Question about 1998 Honda CR-V

Open Question

Replacing the cabin filter in a 1998 honda crv

I have removed the glove box and discovered a metal bracket that is blocking the removal of the cabin air filter. Do I have to remove the dash too?

Posted by on

  • Anonymous Dec 02, 2008

    I have exactly the same issue. I've seen some post they undo a few bolts and bend it out of the way.

  • Anonymous Jan 16, 2009

    how do i get to a cabin air filter on a 98 honda accord

×

6 Suggested Answers

  • 1 Answer

SOURCE: What fuse # controls the in cabin fans on a 2004 Honda CRV?

The fuse box is located under the steering wheel to the right. A diagram on the back of the removable door should show you which fuse to check. You will likely need a pair of needle nose pliers to reach/pull the the fuses, they're recessed beyond the opening.

Posted on Jul 08, 2008

Brian032472
  • 150 Answers

SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic

Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually

Posted on Nov 04, 2008

  • 651 Answers

SOURCE: 2001 Honda Crv Bake light on dash is on

make sure your emergency brake is off all the way.

Posted on Nov 28, 2008

JShreader
  • 50 Answers

SOURCE: remove glove comartment

Hello mrock107, my name is JShreader. Thank you for choosing fixya.com.

First, remove the Glove Box and Glove Box Frame. Then release the wire harness from the clamps on the evaporator. Remove the filter lid, then pull out the A/C filter assembly from the evaporator housing. I uploaded a picture for you in .pdf format showing you how to get it out. You can download it by clicking HERE. I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

Posted on Apr 01, 2009

  • 58 Answers

SOURCE: How to change the cabin filter on 2006 Honda Odyssey?

I will never understand why this service is so expensive at the dealership.
I made a video showing how this is done:   (I would recommend watching the video in HQ and full screen)

Posted on Apr 21, 2009

jyackle5
  • 8197 Answers

SOURCE: how to replace cabin air filter in 2003 pilot

Step 1 Take everything out of the glove box on the passenger side. Squeeze the black clips on either side of the glove box interior to free it from its retainer and pull it toward you. It will glide forward on hinged arms. Lower it as much as possible so it's out of your way.

  • Step 2 Identify the gray plastic bar that runs from left to right across the bottom of the glove box opening. This is a piece of plastic molded to the rest of the glove box assembly, but it covers up a removable bar that is mounted directly in front of the cabin air filtermag-glass_10x10.gif case. You'll have to cut this plastic bar off with a razor knife to proceed. Fortunately, this isn't too difficult; just cut carefully and steadily, and make your cuts as close as possible to the ends of the bar.
  • Step 3 Remove the metal bar you uncovered in the previous step. It is screwed into the glove box assembly with Phillips head screws on either side.
  • Step 4 Open the cabin air filter case, which is the large plastic case on the left side off the glove box opening. The hatch will come all the way off when you open it.
  • Step 5 Take the old air filter out of the case and throw it away.
  • Step 6 Look at the arrows on the filter and the arrows on the filter case that indicate the direction of the air flow. Slide the new filter into place so that the arrows are both pointing the same way.
  • Step 7 Put the lid back on the air filter case and reinstall the metal bar you removed in Step 3.
  • Step 8 Push the glove box interior compartment back into place and listen for the snapping sound. Put the glove box contents back, close the lid and you're done.
  • Posted on Dec 06, 2009

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    Where is the dust and pollen filter located on a 2009 Honda CRV?


    Hi Maria: Remove the glove box, then you will be able to remove the cabin air/pollen filter. If you need help removing the glove box, try You Tube and search "2009 Honda CRV dust and pollen filter replacement. You can purchase one from a Honda dealer online or aftermarket such as Rock Auto, etc. Take Care.

    Mar 05, 2014 | 2009 Honda CR-V

    1 Answer

    How to replace the cabin microfilter


    Hello, I'm sending you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
    Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
    Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
    Remove three screws and remove in cabin micro filter cover.
    Remove in cabin micro filters from front heater and cooling unit assembly.
    Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
    Install in cabin micro filter cover. Reinstall glove box.12eb879.gif63a72f6.gif
    Thanks

    Jul 27, 2010 | 2005 Nissan Quest

    1 Answer

    How do i change the cabin air filter on my 1998 honda accord v-six i cannot find it


    you have to remove the glove-box and frame to access the cover that hold the 2 cabin air filters in. Remove the 2 filters and remove them from the frames they sit in. Install new filters in the frames and reassemble as needed. Good luck

