the lights are out on the shifter and the heater control knobs. the dealership says it may be a wiring problem. how do i remove the cover for the shifter and the front dash(to get to the knobs)?
-   i have the same problem but only with the heat directing knob and ive torn down the center dash to only find a lightbulb is out. the light bulb costs ~42.00$ at a dealership but you can try your luck at a junkyard. you can remove the center dash by opening and pulling the top storage out, gotta give it a good **** and u also have to pull out the very bottom cd storage "COVER" above the cup holders. this is only cliped on and its easy to pull out and nothing should break. everything after that is phillips screws like the a/c, radio, and the mounting.
-   Guest
Dec 12, 2008
-   my light has went out on the heater control as well it is the middle one which is the 1-4 and the last one which is where you want the heat how do i get the cover off-   Guest
I got to the bulbs on the heat sensor and control knob turn to left and pull out ordered them 30.00 apiece one was working but not now dont know what the circuit board is for where lights are will replace them next week we will see
Running normally Car just shuts off after reaching normal temp, no sputter, nothing....just shuts...
(More)
Running normally Car just shuts off after reaching normal temp, no sputter, nothing....just shuts down. Could this be a sensor problem?
I have 2004 Sentra, 1.8L Standard. Starts,Runs for a bit then quits. Code says camshaft sensor was...
(More)
I have 2004 Sentra, 1.8L Standard. Starts,Runs for a bit then quits. Code says camshaft sensor was the problem. Replaced it - worked well for a month, then same problem - so I spoke with some local garage mechanics I know. Some of their thoughts - May be broken wire form sensor to computer. So now I have checked continuity of wire harness, checked (old)and new camshaft sensor - all good. replaced O2 sensor just in case. Still the same code comes up - camshaft position sensor. Any thoughts on what may be the problem why it will not stay running?