Question about 2002 Dodge Ram Maxi

1 Answer

Tail lamps and front corner lamps inop

I have a 2002 Dodge Ram 1500 p/u Quad cab 4x4 the tail lights and the front carner lamps aren't working I found a 5 amp fuse melted replace the fuse and still no lights how do I replace the front corner/parking lampsDJPalmer

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 279 Answers

If the fuse was melted, I doubt that all 4 bulbs went bad at once. It sounds like you have a short circuit there. The power goes from the fuse, up to the head lamp switch and then to the 4 lamps. Check to see if the headlamp switch is working properly.
Charlie

Posted on Nov 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My tail lights on the driver side only do not work I have a 2007 Dodge Ram 1500.The lights on the passenger side work fine


The wiring of the harness is parallel to the sides. hence you will need to trace the driverr side lamp connection backwards to the joining section of the line. Please check on the ground connection of the lamp assembly, remove and clean and reset after confirming that the groundis fine but the voltage does not reach on switch on of the park lamps. If this becomes difficult to trace just take a parallel wires from the passenger side lamp to be connected to the non working side. this will work fine. Please take care to insulate.Good day

Jul 07, 2010 | 2007 Dodge Ram 1500 Quad Cab Sport

1 Answer

Im trying to locate a fcm and pcm...any ideas as


THE FRONT CONTROL MODULE IS LOCATED ON THE END OF THE UNDERHOOD FUSEBLOCK..YOU MUST REMOVE 1 BOLT FROM FUSEBLOCK AND 1 PLASTIC CLIP..SLIDE FUSEBLOCK BACK..FCM IS ATTACHED WITH 4 SCREWS TO FUSEBLOCK..PCM IS LOCATED ON RIGHT SIDE OF FIREWALL OF ENGINE COMPARTMENT..I HOPE THIS HELPS

Aug 26, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

2002 dodge ram 1500 quad cab. service 4x4 light came on, 2nd time. 1st time battery ran down due to light left on. charged the battery started truck and light was out. this time just got truck back from...


this light is telling you that there is something wrong with the system. like fluid levels in the transfercase or front diff it could be telling you that the transfercase may have some internal issues. I would take it to a transmission shop and have them look at the tcase and front diff

Jun 03, 2009 | 2002 Dodge Ram 3500 Truck

1 Answer

Engine stalls in drive after check engine light came on.


Have it sacnned for a code. it seems to be the speed sensor at the tranny.or the crankshaft position sensor. hope this helps. will you please vote ?

Dec 19, 2008 | 2007 Dodge Ram 1500 Quad Cab Sport

Not finding what you are looking for?
2002 Dodge Ram Maxi Logo

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...