Question about 1995 Plymouth Voyager

1 Answer

Dash removal 95 plymouth voyager

I am trying to remove the dash on my van so I can put in a new stock stereo. I've removed all the screws but am not sure how to loosen the dash above all the gauges. Any suggestions?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 43 Answers

This is a fun one. I was going to attempt to explain, but pictures are worth a thousand words on this one! See www.carstereoremoval.com/htm/stereoremovalDodPlyVoyager94_95Str.HTM This is a temporary page, please print when accessed.

Posted on Nov 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the stereo on a 1996 mazda mpv


Mazda MPV Dash Trim Removal, Stereo Removal - Auto ...

? 3:38
https://www.youtube.com/watch?v=REoTeVM2S-o
Jul 1, 2013 - Uploaded by Robert DIY
Dash trim removal: 5 minutes. This video will show you how toremove the dash trim piece on the Mazda ...

[PDF]MAZDA 1996-UP MPV - Scosche

www.scosche.com/media/guides/ma381.pdf
164. 1996-UP MAZDA MPV. MINIVAN. RADIO REMOVAL USING SCOSCHE DT-1 TOOLS . FRONT DOOR PANEL. FRONT AND REAR DOOR 61/2" 3-HOLE.

DIY Mazda Car Radio and Speaker Removal, How to Remove

www.carstereoremoval.com/htm/stereoremovalMazda.htm
'96-99* Car Stereo Removal · Ford Stereo Removal Tools Stereo Removal Tools. How To Install and Remove Mazda MPV Van Car Radio and Speaker, '89-95*

Jan 31, 2016 | Mazda Cars & Trucks

1 Answer

How do I replace a rear wheel bearion 1 2000 Plymouth voyager


you jack the van up . remove wheel , remove the old wheel bearing and put in a new one then put wheel back on of course you have the brakes to remove and replace also.

Sep 30, 2014 | 2000 Plymouth Voyager

1 Answer

I have a 1998 Plymouth Voyager van that I changed the ignition switch and now the dash lights won't go off.


Is the headlight switch in the steering column? If so you may want to take the covers off the column if you had them off earlier and look and see if you pinched a wire or put a screw in a wire. It sounds like you my have done something when you replaced the switch

Nov 10, 2013 | 1998 Plymouth Voyager

1 Answer

1998 plymouth grand voyager cluster illumination


I would check the dash lights fuse first. If the fuse is good and the circuit has voltage, you may have toasted the dimmer control.

Aug 13, 2012 | 1998 Plymouth Grand Voyager

1 Answer

How to remove leaves from the heating system on a 1990 plymouth voyager


if your talking about the ones under the wiper cowling you will have to remove the cowling to get access to them to remove them.if your talking about the air duct work inside the car this is a big job as the air duct will have to be removed from the car and cleaned out.i`ve never seen these this bad ever as far as the duct work inside the car.to remove the cowling the wiper arms will have to be removed along with any screws that hold the cowling to the car.

Nov 12, 2011 | 1997 Plymouth Grand Voyager

2 Answers

Need to remove the alternator


Remove windshield wiper blades (mark the arm and stud to put back exact). The next two steps you might have to lower/raise the hood. Remove cover just below the windshield(each end has a phillips screw turn 90 degrees so arrow points toward center of van). Remove the 4 metal braces. Remove windshield wiper motor/linkage assembly(the whole tray comes out). Remove drive belt. Disconnect negative side of the battery. Remove alternator horizontal mounting bracket. Loosen vertical bracket bolts to get to electrical connectors. Finish removing bolts and alternator.

Jul 18, 2009 | 1994 Plymouth Grand Voyager

3 Answers

98 plymouth voyager radio wont work. comes in as static. am works fine.


First start with pulling out the radio and make sure the antenna wire is plugged in. The last owner might have had an aftermarket radio in it and when they put the factory one back, forgot a wire. To remove it remove the trim ring (two screws I think) and then the radio screws.

May 24, 2009 | 1998 Plymouth Voyager

1 Answer

How do you get to the heater blower motor on a 1987 Plymouth van?


it is located under the dash. Passenger side behind removeable panels. It is a tight squeeze. Easiest way to work on it is remove the entire dash, but it can be accessed with time and patience.

Dec 26, 2008 | 1987 Plymouth Voyager

1 Answer

Radio installation in 1983 dodge ram van


remove screws from dash face, remove dash face. two 10mm bolts hold stereo in place,remove bolts, gently pull stereo out. unplug stereo. install new stereo by reversing the directions

Oct 19, 2008 | 1983 Dodge Ram Wagon

Not finding what you are looking for?
1995 Plymouth Voyager Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...