Question about 1994 Toyota Camry

1 Answer

1994 camry power mirror assembly

I previously Emailed you to take you up on your kind offer to send me the pdf file of instructions to remove the front door panel on my camry.I am not sure if the original email was successful so I am sending it again.
Regards, Ronk Email:

Posted by on

  • ronk35 Nov 21, 2008

    Hi Ed,

    Yes i received your comments about the used parts. Found an outfit in chicago that could supply me with a mirror supposedly from Japan?. So, untilI I receive the mirror the installation is on hold. Needless to say your help an expertise is greatly appreciated. You can be sure if I run into difficulty I will contact you for additional help. Thanks again, ronk

  • Toyota Ed May 11, 2010

    Sorry, I did not get your original e-mail. Sure, I can send it to you. Expect to see it Monday morning.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

Sent it this morning. Please advise if you do not get it.

Posted on Nov 17, 2008

  • 2 more comments 
  • Toyota Ed Nov 18, 2008

    Did you get the .pdf?

  • Toyota Ed Nov 19, 2008

    How is the repair going? Need anything else?

  • Toyota Ed Nov 20, 2008

    Did you get my last communication regarding the used parts? Also, please rate this solution.

    A FixYa would be most appreciated. Thanks.

  • Toyota Ed Nov 21, 2008

    No problem, always glad to help. Call on me anytime. Thanks for the FixYa. I appreciate it.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1994 Camry: 1998 Toyota camry power window fell in door...

your problem is damage window regulator, you can change it by removing the trimboard first to give way in removing the old window regulator assembly.

May 06, 2010 | 1994 Toyota Camry

1 Answer

Need instructions to replace drivers side rear view mirror glass.

Outside Mirrors REMOVAL & INSTALLATION The mirrors on these models can be removed from the door without disassembling the door liner or other components. Both left and right outside mirrors may be either manual, manual remote (small lever on the inside to adjust the mirror) or electric remote. If the mirror glass is damaged, replacements may be available through your dealer or a reputable glass shop in your area. If the plastic housing is damaged or cracked, the entire unit will need to be replaced. Manual
  1. Remove the set screw and the adjustment knob, if equipped.
  2. Remove the delta cover; that's the triangular black inner cover. It can be removed with a blunt plastic or wooden tool. Don't use a metal prytool; the plastic will be marred.
  3. Fig. 1: Use a tapped ended tool to pry the trim from the mirror 89550g29.gif

  4. Depending on the style of mirror, there may be concealment plugs or other minor parts under the delta cover — remove them.
  5. Support the mirror housing from the outside and remove the three bolts or nuts holding the mirror to the door.
  6. Remove the mirror assembly.
  7. Installation is the reverse of removal.
  8. Power
    1. Turn the ignition key to the OFF position. Disconnect the negative battery cable. Wait at least 90 seconds from the time the negative battery was disconnected to start work. CAUTION
      Some models covered by this manual may be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in Section 6.
    2. Remove the delta cover; that's the triangular black inner cover. It can be removed with a blunt plastic or wooden tool. Don't use a metal prytool; the plastic will be marred.
  9. Depending on the style of mirror, there may be concealment plugs or other minor parts under the delta cover — remove them.
  10. Depending on the type of door trim, you may need to remove the door inner panel to access the electrical wiring harness for the mirror.
  11. Support the mirror housing from the outside and remove the three bolts or nuts holding the mirror to the door.
  12. If the wiring to the electric mirror was not disconnected previously, detach it now. Some connectors can only be reached after the mirror is free of the door. Remove the mirror assembly.
  13. Installation is the reverse of removal. Cycle the mirror several times to make sure that it works properly.

Jul 23, 2009 | 1996 Toyota Camry

1 Answer

I need to replace the mirror glass on a 1994 camry driver side p

Start with a good thick pair of leather gloves, a putty knife, and a tall trash can. Place the trash can below the mirror, tilt the mirror inward so you get a hold of the outer edge, and carefully pry the remaining pieces of mirror from the backing plate. Do not apply any pressure directly to the backing plate, or you may damage the gears on the electric motor. You should be able to pick up a new mirror and adhesive at your local auto parts store. Use masking tape and a couple of wood blocks to hold the glass in place while the adhesive sets (blocks against the glass, then wrap the whole thing in tape).

