Question about Renault Fuego

1 Answer

Vacume pump will a vacume pump from 1999 19td scenic fit a 1997 td

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Renault Master
  • 22,359 Answers

Should do ,might be a different pipe connector but just swop them over ,but iam sure they are all the same

Posted on Nov 17, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Renault scenic 1.9 td '03 starting problems in cold weather

coolant temp sensor, you have one for your gauge and another for your ecu, it adjusts air fuel ratio dependant on the outside temp as colder air is denser than warm.

I’m happy to assist further over the phone at

Dec 29, 2013 | Cars & Trucks

1 Answer

Hi, I need some help please! I have a peugeot 406 2.1 td p reg. I've had to put a 1.9 bosh pump on it to bipass the imobiliser. does any one know what order the injection pipes go in. cheers ale

Hi Alex, The firing order is 1-3-4-2. When fitting the injector pump I hope you noticed the match marks for timing. When fitted and aligned the engine will be at TDC firing on one. To identify # 1 on the pump, connect the fuel supply and bleed air from the system and rotate the engine one and three quarter revolutions by hand, having someone watch which outlet ejects fuel when passing TDC completing the second rotation. That will indicate number one piston. Follow the firing order for the remaining three. Regards John

Nov 16, 2012 | Cars & Trucks

1 Answer

Nissan d22 navara 06 no vacum to brake booster??

if you are sure you have no vacum at your brake booster it could possibly mean either you have a leaking vacum pipe or if you have a pump fitted then the fault is that. If you are not sure if you have vacum at the booster end than it could also be a booster fault. Check the pipe first at the booster end (engine running)

May 26, 2012 | 2006 Nissan Navara 2.5

1 Answer

A 1997 Trail Blazer on the fuel pressure regulator is there to be a vacum line and if so where is it run to. Thank you

If it's vacuum operated, the regulator would be on your fuel rail. It would have a fitting/nipple for the vacuum line to connect to. The line would come from the intake manifold, somewhere, but a vac. line specific for the regulator. Some cars use means other than vacuum to regulate fuel pressure. Some even have the pressure regulator in the tank with the pump. Not exactly sure about your '97 blazer.I hope somebody else here knows.

Oct 30, 2011 | 1997 Chevrolet Blazer

1 Answer

Is there a fuse for cenyifugal pump for heat on a mercedes 300 td from 1997. and what is it for one?

centrifugal pump for heater ?? this is a new one on me thats for sure ,please explain what the problem is to start with and i may be able to help

Jan 07, 2011 | 1997 Mercedes-Benz C-Class

1 Answer

I can't figure out how to get at the pump

Remove Jack from front left hand fender area.There are 3 rubber grommets that attach to the vacum compressor , which you will see If you look immediately beneath the compressor location.Feed these grommets back up into the compressor location area from beneath, and hey presto you have loosened the vacum pump for removal.
Compressor is accessed by 2 large holes in bottom plate upon which the tyre jack sits.It will pull out through these holes with a bit of manouvering.Be warned its like doing keyhole surgery.

Jun 08, 2010 | 1997 Land Rover Discovery

2 Answers

1997 ford escort a/c blowing hot air pressure registers @150-155

Get a can of freon at the auto parts store, with leak detection dye in it then inspect all fittings and coils after you run it .

Aug 16, 2009 | Ford Escort Cars & Trucks

1 Answer

1997 jetta td, coolant is leaking, but car is not overheating

look at all your hoses and the seams on your rad, you will find the seams at each end of the rad, see thats its not liking from ether side. locate and look around your water pump the gasget maybe bad, and be sure look at your drain valve, if its plastice change it to metal if you can the plastice can wear out faster and can become brittle

Feb 23, 2009 | 1997 Volkswagen Jetta

3 Answers

Air lock on diesel to engine on c 250 td - how do I solve

the only permanent solution to your problem is to replace ALL the O-rings on the injection pump fuel lines. Don't forget the one behind the fuel cut-off valve as well..
This is the only soltion that really worked for me.

Sep 29, 2008 | 1997 Mercedes-Benz C-Class

1 Answer

1998 renault scenic water pump replacement

to replace the pup the timing belt must be removed. water pump removed. new 1 saled and fitted and t belt replaced

Aug 21, 2008 | 2000 Renault 181

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

xxxxxx xxx

Level 3 Expert

4981 Answers


Level 3 Expert

81423 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides