Question about 2002 Honda CR-V

1 Answer

Gas gauge would not move and car started very rough.

The gas gauge did not move from empty and the crv would not start at first but finally did and seems to run o.k. When the crv started the gas gauge finally went to the proper position.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 61,180 Answers

This sounds like a ground problem to the fuel pump and gas guage sender, they share a common ground connection.

Posted on Nov 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Town and Country Van running out of gas and guage says half a tank what could be the problem?


If your fuel gauge is showing you in accurate readings this is normal to all vehicles that are not used to fill-up gas full regularly but sometimes the cause of the inacuracy is due to faulty float valve in the gas tank you need to replace it

May 09, 2014 | 2005 Chrysler Town & Country

1 Answer

How do you get the gauges on the dashboard to work


Well the first thing i can say is that these clusters do have a bad failure rate , they do go often ,but lets start with the basics first. check the fuses all of them, there is a cluster fuse and i think it is labeled gauges, start with that first.

Nov 17, 2012 | 1998 Chrysler Town & Country

1 Answer

If my gas gauge doesnt work can it just be a fuse


Doubt it.
The same fuse for the gauge would handle the rest of the cluster.
Probably the sending unit in the tank.

Jun 28, 2012 | 2006 Jeep Grand Cherokee

1 Answer

1995 Firebird After Running Low on Gas


You have most likely sucked residue in the bottom of the fuel tank into your fuel filter, This can cause it to get blocked, Try fitting a replacement fuel filter as it's most likely it's never been changed anyway.

Mar 10, 2012 | 1995 Pontiac Firebird

3 Answers

Gas gauge is not reading correctly. Shows a full


the problem is caused by a defective gas gauge sending unit, this part is located inside the gas tank, you must remove the gas tank to replace it.

Dec 02, 2009 | 2002 Cadillac Deville

1 Answer

Gas gauge shows empty after filling gas tank. Eventually the gas gauge will register the proper level.


The gauge circuit is shunted on most cars, this is wierd, but needed to stabilize the readings... Your description sounds like normal function. Drivers would complain if the qauge were to be instant, going around corners, starting, stopping, all move fuel, and the gauge would indicate this, cauing driver alarm...Been this way for ever, although yours sounds like it is on the far side of the scale...if it reads correctly after a while, you could replace everything and you would have the same performance.

Sep 05, 2009 | 2005 Buick Terraza

1 Answer

Gas gauge/tank


I am very familiar with this problem, u will need to replace the gas gauge sending unit in the fuel tank.

Jun 17, 2009 | 1996 Ford Ranger SuperCab

1 Answer

Fuel gauge showing empty


open circuit in the fuel level sensor. mounted in tank. as the fuel level in the tank starts to drop the arm will move past the dead spot on the sensor and the gauge will start reading again.i dont recommend diy replacement of the fuel level sender.

Dec 12, 2008 | 1995 Cadillac DeVille

Not finding what you are looking for?
2002 Honda CR-V Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...