Feb 21, 2009 | 2003 Toyota Camry

1 Answer

Camry mirror ***'y

I routinely use recycled parts. I deal with several recyclers, and I have good luck with them. If a part comes in that is bad, they replace it for free. That being said, I would have no issue replacing the mirror with a used unit.
Japanese cars start the VIN with a "J", American production cars start with a "4".
I do not see where the difference would be, but, if you can find a used Japanese production mirror, go for it first. $215.00 is a realistic price, from the dealer. Used units are much, much cheaper.

Nov 19, 2008 | 1994 Toyota Camry

1 Answer

Side view mirror assembly

Just looked at the same handle, I drive a '93 Camry...

Look at the handle. See the orange thing on the lock button?
Right above it, insert a flat screwdriver, and pry it down & out just a bit, this will defeat the lock tab
Do the same below the lock button, under the pull handle pivot. Pry up a bit. That whole side will be loose.
Once the 2 tabs are loose, pull it forward and out. Easy. Just don't pry too hard.

Nov 18, 2008 | 1994 Toyota Camry

1 Answer

Camry door panel PDF file

You are quite welcome. This is what FixYa is all about. Helping people such as yourself. Back in the day, I had a Corolla with a 2TC, 240,000 miles and still counting. Great cars. Please feel free to post back/post a question to me whenever you need my services again. Proud to be able to assit you. Thnaks for the FixYa.

Nov 18, 2008 | 1994 Toyota Camry

1 Answer

Need to install power mirror - driver side 1994 toyota camry xle

take the screws out, pop off the panel, disconnect the wire connectors, make sure you dont lose the screws.

to put the panel back on: reconnect the wire connectors, put panel back on track, pop panel on (hit the corners), put the screws in and tighten them.

Nov 18, 2008 | 1994 Toyota Camry

1 Answer

Power mirror assembly 1994 camry

You can ask as many questions as you want, Sir. That is what we are here for! No problem!

To answer your question, the connector for the mirror is behind the door panel, and it is difficult to unplug thru the side of the panel. I have already tried that years ago...
You could, if you want to, cut, splice and solder the wires, assuming that they are all of the same color, on both mirrors.

If you want, I can e-mail you a .pdf for the door panel removal procedure, FixYa is not set up to display .pdfs yet. Please advise.

The graciousness of FixYa ratings for this and the previous question would be greatly appreciated!

Nov 14, 2008 | 1994 Toyota Camry

1 Answer

Procedure for removing door panel on passenger side 1994 camry


Pull off the triangle thing.
On the door, at the front edge, there should be 2 plastic caps. Remove them. Under the caps there are screws. Remove them.
On the rear of the door panel, above the latch, are 2 round things, with a smaller round thing in the middle. Press on the inner round thing, and pull the pin assemblys out.
Do you have a light on the door panel at the bottom? If so, pry it out with a small screwdriver (it's just a "press-fit"), and remove the wire connector.
Under the arm-rest, remove the big phillips screw that is hidden, about an inch back from the outer edge of the panel. You will see the hole.
Under the arm rest, remove the tiny plastic trim cover, remove another big phillips screw.
Remove the door handle: Remove the phillips screw. Slide the handle forward or backward to release it from the door metal. Undo the clamp from the lock rod to the handle.
Remove any screws at the very bottom of the panel, if there are any.
Starting at the bottom of the panel. pull straight out, to defeat the plastic clamps tht holds the panel to the door metal. Once the panel is loose, pull it up a bit to remove it from the window opening retainer. Finally, inside the panel, unplug the wiring harness to the window switch assembly.

If you need any more info, please comment back. And, Thanks for the FIxYa.

Nov 14, 2008 | 1994 Toyota Camry

1 Answer

Replace the passenger powered side view mirror assemby 1994 camry

You do need to pull the door panel off, as the wire from the mirror is plugged into the door harness under the middle of the door panel. The tringular plastic panel just pulls off, start at the top. There is no difference Japan vs USA production. The mirror is held on by 3 10 mm bolts behind the triangular plastic panel.
Hope this helps. The graciousness of a FixYa rating for my solution would be greatly appreciated.

Nov 14, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
1994 Toyota Camry Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides