Question about 1992 Toyota Land Cruiser

Open Question

Water reducing in Radiator

My Toyota Prando 1997 model radiator is reducing water about one liter per 100kilometer. the hose pipe changed but still same. Can uyou suggfest what is problem?

Posted by on

  • Abdi Jama May 11, 2010

    how long you had this problem means to adding water.

    ather side how is engine temperature from gauge.



6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 330 Answers

SOURCE: overheating

1. start the engine and leave the radiator cap open.
2. put a cardboard cover or a rug in the front of you radiator.
3. let it runs 20 minutes or more, see if it is overheated and see the water or coolant in the radiator circulated or not. If not, as soon as you have already changed water pump. thermostate and check the hoses, no leak, I think your radiator was blocked.

Did you put stop leak before?

Posted on Jul 07, 2008

  • 359 Answers

SOURCE: removal of 1993 toyota landcruiser radiator

I couldn't find any diagram on the internet for you, but you can call your local auto part stores for a Haynes Manual for your vehicle, or you can go to this link, I found a repair manual for you on ebay
I hope all works out.

Posted on Feb 22, 2009

  • 478 Answers

SOURCE: How difficult to replace Toyota Corolla '95

Its under where the top hose goes into engine, It is pretty easymake sure to get some forma gasket when putting back together

Posted on Mar 14, 2009

  • 2984 Answers

SOURCE: How difficult to replace 1995 Toyota Corolla radiator/thermostat

You can replace the radiator yourself, but why do you need to? The thermostat is on the engine. Follow the large hose that goes to the engine block....not the water pump. The thermostat is under that or sits on the top of the engine....looking for a pic for you!

Posted on Mar 14, 2009

  • 583 Answers

SOURCE: Toyota 2ct diesel turbo in 4x4 Townace van 1991

it is the head gasket blown from the cyl to the water jacket ,a radiator specialist can test for combustion gases in the water to confirm this ,but that is what it is . "youdoit"

Posted on Oct 25, 2009

Testimonial: "compression test ok still looking"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where can I get the main water pipe for opel corsa 1.7d old shaped,the one from the block to radiator and to the radiator water container with a reduced pipe

try the spares department for your vehicle. try auto spares shops . try on line or e-bay. try the local wreckers as they have good hoses from wrecks.

Feb 09, 2015 | Opel Cars & Trucks

3 Answers

My radiator is lossing water and no sign of leakage

great question, a nice symptoms posted.!!!! and car !
The water, (coolant) can only go 3 places.
1: on the ground, (or at passenger toes, look there)
2: into the inside of the engine (see engine oil turn to milk chocolate shake?
3: in the the A/T tranny pan, same thing same milk.
4: out the exhaust, pipe end point, see steam there ALL THE TIME?

this is short term loss.
long term is normal this is evaporation.
here are the tests.

1: no steam ,tail
2: no carbon or oil in rad neck (cold)
3: milk in pans. per above.
4: rad neck tester (green/blue) chem test unit finds exh. gasses in the rad.
5: same place, RAD leak down tester.
6: compression test. all cyl.
7: cylinder leak down tester can even show me here it leaks (ASK, this is advanced testing methods but easy to do)

Jun 25, 2014 | 1998 Toyota Camry

2 Answers

Radiator fan not working unless ect switch is unplugged, also lower rad hose cool to the touch

Do you have a bleed valve on or around radiator / radiator pipes.
if yes the undo the valve and leave the car running till it bleed.
once its bleed, you will have full circulation of the water and both pipes will heat up also the fan will come on.

If no bleed valve then undo the water bottle or metal cap.
start the car up and leave it running till the fan kicks in. it will only kick in when the system is bled and no more air in the system.

Aug 12, 2017 | 1997 Toyota Corolla

2 Answers

New radiator (correct for that model) has extra copper pipes at bottom

The extra pipes are intended for connection to a transmission fluid cooler in a trailer towing application. The replacement part is multi-purpose

Jan 27, 2013 | Cars & Trucks

1 Answer

Hi, Coolent puddle was formed under the bonnet after driving for straight 70kms. Overflow bottle was full and noises of boiling could be heard.Dont know what the problem is. Thanks


Dec 25, 2010 | 1997 Toyota Camry

2 Answers

Where is the thermostate located

The thermostat will be located either at the upper radiator hose inlet to the engine, or it will be located at the lower radiator hose inlet to the engine.

