Question about 1994 Toyota Camry

1 Answer

Procedure for removing door panel on passenger side 1994 camry

Toyota ed,
Thanks for your speedy response regarding replacing the passenger side mirror assembly. Now knowing i must remove the door panel to access the power cable can you give me some tips on how to do this. Seems to me it could be a little complicated considering all the power window switches, door locks, etc.
Regards, RonK

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

Sure.

Pull off the triangle thing.
On the door, at the front edge, there should be 2 plastic caps. Remove them. Under the caps there are screws. Remove them.
On the rear of the door panel, above the latch, are 2 round things, with a smaller round thing in the middle. Press on the inner round thing, and pull the pin assemblys out.
Do you have a light on the door panel at the bottom? If so, pry it out with a small screwdriver (it's just a "press-fit"), and remove the wire connector.
Under the arm-rest, remove the big phillips screw that is hidden, about an inch back from the outer edge of the panel. You will see the hole.
Under the arm rest, remove the tiny plastic trim cover, remove another big phillips screw.
Remove the door handle: Remove the phillips screw. Slide the handle forward or backward to release it from the door metal. Undo the clamp from the lock rod to the handle.
Remove any screws at the very bottom of the panel, if there are any.
Starting at the bottom of the panel. pull straight out, to defeat the plastic clamps tht holds the panel to the door metal. Once the panel is loose, pull it up a bit to remove it from the window opening retainer. Finally, inside the panel, unplug the wiring harness to the window switch assembly.

If you need any more info, please comment back. And, Thanks for the FIxYa.

Posted on Nov 14, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

5 Answers

How to erase toyota camry code obd 1


Hello, and welcome to FIxYa.

To erase the check engine light on a 1994 Camry, open the hood, and, in the engine compartment fuse box, remove the blue 15 amp EFI fuse for one minute. This will clear the codes. If you have a hard code; ie a malfunctioning sensor, the light will come right back on.

Thanks for choosing FixYa for assistance.

Mar 12, 2010 | 1994 Toyota Camry

2 Answers

How to replace passenger side mirror on 2007 Camry


To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.

Dec 04, 2009 | 2007 Toyota Camry

1 Answer

1994 toyota camry door speaker replacement


Does speaker have an external cover on it, on the outside of door panel? if yes, remove it and speaker porobaly has screws holding it in door. if no, just slots/smalll holes, cut in panel & speaker is concealed behind panel, then the panel will have to come off. Once you get to the speaker it's relatively easy from there.

Mar 13, 2009 | 1994 Toyota Camry

2 Answers

Replace 97 Camry passenger side mirror


If you pull off the triangular black plastic trim behind the mirror, you will see the mirror wiring. If there is no plug, you will have to pull off the door panle. .....SOME Japanese cars have the plugs, but not all of them...Americian built cars do not. They are different.

Feb 09, 2009 | 1997 Toyota Camry

1 Answer

Need to install power mirror - driver side 1994 toyota camry xle


take the screws out, pop off the panel, disconnect the wire connectors, make sure you dont lose the screws.

to put the panel back on: reconnect the wire connectors, put panel back on track, pop panel on (hit the corners), put the screws in and tighten them.

Nov 18, 2008 | 1994 Toyota Camry

1 Answer

1994 camry power mirror assembly


Sent it this morning. Please advise if you do not get it.

Nov 15, 2008 | 1994 Toyota Camry

1 Answer

Power mirror assembly 1994 camry


You can ask as many questions as you want, Sir. That is what we are here for! No problem!

To answer your question, the connector for the mirror is behind the door panel, and it is difficult to unplug thru the side of the panel. I have already tried that years ago...
You could, if you want to, cut, splice and solder the wires, assuming that they are all of the same color, on both mirrors.

If you want, I can e-mail you a .pdf for the door panel removal procedure, FixYa is not set up to display .pdfs yet. Please advise.

The graciousness of FixYa ratings for this and the previous question would be greatly appreciated!

Nov 14, 2008 | 1994 Toyota Camry

1 Answer

Replace the passenger powered side view mirror assemby 1994 camry


You do need to pull the door panel off, as the wire from the mirror is plugged into the door harness under the middle of the door panel. The tringular plastic panel just pulls off, start at the top. There is no difference Japan vs USA production. The mirror is held on by 3 10 mm bolts behind the triangular plastic panel.
Hope this helps. The graciousness of a FixYa rating for my solution would be greatly appreciated.

Nov 14, 2008 | 1994 Toyota Camry

1 Answer

1994 Camry Broken Passenger Lock Cylinder


Your best bet would to be remove the inner door panel, and remove the lock/handle assembly. Take the lock/handle to a professional locksmith; he will replace the internals of the lock to match your existing key. You cannot "buy" a lock cylinder that will match your key; it has to be assembled to match the key that you have.

Oct 15, 2008 | 1994 Toyota Camry

1 Answer

92 Toyota Camry V4


Sounds like the power lock actuator is going.On some cars it's part of the door latch and somethey are sep.. To remove door panel remove all the srews and pull out on panel. actuator is in lower corner of door. should be easy to find just use power locks and listen.

Sep 13, 2008 | 1992 Toyota Camry V6

Not finding what you are looking for?
1994 Toyota Camry Logo

580 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...