Question about Chrysler Voyager

1 Answer

My rear wheel, on drivers side of van, has locked up and will not move. what could be the problem? does turn when going foward or reverse. emegency brake is not on.

Posted by on

  • rtucker19 Nov 15, 2008

    sorry, i meant does not turn

  • darin brown May 11, 2010

    does vehicle have disc or drum brakes

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 147 Answers

Sounds like the caliper is locked up

Posted on Nov 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 ram 1500 4x4.when i put it four wheel drive high it feels like its in low and back tire on driver side skids


There's something seriously wrong in the transfer case or controls. It seems the rear driveshaft is locked up, and the front wheels are driving. The driver's side rear tire is skidding because it's trying to turn backward - rear passenger rear tire is going forward and rear differential has no option but to turn the driver tire in reverse (driveshaft locked). DON'T TRY TO DRIVE IT. Get it checked out and fixed.

Oct 25, 2016 | Cars & Trucks

1 Answer

1997 conversion van was towed now it wont go in reverse


When you tow a vehicle -- a flat bed hauler -- is your best bet

Next would be -- to use a wheel lift to raise the rear wheels or
remove the drive shaft, so the trans does not have any internal
parts moving

Hard to say IF something was ruined or reverse was about to fail

When reverse goes on a rear drive GM trans, your pretty much going to be taking it apart & rebuilding it,as reverse is the first parts into the case & the last out on disassembly


Jul 14, 2014 | 1997 Chevrolet K1500

1 Answer

My wife came to a stop while driving the van. When she went to take off she pushed the gas and there was a loud boom followed by a severe whining noise. The reverse gear worked so she got the van out of...


The wheels turning opposite is normal. It's how the differential works. You need to get the transmission checked out by a qualified tranny person.

Apr 08, 2010 | 1999 Ford Windstar

1 Answer

Rear wheels on 2000 super duty f250 skid in reverse only


I hate to say it but it sounds like you have a severe problem in the rear end. Here are a couple of things i would do. First pull off your tires and wheels. Of course you need to put the truck on jack stands and block the wheels for safety! Disconnect your rear drive line so you know nothing from front diff or trans could be affecting it. Next spin the brake rotors by hand and inspect them for severe damage. Go forwards and backwards. Also listen in your rear end for grinding or clunking noises and also excessive play front foward to reverse. And last drain your oil and put your finger up inside the housing as far as you can and feel for large pieces that should not be there. This should give you a good idea if it is in your braking sytem your rear end or wether you need to start looking at front diff. or the trans. If all is good on rear end do the same thing for front diff and inspect it as well. Make sure you pull front driveline off!

Feb 03, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

After sitting in driveway, back wheels have completely locked up.


Chock the front tires, loosen up the lug nutes on the rear tires, jack the rear end up, uncap the adjuster dust caps on the back of the rear drums, either use a brake spoon or straight blade screwdriver and turn the star adjuster while spinning the wheel until you have no resistance. If this does not work remove the rear tires and hit the sides of the drums with a small sledge hammer or hammer to loosen & break up the rust, When you get movement on the drum, hit it betweeen the studs. Be patient, this may take some time.

Jun 20, 2009 | 1998 Dodge Caravan

2 Answers

Ignition locked will not turn


easiest way to handle this problem is as you turn the key turn the steering wheel back and forth not real hard bust firm and try and turn the key foward and back at the same time. usually what happens is the little detente inside the column gets stuck just right and stops the tumbler from moving

May 20, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Locked key ignition


had the same problem with a 99 dodge van. tow truck driver put the key into the ignition and tapped it a couple of times while turning the key to freed it up and start the engine. works as long as you leave the key in the ignition so i use a second key to lock/unlock the van. hope this works for you. gary

May 19, 2009 | 2004 Dodge Stratus

1 Answer

Van makes poping sound when I change gear.


Possible motor mount worn. Stop at a reputable garage, they should be able to confirm for you at a glance.

Mar 05, 2009 | 1990 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...