Question about 2003 Chevrolet Blazer

1 Answer

4 high not working

Not going in or out seems like its in between sounds something like a match book on a spoke

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Sounds like the transfer case has gone bad and needs to be rebuilt. if it is a newer style blazer (late 90's or newer) with the push button transfer case it could be the motor that shifts the transfer case is bad or not install right.

Posted on Dec 27, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1966 ford fairlane that I put a 1990 5.0 ford fuel injected motor in, what is the wright way to run the fuel system ? It keeps running gas out the vent tube,is there a certain way to vent the

You may need a different fuel tank to match the motor. You are going from a 1966 with no evaporator canister to a later model which has emissions. There surely is a way to do it. You should replace 1966 rubber fuel hoses because of corrosive fuel and high pressure compared to stock 1966 fuel pump.

You might find something you need at Carpenter restorations and they publish parts books.

Sep 22, 2017 | Ford Cars & Trucks

1 Answer

Heater core hot but not in cabin

the damper at the core must be open,
so the rules are" (heat exchangers) 101
1: hot engine, yes.
2: hot core, yes. (water must flow and both tubes hot to core)
3: air flow through core, not. (fix cause, if blower is running on high
then the damper is closed.
do you need a drawing? the FSM covers that , all cars, factory service manual even shows every step, in diagnosis.
1990 is a toyota corolla. so books on that car , match too.. hint?

they make 2 kinds if 1990
one with cable damper (temp)
and with water valve. got valve>y/n, no then its damper
this is a cable car, so the cable must move the valve or the damper
open fully to get hot air

valve below. (1990 corolla book)

using 2 persons, make sure the valve works
and is not clogged inside. it.


Feb 18, 2015 | 1990 Geo Prizm

1 Answer

Have a 91 Ford Explorer. Front headlights having issues. Good bulbs I believe. Sometimes when switching between high and low beams on the column, lights would go oput for a moment then back on....

Sounds like it has possibly got a defective multifunction switch,which is part of the turnsignal lever/high beam lever switch. Aside from physically diagnosing the circuit I would say replacing the multifunction switch may take care of your problem.

Hope this helps

Oct 23, 2013 | Ford Explorer Cars & Trucks

1 Answer

Losing power on LPG. Seems to run fine for a little while then loses power and stalls, especially when the revs go high. Just bought the van (berlingo) and don't really know much about LPG conversions but...

Wiring, schematic, electrical diagrams, fuse diag, error codes, torque settings etc are basic contents of these online books they have here on this website I have attached. Must check it out

Feb 28, 2018 | Citroen Berlingo Cars & Trucks

2 Answers

Old school ways were when without a feeler guage the thickness of a match book would work if you knew the similarity what is the thickness of a match book cover oldschool in (mm)or(inch)

Most spark plugs are definitely preset for gap clearance. If you don't alter gap setting, factory plugs are ready from box to install.

Sep 28, 2013 | 1993 Toyota Tercel

1 Answer

I own a 2007 Jaguar x type 2.5 litre petrol estate. I have damaged a wheel and wish to replace it. There seem to be a baffling array of potential makes and models. The only distinguishing features on the...

Hello Frank Hunter...

You can go directly to the DEALER... ask them
to go through their "PARTS" listings...
(they ask for a truck-load of money...
(IF they will help)... You will need a BUNCH of money.

But when they (Dlrs) are in trouble... THEY WILL go
WOODS WHEELS in Southern California...

I have only ever seen them in the CLUB
publications... and not paid much attention...

Incredibly EBAY is also an outstanding source...!!

Check out your rim in the two ROCKAUTO listings below...
Fours 17" choices

More Information for KEYSTONE ALY59790U,2007,x-type,3.0l+v6,1434532,wheel,wheel,7644

Also check AMAZON... (see bottom of THEIR page
for their sources... BE SURE TO USE OEM
"FACTORY" when searching.

There are MANY CLUB sites and forums...

Hope this helps

59790 Factory OEM Reconditioned wheel 17 7 Sparkle Silver Full Face...

Mar 16, 2017 | Jaguar X-Type Cars & Trucks

1 Answer

Contact point gap of ford laser 1983

where I come from - we always used a match book cover to set the gap on the points and then used a dwell meter while the car was running.
the match book cover sounds a little ' back yard ' I know but it works every time.


Dec 31, 2010 | Ford Laser Cars & Trucks

1 Answer

4 high not working


Dec 29, 2008 | 1995 Chevrolet Blazer

Not finding what you are looking for?
2003 Chevrolet Blazer Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides