An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: p1391 diagnostic code
The code is for intermitent loss of cam or crank sensor...one of the sensors maybe going bad or i have run into the wiring where it comes over the rear of the engine chaffing at the valve cover causing the loss of the signal
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
DIAGNOSTIC TROUBLE CODE (DTC) P1391: "INTERMITTENT LOSS OF CMP OR CKP" This DTC is monitored with the engine cranking or running. This DTC will be stored in the Powertrain Control Module (PCM) when the PCM FAILURE COUNTER reaches 96 failures for 2 consecutive trips. Posiible causes are: Craknkshaft Position (CKP) sensor improperly installed, defective CKP sensor, defective distributor, defective Camshaft Position (CMP) sensor, defective PCM, defective or broken flywheel, defective connectors or defective wiring. Proper diagnosis is recommended before replacing ANY parts.
Here are the meanings of these codes.
P1391 FORD - Glow Plug Circuit Low Input Bank #1
P1393 FORD - Glow Plug Circuit Low Input Bank #2
I think you most likely have a burnt out Glow pug controller. Whenever this controller is replaced all glow plugs should be tested for proper function.
Hello my name is brad,a code p-1391 is a crank sensor code or the cam sensor..check wiring connetors at crank sensor or at cam position sensor,do you have a car or truck or mini van and what size engine.i hope this helped brad