    Jan 05, 2010 | 1998 Honda Accord

    1 Answer

    How to replace cabin air filter in 2003 pilot


    Step 1 Take everything out of the glove box on the passenger side. Squeeze the black clips on either side of the glove box interior to free it from its retainer and pull it toward you. It will glide forward on hinged arms. Lower it as much as possible so it's out of your way.
  • Step 2 Identify the gray plastic bar that runs from left to right across the bottom of the glove box opening. This is a piece of plastic molded to the rest of the glove box assembly, but it covers up a removable bar that is mounted directly in front of the cabin air filtermag-glass_10x10.gif case. You'll have to cut this plastic bar off with a razor knife to proceed. Fortunately, this isn't too difficult; just cut carefully and steadily, and make your cuts as close as possible to the ends of the bar.
  • Step 3 Remove the metal bar you uncovered in the previous step. It is screwed into the glove box assembly with Phillips head screws on either side.
  • Step 4 Open the cabin air filter case, which is the large plastic case on the left side off the glove box opening. The hatch will come all the way off when you open it.
  • Step 5 Take the old air filter out of the case and throw it away.
  • Step 6 Look at the arrows on the filter and the arrows on the filter case that indicate the direction of the air flow. Slide the new filter into place so that the arrows are both pointing the same way.
  • Step 7 Put the lid back on the air filter case and reinstall the metal bar you removed in Step 3.
  • Step 8 Push the glove box interior compartment back into place and listen for the snapping sound. Put the glove box contents back, close the lid and you're done.
  • Dec 06, 2009 | 2003 Honda Pilot

    1 Answer

    I need to replace my Nissan Quest 2007 in cabin micro filter


    I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
    Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
    Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
    Remove three screws and remove in cabin micro filter cover.
    Remove in cabin micro filters from front heater and cooling unit assembly.
    Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
    Install in cabin micro filter cover. Reinstall glove box.12eb879.gif63a72f6.gif

    Oct 10, 2009 | 2007 Nissan Quest 3.5 Minivan

    2 Answers

    Where nad how to check cabin air fielter?


    The Cabin air filter is located behind the glove box, There is a plastic cover that must be removed to change the filter, if the filter has never been changed a plastic bracket may have to be removed also.

    Sep 22, 2009 | 2006 Honda Odyssey

    2 Answers

    2008 honda pilot cabin air filter


    This solution pertains to a 2008 Honda Pilot...To replace the cabin air filter which is located on the passenger side of the vehicle behind the glove box: Open glove box and remove stored items...while sitting in the passenger seat, pull towards you on each of the two clips on the left and right side of the glove box...this will cause them to become loose and the glove box will tip out completely exposing the inside of the dashboard. (Alternately...carefully pull towards you on the top center of the glove box which will cause the left and right side stops to pull away from the edges and allow the glove box to tip out) Here it gets tricky...the box holding the cartridge for the cabin air filter is the large black box on the left side behind the glove box The filter fits in a removable tray vertically inside that box. A pressure clip at the top of the box allows the vertical cover to be removed exposing the tray with the Cabin air filter... BUT!!! There is a plastic bar an inch or so high which has been placed there by the manufacturer to prevent most from changing the filter without the service department being involved. This bar must be cut with a sharp sheetrock knife or hacksaw and discarded, (it will not be reinstalled). Then there is a flat metal bar behind the plastic bar that can be removed using an 8mm socket and a phillips screwdriver. There are 2 8mm screws and one phillips head screw on each side that must be removed in order to remove the metal bar. THEN you can remove the cover to the cabin air filter box, pull out the tray with the filter (note how the filter is in the box so the new one can be placed the same way) reinsert the tray with the new filter and replace the tray cover. All other steps to finish the job are obvious as everything is the reverse. Actually the whole process is a lot of trouble and unless you are determined to change the filter I would recommend not doing it.

    Aug 24, 2009 | 2008 Honda Pilot

    1 Answer

    How do you change the cabin air filter on 2005 crv?


    remove the glove box stop of each side and hang the glove box down. and i will see the filter.

    Jul 07, 2009 | 2005 Honda CR-V

    1 Answer

    Remove glove comartment


    Hello mrock107, my name is JShreader. Thank you for choosing fixya.com.

    First, remove the Glove Box and Glove Box Frame. Then release the wire harness from the clamps on the evaporator. Remove the filter lid, then pull out the A/C filter assembly from the evaporator housing. I uploaded a picture for you in .pdf format showing you how to get it out. You can download it by clicking HERE. I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

    Mar 29, 2009 | 1998 Honda CR-V

    1 Answer

    Cabin Filter replacement


    The filter comes with the instructions. I just did it last night to my Honda. It is behind the glove box. You need to remove the glove box, cut a plastic beam out, unscrew the metal support beam and then open and r/r the filter. The instructions don't mention that you need to remove the trim that covers the little fuse box located on the side panel--there is a plastic retainer that you unscrew by hand and then it all comes off easiliy!

    Jul 23, 2008 | 2005 Honda Pilot

    Not finding what you are looking for?
    1998 Honda CR-V Logo

    Related Topics:

    482 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honda Experts

    yadayada
    yadayada

    Level 3 Expert

    60792 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6811 Answers

    Are you a Honda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...