Question about 1996 Jeep Grand Cherokee

1 Answer

I have a 95 jeep grand cherokee limited 5.2 l. that will notstart

The problem has been getting worse and worse over the last few weeks. it usually would start if the key was in the ignition and turned on for awhile. when the key has been left on though it would start doing a rapid series of clicks that come from the fuel pump fuse and what looks like a small diaphragm next to the distributor. after awhile the clicking would stop and then the jeep would start right up like nothing was even wrong. what would most likely be the problem? fuel system or electrical?

Posted by on

  • yadayada
    yadayada May 11, 2010

    ID the component and get back to me, this may require a trip to the dealer parts dept.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 110 Answers

I had electrical problems on my cherokee before u start getting in to deep disconnect your battery for 1min then reconnect maybe computer at fault but doing this will reboot it

Posted on Nov 14, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 pontiac bonneville-ignition not engaging


There are a few components that could cause the problem. Bearing in mind the hard turn issue last week, I would first suspect the manual ignition switch, which is located on top of the steering column under the dash( not the key switch). All other components would not affect the hard turning issue, other than a dry ignition lock cylinder, so that's why I would first check out that mechanical switch.
I don't know your level of aptitude or what tools you have, but this is not a very difficult fix - but it will take time.
If you would like to fix this yourself, let me know and I will be happy to help walk you through the procedure.
Hope this helps!!

Dec 02, 2013 | 1999 Pontiac Bonneville

1 Answer

How do I change the starter in a 1995 Ford E250 van?


your starter is defently bad [celloinid/starter moter. starter is located where your trainsmiton meets your motor .usuly 2/3 bolts &wirers

Dec 31, 2011 | 1995 Ford Econoline

1 Answer

I have a 2006 Jeep Grand Cherokee Limited with a 5.7L Hemi. I have had a starting issue I turn the key - nothing Turn the key a few more times the engine cranks and starts. It was doing this last spring...


is the engine grounded to the body? if so, you may have a key issue that's only going to get worse. your key is coded, black square ignition key right? $75.00 dealer only. sorry but it sounds like that's your problem. almost like a valet key. only works for short time and if you keep using it, it will blow the fuel pump$379.00 please do more research! hope this helps,and merry christmas from me and mine,to you and yours.

Dec 26, 2010 | 2006 Jeep Grand Cherokee

1 Answer

Car dies while driving, now it won't start sometimes


Could be a fuel pump that is going bad. Some times when fuel pumps go bad they cavitate and pump not just gas but also air. If you get too much air in the line and not enough gas the car won't start. Have a mechanic check your fuel line pressure.

Aug 04, 2009 | 1998 Honda Accord

1 Answer

Turn the key but nothing happens all electrics


Not all replacement parts are good. I would guess that the new ignition switch is bad. Its also possible that the wiring harness is loose where its connected to the ignition switch. You could try jiggling the wires.

Jun 27, 2009 | 2006 Chrysler PT Cruiser

1 Answer

Key won't come out of ignition - won't turn completely off


Ignition switch (where key actually goes in) needs replaced. May be easier to get the whole column because that's not gonna be very simple. Also for the problem of getting nothing when you turn the key all the way over, that is the contacts within the box of the switch down the harness on the column. Not an impossible fix though. Contacts usually get burnt and give you dead spot once in awhile, will get worse, believe me.

Apr 09, 2009 | 1994 Pontiac Grand Prix

1 Answer

Sometimes will not shift out of Park


I have the same issue. As far as I can tell it's probably the ignition switch and or/ ignition lock assembly. Parts only you can find the switch for $65. If you replace the ignition lock assembly you should have it ordered for your car by VIN # to get a matching key.

Apr 07, 2009 | 1997 Volvo S90

2 Answers

2000 Buick Custom - no response on inital start


that sounds like its the ignitionswitch is going bad on the car or its the ignition its self. it could also be a loose wire going to your starter.

Mar 24, 2009 | 2004 Buick LeSabre

1 Answer

My td5 disco has intermittant starting problems


need a new ignition switch on the back of the steering lock

Feb 02, 2009 | 1997 Land Rover Discovery

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...