There is a latch located behind the head rest on the rear deck area of the car. Good Luck

Posted on May 07, 2009

  • 462 Answers

SOURCE: Fold down rear seats

THE SEAT RELEASES ARE IN THE TRUNK IN THE AREA WHERE THE SPEAKERS ARE NEAR THE EDGE OF THE TRUNK OPENING.

Posted on May 25, 2009

  • 508 Answers

SOURCE: after the seats were folded down the legs were

bend them back into place!

Posted on Jul 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove rear seat


Rear seat cushion-fold forwards,release plastic clip from hinge,remove wiring multiplug if applicable.Lift out cushion.(40% backrest)Tilt forward approx 20degrees,use a screwdriver to release catch retainer on outer pivot pin.lift backrest and withdraw from inner pivot pin.Lift the backrest from inside vehicle.(will only lift out if backrest is tilted forward 20degrees from verticle. 60% section can then be removed on saloons by releasing the lock with a finger and pulling from the anchor pins.On estates unscrew centre seat belt lower mounting and unscrew hinge pin from centre support. unhook upholstery clip and lift backrest from lefthand side mounting.slide backrest towards the door to release centre pinlug and withdraw backrest from inside the vehicle. Refit in reverse order.

May 22, 2015 | 1999 Saab 9-5

1 Answer

My power third row seat don't work, I tested the motors and they work fine when power directly. When I measure the voltage at the connectors I get about +/- 10 volts, from any of the 4 switches. I verified...


Your missing something's G-404 has nothing to do with it !
Seats - Third Row
The third row seat:
  • is three-passenger seat.
  • a 60/40 bench seat.
  • folds down for more cargo area.
  • has optional power fold down seats.
Third Row Power-Fold Seat
CAUTION: To prevent possible damage to the third row seat or the safety belts, make sure that the safety belts are not fastened when moving the seat to the load floor position.
CAUTION: Make sure that no objects such as books, purses or briefcases are on the floor in front of the third row seats or on the seat cushion before lowering the backrest(s).
The third row power-fold seat consists of the following electrical components:
  • right third row seat relay.
  • left third row seat relay.
  • right power-fold seat motor.
  • left power-fold seat motor.
  • right front third row seat switch (if equipped).
  • left front third row seat switch (if equipped).
  • right rear third row seat switch.
  • left rear third row seat switch.
For the third row power-fold seat to operate, a shared ground is supplied by the body security module (BSM) to both of the power-fold seat relays, enabling the seats to then be moved by pressing one of the third row power-fold seat switches. The third row power-fold seat operates only when the vehicle is in PARK and the liftgate glass, liftgate door or any entry door must be open.
The third row power-fold seat motors transfer movement to a drive gear assembly to raise and lower the seat backrest. The power-fold seat motors rotate a short drive cable which is connected to the drive gear assembly.
The relay's are located in Aux. relay box #2

May 24, 2017 | 2003 Ford Expedition

2 Answers

2004 ford expedition: changed battery, now rear seats will not go up or down. One is up the other one is down. They were working fine before the battery was replaced. Wifes car need to fix, she is...


Call the dealership and ask them how to reset the electronic on your Ford Expedition after changing the battery. Anything else is happen? Maybe like the radio wont turn on, hit the turn signals and the windshield wiper turn on. ***** things happen after replace the battery. I know what it is, it the darn wigits. GB you....stewbison

Aug 21, 2011 | Ford Expedition Cars & Trucks

1 Answer

Locked my keys in boot and no spare key.its a audi a3 2006 2 door


You can remove the back seat and access the trunk from car inside. The rear seat is split 60/40 and folds down for carrying even more stuff. Push the backrest upper lateral button and fold down the rear seat backrest. Then go into the trunk and take out your set of keys.

Jun 10, 2011 | Audi A3 Cars & Trucks

1 Answer

I locked my only set of keys in the boot of my audi a4 2004. how do i go about getting them out? can i take the back seat out and where do i start?


Yes, you can remove the back seat and access the trunk from car inside. The rear seat is split 60/40 and folds down for carrying even more stuff. Push the backrest upper lateral button and fold down the rear seat backrest. Then go into the trunk and take your set of keys.

Mar 28, 2011 | Audi A4 Cars & Trucks

2 Answers

HOW TO LET DOWN THE REAR SEAT IN A FORD FOCUS 2001


If the rear seat folds down the fabric lever will be at top of seat in trunk. many of these eats do not fold down.

Oct 27, 2009 | 2001 Ford Focus

1 Answer

Middel seatbelt will not loosen


I think you have to remove headrst bfore folding seat back down. You may have to unbolt seat from floor. 4 bolts.
Rear Seat Backrest —Split Bench Removal
NOTE: The 40% rear seat backrest must be removed before the 60% rear seat backrest.
40% rear seat backrest
  1. Remove the 40% rear seat backrest.
    1. Remove the nuts and bolts.
    1. Remove the backrest.
60% rear seat backrest
  1. Remove the 60% rear seat backrest.
    1. Remove the nut and bolt.
    1. Remove the backrest.
Installation
NOTE: The 60% rear seat backrest must be installed before the 40% rear seat backrest.
60% rear seat backrest
  1. NOTE: Do not tighten the nut and bolt at this time.
    Install the 60% rear seat backrest.
    1. Install the rear seat backrest.
    1. Install the nut and bolt.
40% rear seat backrest
  1. NOTE: Do not tighten the nuts and bolts at this time.
    Install the 40% rear seat backrest.
    1. Install the rear seat backrest.
    1. Install the nuts and bolts.
60/40% rear seat backrest
  1. Tighten the 60/40% rear seat backrest nuts and bolts in the sequence shown.
de01dcf.gif
40% Rear Seat Backrest
  1. Tighten the 40% rear seat backrest nuts and bolts in the sequence shown.

Jun 11, 2009 | 2005 Ford Escape

1 Answer

Deadlocked S80. Seats don't fold down. Keys in


hi there i presumed as you have told us that the back seats don't fold down that you have access to the inside of the car, if this is the case you could remove the backrest of the back seat and fish for the keys throw the holes in the back panel. regard John

May 16, 2009 | 1999 Volvo S80

2 Answers

Hai i would like to know how to fold the back car seat to increase cargo space in hyundai santa fe 2003


The rear seats have a pull strap located between the bottom cushion and the backrest of the rear seats used to disengage a lock to lift up the bottom cushion. The pull straps will only stick out an inch or so, or they might have fallen down between the seats and then you wont see them. Before you can lower the backrest of the rear seats, the bottom cushions have to be lifted up and forward out of the way so that the backrest may lie down flat. If your pull straps are not visible between the bottom cushion and the backrest, you may have to stick your hand between the cushions and feel for the straps. Once you find the straps, pull upward on the while lifting on the bottom cushion where the pull strap is located and the seat should tilt forward. Once you have manged to do this, the lever for the backrest is located on the top of the backrest. Just slide the lever and tilt the backrest to the desired position.

Apr 13, 2009 | 2003 Hyundai Santa Fe

1 Answer

How to fold down back seat


There should be a loop between the seat and backrest, pull that and the seat will pull toward the front seats. After that, pull the lever located at the outside of the backrest. This lever is on the outside of the seat by the door-side of the seat. Pull that up and allow the backrest will fold down and the headrest will pivot back and your seat is folded down.

Jun 28, 2008 | 2004 GMC Envoy

Not finding what you are looking for?
2003 Dodge Dakota Club Cab Logo

Related Topics:

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

71288 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7009 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...