Question about 1996 Jeep Grand Cherokee

2 Answers

96 jeep grand cherokee

Hi, saw your response to a Jeep no start condition on this site and I am having the same problem you are with the little 20 amp fuse blowing( middle one close to bat) under the hood. Did you ever find the problem? and what is fuse for ? PCM? LL73Jay@yahoo.com

Posted by on

  • bksxxx Feb 21, 2009

    I have the same problem...Any suggestions???

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

We have also had this problem this week over the last few days, on the passenger side of transmission we found the neutral safety switch just before the catalytic converter wiring harness and wires were melted and frayed so check there also

Posted on Mar 12, 2010

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If it is the fuse for major engine control electronics that is blowing (PCM, etc.) as soon after energizing, try disconnecting the O2 sensors. The 12V heater in the sensor could be shorting to ground.

Posted on Nov 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Replace serpantine belt on 96 jeep grand cherokee v-8


Here you go, pick the one that applies:

https://www.google.ca/search?q=serpentine+belt+routing+for+96+jeep+grand+cherokee+v-8&biw=1360&bih=609&source=lnms&tbm=isch&sa=X&ei=9B71VMygJ5PfgwS-rYCgDA&ved=0CAYQ_AUoAQ

Mar 03, 2015 | 1996 Jeep Grand Cherokee

1 Answer

Jeep cherokee limited ed. 96 wont start


check for spark??...and ignition coil

Mar 11, 2010 | 1996 Jeep Grand Cherokee

2 Answers

96 jeep grand cherokee starts but wont idle


CHECK FUEL REGULATOR ON FUEL INJECTOR RAIL,&ALSO FUEL PUMP, CHARLIE

Feb 21, 2010 | 1996 Jeep Grand Cherokee

1 Answer

Have an issue with my 96 Jeep Cherokee's Air Conditioning It only works only when I set the fan on HI otherwise it's dead do you have any idea what this?


ck the blower resistor. its located right beside the blower motor. 2 plugs I think. take it out, if anything looks burned, its bad.

Sep 18, 2009 | 2005 Jeep Grand Cherokee

2 Answers

96 grand cherokee crank no start, no spark from


have the crank sensor replaced this controls the spark and injector pulse it is located on the drivers back side of the engine above the transmission housing!

Jun 08, 2009 | 1997 Jeep Grand Cherokee

1 Answer

96 jeep cherokee, replace cps and the engine control fuse


The guy at the garage today, said he went out and put a fuse in it and it started right up. Thats all he did for now. I going to have a closer look on the weekend. But, as before when I went 1/2 mile it would burn the fuse again. We will have to see if it does again, I espect it will. Any idea?

Mar 26, 2009 | 1996 Jeep Grand Cherokee

2 Answers

1996 jeep grand cherokee limited won't start alarm keep flashing


try the 15 amp fuse under the hood by the battery if its blown put in a 20.
turn on the key and wait for all the ligth to go out then try it if it dosnt start the first time do it a 2nd same thing
hope it helps

Feb 26, 2009 | 1996 Jeep Grand Cherokee

2 Answers

96 Jeep Grand Cherokee not running well


If the check engine light is not on, I would do a cylinder compression test.

Feb 14, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Battery drain from power door locks on 96 Grand Cherokee


The Module in the Drivers Door is notorius for this problem. I would start by changing that first. Good luck to you. Thanks for using fixya!

-JC

Jan 15, 2009 | 1997 Jeep Grand Cherokee

1 Answer

2001 Jeep Grand Cherokee which fuse controls heated seats?


Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.

CLICK_HERE

Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.

Nov 15, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...