Blinkers do not work
SOURCE: HOW DO I REPLACE MY TURN SIGNAL LIGHTS ON 2003 HYUNDAI TIBURON
I just found out today that it is a problem for alot of 2003 tiburons that the flasher relay for the turn signals will go out causing the turn signal lights to stay on even with the car off. The relays are internal and located on the circuit board of the BCM. In order to fix you will have to remove and disassemble the bcm circuit board from it's housing and resolder a new flasher relay. Haven't figured out where to get that flasher relay though.
SOURCE: Flasher unit on Hyundai Excel 98
I recently had the same problem (Aust Excel 1998).
The panel on the right side of your steering wheel where the dash light dimmer and fog light switches are located, will lever out with a small flat bladed screwdriver. Pull it out gently and position it out of your way.
You will find the flasher can directly behind this panel (within reaching distance) - the can is the square plastic box about 2.5cm square and 4cm tall.
It will release by squeezing the two plastic retaining clips on either side (toward the bottom) and pulling outward.
I recommend you get a genuine (or as close to the manufacturers specifications as possible) replacement (around $35-$50 AUS), these are usually garaunteed and some inferrior replacements don't work (I tried one).
I also found that my original was repairable (sign of repairable was intermittent operation). If you are capable with a soldering iron, disassemble and look for cracks in the solder joints (wobble some components, especially around the bi-metalic strip) - resolder any cracked joints.
Hopefully this should get you out of trouble.
SOURCE: Location of the Purge Control Valve for 2003 Hyundai Tiburon
There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
And the 2.7 Liter V6:
SOURCE: flasher
Its the BCM. Follow these instructions for a cheaper fix.
DIY: BCM Turn Signal Fix - NewTiburon.com
706 views
Usually answered in minutes!
×