Question about 2000 Volvo S70

2 Answers

Where is the obd 2 connector in volvo s70 2000


I am not able to find the obd 2 connector in volvo S70 2000. I tried to find in internet but i could not find it. Please tell me or show me proper location.

Thank you for help

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Open your center console.

Posted on Mar 13, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Volvo Master
  • 74,269 Answers

Below the steering wheel under the dash panel

Posted on Nov 15, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Could you please tell me how to turn off the service light on the dash of my 1999 volvo S80 2.9

best way is with obd scaner but if you dont have disconnect the negative batt and tap it a few times times like your putting in back on should over ride it in a 1999

Oct 24, 2016 | Volvo Cars & Trucks

1 Answer

2000 Volvo s70 got a code from my OBD tool witch is P1670 could that be why it doesn't get speed like pose to an it that apart or wat is it

P1670 is an Immobilizer fault code, the problem is related to the immobilizer antenna the connectors are defective or dirty or just loose.
There are 3 main parts to the immobilizer system. The ignition key, the antenna around the ignition lock, and the control module. The only thing that would need any sort of cleaning would be the electrical terminals that connects the antenna and control module.

Jun 24, 2016 | Volvo Cars & Trucks

1 Answer

My 1998 Volvo S70 keeps dying while driving. I wait a bit and it starts up again.if I accelerate to go with the flow of traffic it dies unable to get on freeway for fear of it dying help me please

Try make a OBD readout. Perhaps there are a troublecode stored in the system.
The relay to operate the gasolie pump in the tank can be defective so the solder is getting hot and loses contact.

Jun 10, 2016 | 1998 Volvo S70

1 Answer

What do you plug into the glove compartment on volvo xc60, I have just learned that you can plug the iPod into it in between the seats

hi that is youre OBD 2 connector plug used for diagnostics equiptment or iphone if you have the bluetooth connector plug and software installed on youre phone

Sep 06, 2015 | Volvo Cars & Trucks

1 Answer

How do I fix all warning lights on, on a 1999 Volvo s70 at the same time.

try disconnecting the battery ,leave for ten minutes for the electronic gizmos to power down ,i should say make sure you have the radio code , reconnect battery and try ignition if no change will need to be scanned on the Volvo diagnostic setup as i would'nt expect a generic OBD reader to be able to resolve this issue

Sep 25, 2014 | 1999 Volvo S70

2 Answers

How to reset service engine soon light on my volvo s70

Best use OBD II scanner,read the code and fix it.Sometimes to rest helps too.

May 05, 2014 | 1999 Volvo S70

2 Answers


  • Hi, I can help.

  • You don't have an OBDII port. You have an On Board Diagnostic set up or just plain OBD I.

  • The connector is under the dash. Take a paper clip and put it between the number 1 and number 2 ports. When you first stick the paper clip in you will get 1 blink and a pause the a 2 blinks which is normal and lets you know that the the OBD computer is reading properly and your codes will shortly follow in sets of two.

  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 26, 2011 | 1991 Pontiac Firebird

2 Answers

Where do I find the DLC Connector location for my 1993 Volvo 850 GLT? Where can I purchase the Volvo adapter for the OBD I and/or II readers?

hi, i know a shop, they supply the good qaulity and good aftersales volvo adapter for obdi or obdii. you can look here, hope help you.

Jul 01, 2011 | 1993 Volvo 850

1 Answer

I have Volvo s70 2000 model, Check engine, arrow up flashing and service light are up, very hard to drive, can only go 25 miles per hour Whats wrong??

go to Advance auto parts to test the OBD II sensor codes first to see what codes are coming up. Advance auto parts has one there they can check your codes for free.

May 31, 2011 | 2000 Volvo S70

Not finding what you are looking for?
2000 Volvo S70 Logo

Related Topics:

1,598 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts


Level 3 Expert

74241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7207 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides