Question about 2006 Ford Mustang

1 Answer

Boost a pump

Can you please show me(or tell) where the vacuum preasure switch coming from my BAP goes to on my 06 procharged v8 mustang

Posted by on

  • yadayada
    yadayada May 11, 2010

    Is this factory?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

I just shorted the leads together on mine so it runs full time. Saves you a wiring run up to the front of the car too.

Posted on Dec 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil pump been replaced, knock senser and oil sending unit. oil light comes on and load ticking ,when its cold started on my 98 nissan altima


Go back to where you got the work done if you can.If not then i would get the oil preasure checked as the low light tells me the preasure is below 8 psi and the ticking is from the lash adjustors at the tappets verifys low preasure too.

Nov 27, 2012 | 1998 Nissan Altima

1 Answer

06 mustang water leaking problem


At the base of the windshield, there is an opening for air to come in for your A/C and heater. The seals around this could be bad, allowing water to come through into the cabin of the car.

Jun 19, 2012 | Ford Mustang Cars & Trucks

1 Answer

2001 mustang will turn over but not start. Fuel pump not coming on. If I boost it off it will start , New battery doesn't help.


a repair manual will show relay--the plug into the pump cud be dirty and corroded-pullit and cleanit

Dec 02, 2011 | 2001 Ford Mustang

1 Answer

My 06 6L diesel has no power, and gets about 15mpg empty. It only has 17000 miles. No codes come up on the computer. Boost at 22lbs. Whats up?


REPLACE AIR FILTER.STOPPED UP AIR FILTER FILL EFFECT TURBO CHARGE PERFORMANCE.22 PSI IS OVER BOOSTING.CHECK VACUUM HOSE GOING TO WASTEGATE SOLENOID.MAKE VACUUM IS GETTING TO SOLENOID.IF GETTING VACUUM HAVE WASTE GATE CONTROL ROD ADJUSTED.THATS WHY YOU GETTING OVER BOOST.

Sep 21, 2010 | 2006 Ford F 350 Super Duty

1 Answer

2002 beetle 1.8 turbo under power the turbo boost goes up and down why


you have a fuel problem that is asociated with you fuel pump, ,,,check fuel preasure and you will see it going up and down

Dec 25, 2009 | 2002 Volkswagen Beetle Turbo S

1 Answer

Hi all ive just brought a saab 9000 2.3 fpt turbo the problem is it just doesnt seem to boost!! it only just touches yellow section on the boost gauge ive changed the vacuum pipes the boost gauge and dump...


since you have done all that and it does make sense to what you have done,the next step is you have to have fuel to make boost please check your fuel preasure ,

Nov 02, 2009 | 1990 Saab 9000

1 Answer

E2200 oil light comes on when cold then goes off after warmed up. The oil level is good


try replacing oil preasure switch, if light still comes on then have oil preasure checked , (when cold) may need oil pump if presure is low, if you caught problem early you wont do any engine damage, again start with the switch .hope this helps.

Oct 15, 2009 | 1988 Mazda B2200

2 Answers

Oil preasure light comes on


Your oil sensor may be faulty, or your may have a leak since you said the fluid level is okay.

Sep 23, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
2006 Ford Mustang Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...