a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This could be the BCM or Body Control Module that has gone bad or needs to be reset.
1 Press and hold the unlock button on the keyless entry remote. Wait for the alarm to disengage and the headlights to flash one time.
2 Insert the key into the ignition. Turn the ignition to the "ON" position.
3 Wait 10 seconds. Look at the dashboard warning lights to make sure that the "security" light is no longer blinking.
4 Start the engine to make sure that the vehicle is operating properly.
IF CAR DONT CRANK CAN BE THAT BATERY IS EMPTY, STARTER OR IGNITION SWITCH. IF ALARM SISTEM IS ORIGINAL TRY THIS: CLOSE ALL DORS AND HOOD, TRUNK AND LOCK AND UNLOCK PASENGER DOR WITH KEY. THIS RESET THE ALARM (IF BATERY IS DISCONECTED) MARKO
sometimes turning the ignition on 3 times quickly without starting will reset the computer. If the van has power locks and keyless entry then try using only the keyless entry. Sometimes your car wont have a alarm but an anti theft device which will not allow it to start if it goes off or something triggers it.
the battery says 12 volts but may be dropping to 4 or 5 under a load...i would suggest jumpstarting the car and see what happens.the battery should read in the high 12 volts and not less than 9.5 under cranking. the dash lights go out on your car when starting,and the alarm will go off ,and disable the ignition if the voltage is too low in cranking the car because the computer will shut it down and activate the anti theft.....check your battery posts are tight. best of luck
Flash headlights 4 times. Alarm will enter programming mode. This will be confirmed by "beeps" from the alarm and flashing led on gearshift. Program each transmitter (up to 5) by pressing the lock or unlock button on the each transmitter once. The alarm will "honk" when you press the transmitter button. The alarm must honk 5 times to complete the programming. Therefore, if you are only programming one transmitter you should operate the transmitter 5 times. If you are programming two transmitters you will operate one transmitter twice, and three times on the other. For five transmitters you will operate each transmitter once.
you probably have a broken wire in the ignition that reads the resistance in the chip in the key. there are two wires that attach the ignition switch to the security system.I had the same problem and it can be easily fixed by putting a resister in place of the chip in the key.any garage that puts alarm systems in cars will be able to do this very easily and very economically.