Question about 2000 Mazda Pickup Troy Lee Cab Plus 4

1 Answer

Truck shifts up and down by its self it is a 2000 mazda

Also o/d light keeps flashing on and off also speedometer quit appx same time

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 34 Answers

The OD light flashing indicates a code has been stored in the trans control module. If the speedo stopped working that could be the whole problem, the most common thing for the speedo quitting is the sensor on the top of the rear end housing, that causes 99% of the speedo failure. If that sensor isn't working the ABS light would be on too (if equiped) I would try that first or get a code pulled out of the computer and I could give you a more complete answer. -Jared

Posted on Nov 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I had my 2000 Mazda MPV jump started after I left my lights on and killed the battery. The next day my radio and speedometer are not working and I have to manually shift my car to get it moving and it...


I think it may be an electrical issue but I think it's just a fuse. There are 2 fuses I would check. One of them is a 15 amp fuse inside the fuse panel inside the vehicle (see fuse layout below) and the other is a 40 amp fuse in the fuse panel under the hood of the vehicle in the engine compartment (see other picture below). I marked the fuses to check and hope this is the problem.

3_19_2012_6_41_46_pm.jpg

3_19_2012_6_42_13_pm.jpg

Mar 19, 2012 | 2000 Mazda MPV

1 Answer

The car worked fine, then when parking, I tried to put car in reverse, and nothing happened. I tried again and it lurched into drive, stopped and now will not go anywhere, not even roll. Reviewed the...


Did you notice if your speedometer quit working at the same time? If so, there is a glimmer of hope, it may be a vehicle speed sensor problem. Otherwise, it sounds like the trans just took a dump. Try shifting the trans into ALL gears (including 2 and 1) to see if that makes a difference.

Aug 21, 2011 | 2000 Mazda 626

1 Answer

My 1997 Mazda MPV Hold light keeps flashing


There is a speed sensor for the transmission inside the speedometer gauge.
if the speedometer cable is broken the hold light will blink. indicating a trans
malfunction code and the transmission will not work properly.
do not drive too long without a speedometer cable.

May 01, 2011 | 1997 Mazda MPV

1 Answer

1999 Mpv hold light flashing and speedometer stop working, change speedometer and still same problem..????


Hello your speed sensor is malfunctioning this is connected to your speedometer.this is usually located on the top of your transmission 10mm 0r 3/8 bolt single plug this will restore your vehicle speedometer.

Feb 04, 2011 | 2000 Mazda MPV

2 Answers

If my trans was unplugged will the speedometer quit working and trans quit shifting? 04 chevy 5.3 z71 vortech


YEP YOU NEED VSS SENSOR HOOKED UP SO TRANSMISSION CAN SHIFT RIGHT.AND SHIFT TO OVER DRIVE AT SET SPEED. YES YOU NEED TO SEE YOUR SPEED TO KEEP FROM GETTING A SPEED TICKET.DONT UNPLUG IT.

Feb 02, 2011 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Speedometer quit on a 2000 intrepid. And it quit shifting gears at the same time


A common issue are the input and output speed sensors.When bad they cause the vehicle to go into limp mode keeping it in second gear and speedometer sometimes no longer works.

Jul 06, 2010 | 2000 Dodge Intrepid

1 Answer

Transmision quit shifting spedomitor quit working


The transmission quit shifting, and the speedometer quit working.
When you say the transmission quit shifting, do you mean you backed out of your driveway, started driving down the street, no speedometer, and you just stayed in 1st as the engine RPM's got higher and higher ?
Please explain what has happened. You should also have a check engine light on in your dash. You will have to plug a OBD II reader in to pull any codes, so we can help you find the problem. Please let us know.

Feb 10, 2010 | 1999 Chevrolet Cavalier

1 Answer

Speedometer doesn't work and the holdon light flash


1993 mx-6 v6 "hold" light flashes, speedo doesnt work but car shifts fine. mechanic at mazda says that there is no way to tell if its the guage cluster or ecu- recomends junkyard replacements of both or do cluster first then try ecu. Checked speed sensor and wiring and says they are fine. we paid alot for this diagnosis figured i would pass along.

Jul 24, 2008 | Mazda 626 Cars & Trucks

1 Answer

1990 mazda mpv


Speedometer cable is broken. Don´t speed more than 35mph until a new speedometer is replaced.

Jul 22, 2008 | 1990 Mazda MPV

Not finding what you are looking for?
2000 Mazda Pickup Troy Lee Cab Plus 4 Logo

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...