Question about 2001 Ford Mustang

1 Answer

Engine chugs under load

My 2001 mustang chugs under load. i.e in fourth gear while driving slow. it runs smooth as silk under higher rpms.

EGR? Plugs and wires? DPGE valve?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I would start with new set of wires & good plugs that should help.

Posted on Dec 14, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just picking this car up with 118,000. First is the gas mileage. Only getting around 15-17 mpg. Besides spark plugs wondering what normal rpm's should be for a 3.5 V6.


The 3.5 is a great engine and in the Concorde pretty efficient for sure over 20 MPG. The 3.5 HO is 1st generation and has a 10.4 to 1 comp ratio. 89 octane is required later engines after 1998 had the compression ration lowered to 9.9 to 1 and 87 might be acceptable. Scheduled spark-plug change is usually 60K miles. If plugs have not been changed than I would certainty start with them. Check tire pressure against the driver door recommended. I expect if all else is well that at 60 MPH just under 2000 RPM in over drive and smooth..

This engine was built in Chrysler's Trenton engine plant in MI and is considered one of the best power planets at the time.

Dec 02, 2015 | 1997 Chrysler Concorde

1 Answer

2001 mazda tribute


I would replace the engine and transmission mounts, they are hard and transmitting engine vibration to the chassis.

Feb 28, 2014 | Cars & Trucks

1 Answer

Celebrity cutting out when accelerating


EGR is typically not employed at high loads because it would reduce peak power output. This is because it reduces the intake charge density. EGR is also omitted at idle (low-speed, zero load) because it would cause unstable combustion, resulting in rough idle. The EGR valve also cools the exhaust valves and makes them last far longer (a very important benefit under light cruise conditions).
Since the EGR system recirculates a portion of exhaust gases, over time the valve can become clogged with carbon deposits that prevent it from operating properly. Clogged EGR valves can sometimes be cleaned, but replacement is necessary if the valve is faulty.

Jul 11, 2013 | Cars & Trucks

1 Answer

My 2006 mustang gt misfires under load in higher rpms


For engine misfiring problem check the help links mentioned below. Click the link below to go through the troubleshooting procedure :---- Engine misses and truck jumps? Hard to down shift? Issue with high gear only? http://technoanswers.blogspot.in/2012/02/engine-miss-and-truck-jumps-hard-to.html

-----------
Bad miss at idle?

http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

------------
Engine Misfire codes for car?

http://schematicsdiagram.blogspot.com/2011/12/engine-misfire-codes-on-chevrolet.html
Engine Misfire codes?

http://schematicsdiagram.blogspot.com/2011/12/engine-misfire-codes-on-chevrolet.html

--------------
Misfire on cylinder 4?

http://schematicsdiagram.blogspot.com/2011/12/misfire-on-cylinder-4.html

-----------
Oil on spark plugs and car misfires?

http://technoanswers.blogspot.in/2012/02/oil-on-spark-plugs-and-car-misfires.html

----------

This will help.

Thanks.

Feb 28, 2012 | 2006 Ford Mustang

2 Answers

Ruff idle on my 2001 for taurus. At higher rpms it runs fine.


It is most likely you wheel alignment (costs about 20 bucks to have your wheels aligned) or try checking the tire Pressure to make sure they're all even maybe hope this helps

Dec 29, 2009 | 2001 Ford Taurus

1 Answer

94 toyota camry running really rough


1st to do,replace fuel and air filter, spark plugs.

Jul 21, 2009 | 1994 Toyota Camry

Not finding what you are looking for?
2001 Ford Mustang Logo

Related Topics:

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...