Question about 2000 Chrysler Sebring

2 Answers

Approx how much to replace the timing bell on 2000 chrysler 300m?

Car didn't want to turn on..after a few minutes it turned on. When I got on the freeway, with 2 minutes or so, my car just turned off. I took it to the repair shop. AFter a few days of inspection, I was told it was the timing belt, that quite a few teeth were missing. The cost to repair was $350.00. Is this a fair price?

Posted by on

  • Anonymous Jan 21, 2009

    I have a 2000 300m and to replace the timing belt, water pump(always replace when you already have it off), serpentine belt and serpentine idler is going to run me $900.00. I live in Peoria, IL. Dealer here are proud of the work they do.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

HI there. My water pump just went out on my 2004 300M with 85000 miles. My cost was about $400 to replace the water pump and timing belt.
I recommend replacing the water pump at the same time since you have to take the timing belt off to change the water pump.
$350 is a good price. The dealer will charge you double that.

Posted on Nov 25, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I live in el cajon, ca. i purchased a 2000 sebring convertible. It has been well taken care of. I want to do preventitive maintenance, by replacing the timing belt before it breaks.
i am limited in funds, as is everyone else. What are you ideas.
thanks
charly

Posted on Nov 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I don't know how to turn the cruise control on in my 2002 Chrysler 2000 300M


All you gotta do is hit the on button on your steering wheel then accelerate to any speed above 35 mph. Once there you press set and the cruise control takes over.

Aug 01, 2012 | 2002 Chrysler 300M

1 Answer

My 2000 Chrysler 300M misses around 2000rpm it feels like the transmission slips but i know its not that. I was told it was the coil packs but theyre expensive and id like to know for sure before i...


You didn't give any info about how many miles are on this car. When was the last time the spark plugs were changed. I would think that if a coil was bad it would act up at all speeds not just over 2000 rpm. I would definately change plugs first, unless you just changed them, then go after the coil packs, fuel injectors, etc. Are you getting a check engine light?

Jan 02, 2012 | 2000 Chrysler 300M

1 Answer

Where is crank shaft sensor in a 2000 crysler 300m


The crank sensor is actually on the bell housing. Right side, about midway down...about at horizontal. One plug, one bolt. When you replace it with a new one, make SURE to leave the paper piece on the business end of the sensor when you bolt it in. That protects the sensor from damage on the first turns of the reluctor wheel (the ones with the timing holes in it) that is attached to the flex plate. Take out the 10mm bolt. Then you may have some corrosion on it, so be firm and twist it clockwise and counterclockwise as you loosen it to take it out. Chrysler also has a funky locking system on electrical connections... either a red or green lock runs through the connector and must be pulled out, kinda like a paperclip before the plug can be released from the sensor. Otherwise an ABC removal and installation.
Good luck and keep the greasy side down.

Nov 18, 2011 | 2000 Chrysler 300M

1 Answer

Car turns off while its being droven


COULD BE FAULTY IDLE AIR CONTROL WATER IN GAS STOPPED UP FUEL FILTER.FAULT IN THE PCM OR FAULT IN ALTERNATOR. BEST TO HAVE VECHICLE SCAN.SAVE TIME AND MONEY.MANY THINGS WILL CAUSE VECHICLE TO STALL OUT.

Jul 23, 2010 | 2000 Chrysler 300M

1 Answer

2000 Chrysler 300M won't start can it be the timing belt?


start with the battery condition...is it fully charged?

Mar 27, 2009 | 2000 Chrysler 300M

1 Answer

2000 Chrysler 300M. No start tIminig BElt???


youre probably looking at 600 to 800 dollars to have the car repaired

Feb 23, 2009 | 1999 Chrysler 300M

2 Answers

My Chrysler 300m headlights will not turn off.


you have a stuck headlight relay...replace it.

Feb 08, 2009 | 2000 Chrysler 300M

Not finding what you are looking for?
2000 Chrysler Sebring Logo

1,207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74115 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7188 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...