Question about 1998 Chevrolet S-10 Pickup

1 Answer

I was driving down the road and it just started missing.

I was driving down the road and it started missing. i have replace the plugs and wires and the crank sensor, but it is still missing.

Posted by on

  • GRADYCBROOKS Dec 05, 2008

    RUNS GOOD COLD THEN BOGS AND LURCHES

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

Probably an O2 thing. My guess is MAP sensor. Take it to A Zone and they'll put it on the code reader for free.

Posted on Dec 01, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 GMC Jimmy with a v6 vortec in it and i have a huge problem. When i bought the truck it started missing so i thought plugs and wires and oil change and its good. Well the problem isnt always...


Check fuel pressure it should be at least 52 psi if anything less replace fuel pump.If pressure is good then pull vacuum line off of the fuel pressure regulator and if fuel runs out replace regulator.

Jul 12, 2011 | GMC Jimmy Cars & Trucks

1 Answer

Driving down the road it throws a engine code and starts sputering and missing


Sounds like engine miss fire! Check to make sure your whole ignition unit is fine... examples....distributor, spark plugs, plug wires, ignition rotor, ignitoin coil...

Feb 18, 2011 | 1991 Honda Civic

1 Answer

I have a 2001 blazer that is throwing a P0306 code which to my understanding is a misfire on cylinder 6. I sprayed carburetor cleaner through a vacuum line which was suggested by a local mechanic to clean...


the only reason it stoped missfiring when idleing was cause your moter was running off the extra boost of the carb cleaner try replacing the plugs and wires before doing that again boss. and you can fid out if its a hard miss by power braking put it in drive and keep your foot on the brake then increase the gas till the car tire just starts to slip if it misses really bad u have a hard miss caused by a coil pack or really worn spark plug or bad plug wire.

Nov 29, 2010 | 2001 Chevrolet Blazer

1 Answer

Start up 1997 ford f150 4.6 liter runs rough and misses out,then oil gauge goes haywire. When it runs down then road after 10 minutes are so it then drives ok.


OK, if it is running rough, does the engine computer record any misfires on any specific cylinders? If so, then start changing parts in that area such as plug wires, plugs, and fuel inj. if this applies.

Hope this helps.

Jul 13, 2010 | 1996 Ford F150 Regular Cab

1 Answer

1988 F15 4.9L RUNS LIKE IT IS MISSING


One more thing when you check the timing did you pull the vaccum plug that will turn off vaccum. The plug is located next to the distributor looks like a dead plug with two wires running to it pull the plug spout out and recheck.

Apr 23, 2009 | 1988 Ford F 150

1 Answer

2004 Ford Ranger XLT miss fires in blowing snow


Sounds like you have a bad spark plug wire. Start the vehicle, then take a squirt bottle of water and spray around the plug wires. You should find it. It'll look like static around the bad one. Also you should get the misfire. You'll probably find a worn area on the wire. Best wishes to you.

Jan 21, 2009 | 2004 Ford Ranger

1 Answer

Car sputters


is it 4 cyl 6 cyl if it is the 2.4 quad four i would replace the plug tubes from the coils to the plugs if it is the 6 cyl i would replace the plug wires and inspect the coil towers for corrosion

Oct 17, 2008 | 1994 Chevrolet Beretta

1 Answer

1999 sunfire misses


bad ignition coil spark plug or wire start with a good tune up wire plug good look
pierre

Jun 23, 2008 | 1999 Pontiac Sunfire

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...