Question about 1999 Isuzu Amigo

1 Answer

Trying to remove the starter on a 1999 isuzu amigo v6

Do i have to remove other parts to get the starter out?

Posted by on

  • prophyball Nov 19, 2008

    We have a 99 4WD V6 Amigo and lately it will start a couple of times and then it will just click the solenoid and not start, like the battery is dead. Put the charger on it and the battery draws hardly any amps.



    The dealership says the exhaust has to be replaced in one section to do the starter on a 4WD. Do you know if your wheel removal method will work for us too?

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 261 Answers

Not nesessary if you can acces the starter from the wheel well all yo have to do is remove the front wheel and yo can move the dust cover and the starter is right in fornt of you easy accesss!!!

Posted on Nov 14, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a 1999 isuzu rodeo sport 2wd v6 auto trans idle air replacement valve interchangeable with a 1999 isuzu amigo sport


double posted why, ? please add to 1 post,
by edits or comments, please'
there are 3 , v6 engines, you never said which
why ask us, about parts, we dont sell parts
and would have to read the same books on parts as you
why ask use to do that.?
here is the list
USA only, RODEO, prime examples. the GAS v6 engines. 3.1L 3.2L 6vd1 SOHC, one cam per head, then the optional... 6vd1w DOHC, 2 cams in one head, w = DOHC optioned heads, then came... 3.5L (a stroked out, 3.2L.) 6ve1 are all DOHC engines. and have 24 valves. (6x4) with 2 rear cam sensor, used for VVT and spark both,
the engines must match ,to mix parts

here im at isuzu.com parts page
note it changed on August 99, mfg build dates. so.....
tricky
this will not cause low MPG
it will cause idle controls to be dead.
why not post all symptoms, first. and stop guessing?

iac-oxkqb5rw1cdtny1acrjczugf-5-0.png

Feb 12, 2017 | 1999 Isuzu Amigo

Tip

How to Replace a Starter in car?


The procedure is as follows:--
1)First of all turn off the car and disconnect the battery. Then lift the car with a jack . 2)Then place jack stands under the frame of the car. The rear wheels in the car should be blocked so the car donot roll or move backwards. 3)Then locate the starter in the car.Beside the starter you will see some wires.Remove the wires connected to it.Before removing the wires please not down the order in which the wires are actually connected. 4)To remove the starter out you will have to remove the bolts holding it. 5)After you remove the bolts you will have to Pull the starter out of its position to remove it from the car. 6)There are some others parts which will have to be removed before the starter comes out.so before removing that parts please take a note there where they parts exact connect in the car. 7) The old starter is out now.Put the new starter in the car by installing it the same way the old starter was removed. this will help.Good luck.



on Mar 14, 2010 | Audi AllRoad Cars & Trucks

1 Answer

2005 bmw x3 3.0l automatic. Swapped out starter from underneath. Removed drive line from frt of tr/case, removed t/cs crossmember.


BMW X3 Starter - PartsGeek.com

www.partsgeek.com > Starter > BMW Starter > X3 Parts
BMW X3 Replacement Starter Information. Read Reviews for ... Search our onlinestarter catalog and find the lowest priced discount auto parts on the web. We sell wholesale ... They are available for the following BMW X3 years: 2006, 2005, 2004, 06, 05, 04. This part is also ... 07 2007 BMW X3 Starter 3.0L 6 Cyl N52 Bosch.

Jul 25, 2015 | BMW Cars & Trucks

2 Answers

Repplacing Starter


Don't buy a starter from Amazon. Go to an auto parts store with your old starter.

Nov 21, 2017 | 1994 Acura Vigor

1 Answer

How do you convert an automatic transmision to a manual on a 99 amigo


I think you should have done more research before you started this project. The clutch wires you cant find may not exist on your Isuzu. Also the starter wont work without a signal from the clutch interlock switch. These probably also dont exist.

Sep 10, 2012 | 1998 Isuzu Amigo

1 Answer

Instructions to replace thermostat in 1999 isuzu amigo v6


if you have the 3.5 v6 izuzu engine the thermostat is a major job, requires removing upper intake ,because it is under not in front of like most thermostats.
about 3-4 hour job depending what kind of problems you run into.

Feb 16, 2012 | 1999 Isuzu Rodeo

1 Answer

Removal and installation of starter of 2002 mercury mountainer


Here's the generic starter replacement directions.
Engine should be cool, parked on level surface. Remove negative cable from battery. Remove electrical connections at starter (Sometimes starter may need to be partially removed to access all electrical connections.) Remove any brackets, parts, or accessories that obstruct access to the starter motor mounting bolts. Remove mounting bolts and remove starter. Clean the mounting surface, and install new starter and tighten the mount bolts evenly. Replace wires on starter. Connect battery.
Good luck.

Nov 20, 2011 | 2002 Mercury Mountaineer

1 Answer

How do you remove and replace a starter for a 1992 2.6L Isuzu Amigo?


1.The battery negative and more importantly positive cable must be disconnected.
2. There are 2 14mm bolts holding the starter in place, the upper bolt can be removed by leaning over into the engine compartment from under the hood with a socket and extension on a ratchet or a ratcheting wrench.
3. crawl under the front passenger wheel and remove the positive cable nut, remove positive cable from starter.
4. unclip the small ground wire attached to starter.
5. remove the lower starter bolt.
6. There is room on the bottom of the vehicle to wiggle the starter down to the floor and out from under the vehicle. There isn't enough room to get the starter out from the engine compartment up and out from under the hood.
7. installation of new starter is reverse of installation.

This procedure should work on any Isuzu Rodeo, Trooper, Amigo, or Honda Passport with a 2.6L 4 cylinder 4ZE1 engine

Nov 12, 2010 | 1992 Isuzu Amigo

1 Answer

How to replace starter?


Turn the car off and disconnect the battery. Lift the car with a jack and place jack stands under the frame of the car. Block the rear wheels to prevent the car from rolling backwards.

Locate the starter and remove the wires connected to it. Mark them so you know which is positive and which is negative so you can reconnect them accordingly.

Remove the bolts holding the starter in place. There are usually two or three bolts holding the starter.

Pull the starter out of its position and remove it from the car. Some other parts may need to be loosened or removed for the starter to be removed from the car. Remember what parts are removed or loosened.

Put the new starter in the car by installing it the same way the old starter was removed. Tighten the bolts slightly, connect the wires to the starter and then tighten the bolts completely.

Replace any other parts in the car that were removed or loosened. Lower the car from the jack stands, remove the blocks from the rear wheels and reconnect the battery. Start the car to make sure everything is working properly.

Oct 09, 2010 | 2000 Toyota Camry

2 Answers

1999 Isuzu Amigo V6 2wd: Car doesn't start always. Turn the key, lights come on, radio on, etc, but no clicking noise, no engine trying to turn over, absolutely nothing. I put in a new battery, but same...


When I have such a problem with my Toyota pickup, I install a button in dash to crank the motor over. Hot wire from the switch on to the button, then from the button to the starter activating wire. My Toy doesn't do this every time, but when it won't crank I just reach down and flip the spring center switch, same as a button, and she cranks and fires up. This is easier than replacing a bunch of stuff that may not be bad or is impossible to get to.

May 26, 2017 | 1999 Isuzu Amigo

Not finding what you are looking for?
1999 Isuzu Amigo Logo

Related Topics:

846 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...