Question about 2001 Chevrolet Blazer

1 Answer

Wont start unless I use carb cleaner than runs But in the morning wont start again

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 1 Answer

The fuel pump wasn't fully working replaced it.

Posted on Nov 18, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Fusion starts first time in the morning and then dies unless revs maintained. If not it takes several turns of engine to eventually start again . Then starts perfectly all day long.


From what you are saying I would think it's the idle control valve. These get sticky and cause the car to stall. Take it off clean with carb cleaner let it dry out completely then reinstall and see how that goes. Hope this helps

Sep 12, 2017 | Ford Cars & Trucks

1 Answer

My 20 hp craftman wont start new starter got fire throu spark plug


Spray a little carb cleaner or brakeclean into carb w/air cleaner removed. If starts, check fuel supply to carb. If ok, clen carb and jet with spray carb cleaner and try again.

Jun 19, 2016 | Cars & Trucks

1 Answer

Grand am 3 4


Sounds like a faulty fuel pressure regulator, or possibly the MAF sensor.

Mar 28, 2014 | 2004 Pontiac Grand Am

2 Answers

2003 volvo s40


worn fuel pump / low fuel pressure / engine management fault ?

Dec 23, 2013 | Cars & Trucks

2 Answers

Wont start


simpler that exposing the throttle body just depress the accelerator 3/4 and try to start.

If like before, the vehicle starts... watch the rear view mirror for black smoke

both indicates a leaking injector(s)

Mar 16, 2010 | 1998 GMC Sierra

1 Answer

After driving the truck will not start unless the


try to clean the throttle body with a carb and choke cleaner using a tooth brush to help you out. it sounds like your not getting enough air. also get a injector cleaning. or run a few (2)bottles of fuel injector cleaner in a full tank of fuel.

Jan 01, 2010 | 1989 Ford F 150

1 Answer

Engine will crank but will not turn over


Do this, take the top off the carb, being careful not to damage the gasket. Then take some carb cleaner and clean out the bowl and floats. Remove the needle valve and clean it out. Put it all back together and filling the bowl with carb cleaner. Start it with the starting fluid. Once you run the carb cleaner through it, it should start to run on it's own. Whatever you do don't shut it off for about 20-30 min unless you have to.

Apr 27, 2009 | 1989 Jeep Wrangler

1 Answer

Wont start after setting


Remove air cleaner Spray carb with carburetor cleaner inside and out let dry try to start..

Probable cause dirty carb or air cleaner choke not set properly or needs adjustment
and cleaned>>Charg battery ans check fluid level fill only with distilled water

Jan 30, 2009 | 1997 Chevrolet Suburban

Not finding what you are looking for?
2001 Chevrolet Blazer Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...