Remember that the spring end of the thermostat should always go towards the engine, and not towards the hose.

Also with a lower mounted thermostat, when it comes time to add coolant you should dis-connect the upper radiator hose at the radiator and fill the engine through the radiator hose, if you do not then there will be very little coolant in the engine block until the thermostat opens up, and by then your engine could be toast.

Apr 30, 2010 | 1997 Toyota Avalon

1 Answer

2.2 liter engine, getting hot. change tstat, same. pulled water pump. impeller looks good. This is on a 97 cavalier.

I would start your car when it is cold and feel the upper radiator hose. When the car starts to warm up the thermostat you have installed will open up and you will feel the water flow past where you are squeezing the hose and the hose will become very hot. This will tell you if you thermostat is opening and installed correctly and if you water pump is working.

If your radiator cap is not working properly the system isn't sealed and this can cause the coolant to boil over and your car to overheat. Might want to repalce that they are cheap.

I would also pull the radiator cap while the car is running and look at the coolant, does it appear to be flowing smoothly thru the radiator. Have a helper rev up the motor while you look at the coolant in the radiator. When they rev it up do you see a lot of cavitation in the radiator (bubbles). If so this is an indication of a leaking head gasket. Observe the tail pipe for white smoke to aid in this diagnosis. Just because neither of this two conditions are present doesnt mean you don't have a leaking head gasket, I would also get a head gasket combustion kit from NAPA it will tell you if there is comnbustion in the coolant.

Finanally are all of your cooling fans working properly?

Apr 08, 2010 | 1997 Chevrolet Cavalier

1 Answer

WHERE THE WATER PUMP IS LOCATED on a 2.3 liter 4 cylinder quad hoc

it is driven off the timing chain, here is how you replace it
2.3L And 2.4L OHC Engines
  • Disconnect the oxygen sensor harness connector
  • Raise the vehicle and support it securely on jackstands
  • Remove the exhaust manifold brace and loosen the exhaust manifold bolts
  • Remove the radiator outlet pipe assembly to the water pump housing bolts and separate the assembly from the engine
  • Remove the exhaust manifold pipe from the exhaust manifold
  • Remove the radiator outlet pipe from the oil pan.On manual transaxles cars remove the exhaust manifold brace and keep the radiator inlet hose attached to the assembly.Pull down on the radiator outlet pipe in order to disengage the pipe from the water pump while leaving the radiator outlet pipe hanging
  • Lower the car remove the brake booster vacuum hose from the camshaft housing also remove the exhaust manifold from the cylinder head
  • Remove the timing chain cover from the engine
  • Remove the timing chain tensioner
  • Remove the water pump cover bolts from the engine block and the timing chain housing
  • Remove the water pump bolts and separate the assembly from the housing

Dec 01, 2009 | 1994 Pontiac Grand Am

1 Answer

Where is the thermastat on a 1997 t100 4x4

1997 Toyota Truck T100 Pickup 4WD 3.4L EFI DOHC 6cyl
For all Toyota engines on this model, the thermostat is located under the upper radiator hose water inlet connection.


After removing the nuts, you can pull the water inlet off of the studs...


then remove the thermostat from the housing.

Hope helped wiht this (remember rated this help) Good luck.

Nov 19, 2009 | 1997 Toyota T100

2 Answers

Cooling system requires burp.

A large air pocket can sometimes be tricky to get rid of. The easiest way is to jack the front end up in the air with the wheels off the ground and support with jack stands, remove the radiator cap(make sure engine is cool) and allow to sit over night in this condition. The elevated front end will allow the air pocket to move to the most highest point and then escaping out the top of the radiator, after doing this procedure make sure to inspect coolant level in radiator and overflow reservoir and top off as needed.

Apr 07, 2009 | 1997 Dodge Ram

Not finding what you are looking for?
1992 Toyota Land Cruiser Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8830 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides