Question about 2000 Toyota Celica

Open Question

Instrument cluster suddenly not working on 2000 celica

Speedometer, tach, gas gauge, shift indicator stopped lighting up in dash and cchime beeps in reverse. I'm told possible instrument cluster must be fixed or replaced. Any help suggestions?

Posted by on

6 Suggested Answers

shaggyrat
  • 1224 Answers

SOURCE: Instrument cluster failure causes fuse #29 to blow.

ok it could be quite simple
lets look at wrong size fuse
example 15 and you need a 25 fuse
also if you did any work on vehicle its quite possible that you grounded something out wrong retrace your work and fix accordingly
bad cluster relay is another problem that would cause these problems

Posted on Jun 10, 2008

  • 1 Answer

SOURCE: Speedometer and Tach guages stop working at the same time

Its your odemeter cable its run out of luburcation and its getting hung up. Reluburcate the cable

Posted on Nov 18, 2008

  • 42 Answers

SOURCE: 2000 toyota camry check engine

wires are pinched and shorting together near the left (drivers side) trunk hinge. brake light power is feeding back through the reverse light wiring. this will also turn on the check engine light with a neutral safety switch malfunction code as the computer also sees this voltage in the reverse light circuit. Find and repair the wiring, pull the EFI fuse in the panel under the hood to clear the code. Hope this helps

Posted on Dec 28, 2008

  • 3 Answers

SOURCE: electrical ?

probally need to check engine groundwires. clean all terminals. battery may have loose terminal.

Posted on Jan 16, 2009

  • 1 Answer

SOURCE: Toyota Hilux rev gauge,radio,windscreen wipers,oil gauge stopped

check fuses first

Posted on Feb 19, 2009

  • 48 Answers

SOURCE: 2000 Chrysler Voyager Instrument Cluster is dead

have you got a dimmer switch on your model to dim the dash lights. if you have it may be faulty. link the cables together if the lights work the switch is faulty. if you have not got a dimmer switch
your printed circuit on the back of the dash may be faulty or the plug in the back of the dash is not pushed all the way in. hope this helps

Posted on Apr 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have two questions, first my speedometer won't light up, and my high beems won't stay on. And when I put them on it knocks out the headlights. Please help


18538624 Indicators and high beam lights on dash cluster ...

surf.dev.kinday.ru/.../t18538624-indicators_high_beam_lights_dash_clu...
18538624 indicators and high beam lights on dash cluster turn on and wont turn off. ...The high beam indicator light stay on my dash, I have a 2002 HD night train. ... wontwork and the blue indicator light wont light up when the switch is turned to high beams.. the lights ... remove install instrument cluster speedometer cable.

Cluster/Gauge lights out, highbeams dont work, no fuses ...

www.rx7club.com/.../cluster-gauge-lights-out-highbeams-dont-work-no-...
Feb 17, 2012 - My gauge lights decided to go out one night and I can't find any reason why. ... are on works on my dashboard but the lights behind the gauges don't (speedometer/rpms/gas/temp) and my highbeams wont work. .... My foglights stay onwith the headlights. ... If that's the case someone hacked up some wiring.

Oct 24, 2015 | Cars & Trucks

1 Answer

Instrument cluster does not work.


Best practice is to leave pinpoint testing of the instrument cluster & (Delicate) P/C board to an expert .....

May 28, 2015 | 2001 Acura MDX

1 Answer

All my gauges quit on my 2003 silverado the dash lights still work but none of the gauges move


Hi, this is a pretty common problem on these Silverado instrument clusters. We can definitely help you out with that. Click here to learn more about these Silverado instrument cluster problems: Dr Speedometer Instrument Cluster Repair Speedometer Repair Guage...

Jan 09, 2014 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Speedometer,tach, fuel and temp gauges not working.


Common problem You need to take dash apart, remove the whole instrument cluster and send it away for repair...... Search instrument cluster repair on ebay ,

Sep 19, 2013 | 2003 Buick Rendezvous

1 Answer

Tranmission and instrument cluster


The speed sensor on your trans sends a signal to the electronics telling it when to shift, this will be where you fault is.

Mar 05, 2012 | 2001 GMC Yukon XL

2 Answers

I HAVE A 1999 CARAVAN THE INSTRUMENT CLUSTER GAUGES ARE NOT WORKING. IT USED TO WORK ON AND OFF. WHEN I START IN THE MORNING THE GUAGES & SPEEDOMETER & THE GEAR SHIIFT POSITION INDICATOR WORK...


Yes you are ru=ight about cold solder joints. as you might be handy working on cars youcan try to fix it yourself, But if your not handy with tools andintricate things you best leave this work to those that are. Remove the instrument cluster, leavingthe wiresconnected. turn the key on and push on the electrtrical connecteras you watch the gauges that are/nt working. If the serial bus weren't makig a connection then the check engine light would beon, or is it? Wigh the key off disconnect the electrical connector and the pins that plug in I scrach them by pulling lightly on the with treaded needle nosed pliers slipping off till they are all a little ruoghted up. Reconnect and try again. Sometimes afterhavingthe cluster disconnected ou may needto disconnect the battery sothe ECM will look for the cluster again. This is a common problem but ther's many varaitions of reconnecting including using a true scanner to cycle the gauges in an output test.

Oct 24, 2010 | 2001 Dodge Grand Caravan

2 Answers

2001 dodge grand caravan sport no dash lights speedometer tach gas guage 4 ways


  1. do the park lamps work?
  2. dash lamp fuse burnt?
  3. is the instrument cluster analog or digital?
  4. digital clusters have been known to fail however the cluster lighting is controlled by a body computer.
  5. proper diagnosis with require a scan tool that will access the body module ( computer)

Jul 05, 2010 | 1994 Honda Accord

1 Answer

Tac dont work. tranmissionwant shift unless you let off of gas


The connector on the back of the gauge cluster isn't making a good connection. If the speed senser is bad the speedometer won't work either or the fuse the speedometer won't work but if the speedometer does work the trans controller or the shift switch ( park neuurtal drive ) could bemaking abad connection or be full of tans fluild or water (frozen?) The tach not working may indicate a fuse or connection problem to the cluster ( speedometer gauge unit and the computer doesn't know how fast the motor is going) The check engine light should be on in this case and checking for codes and following the repair recomedations for them should find the problem

Feb 18, 2010 | 1995 Nissan Pathfinder

1 Answer

None of the instruments in the cluster work (Gas gauge, speedomot


It is possible that the connector came off the back of the circuit board behind the speedometer. Do the lights work IN the speedometer and gauges? Could also be that the ground wire loosened up under the dash, usually on the drivers side. Just some suggestions that I thought might help. Best wishes to you.

Jan 19, 2009 | 2000 Buick Century

1 Answer

Electrical ?


probally need to check engine groundwires. clean all terminals. battery may have loose terminal.

Jan 14, 2009 | 1999 GMC Sierra

Not finding what you are looking for?
2000 Toyota Celica Logo

Related Topics:

372 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...