Question about 2005 Jeep Wrangler

2 Answers

Engine light goes just went on... 95 jeep wrangeler 2.5L

This morning, the engine light on my 95 jeep wrangler, 2.5L went on..I did not notice anything wroung with my jeep...

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

If the light is still on, try disconnecting the battery for 15 minutes. When hooked back up the light might not come on again. If so, don't worry about it till it lights up again.

Posted on Apr 20, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

Go to auto zone or parts store like that and have them pull the codes...it will help in fixing it

Posted on Nov 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 95 jeep Cherokee I went to fill up as I was putting gas the jeep was running. Once it was full I turn jeep off went into store came out and it wouldn't start back up. Changed the coil nothing...


Could be the ecu in need of repair, not sending power to the coil. If there is no check engine light coming on, in the dash, with the ignition turned on, then it's probably the ecu.

Sep 18, 2013 | 1995 Jeep Wrangler

1 Answer

My 1994 Jeep Wrangler: Upon starting the Jeep, the check engine light has been coming on. Sometimes it is on upon starting the engine and sometimes it will not come on until a few miles or so down the...


Try replacing Co2 sensor, most people don't realized that unit need replacing every 50-75k miles also. if that does not work, take it to the dealer and have them plug it into the computer, that will allow for them to narrow it down. with service engine light on, it will effect some of your gas mileage and the performances. The dealer charge somewhere around 50 bucks to diagnose using their computer, however 50 bucks will appilied toward the repair bill if they do the work.

Nov 24, 2010 | 1994 Jeep Wrangler

1 Answer

My jeep wrangler 95 can't be start, because check enginge line can't ON.when i'm remove general cable from batery, end wait until 2 hour, plug cable on batery. check enginge light is ON and enginge can...


i have the same prob with mine. if u trun the key to the on and leave it sit there the ck engine light will come on in a few minutes then it will start. I think it is the computer but i have not got it check yet but i have to do that every morning and then it works fine as long as it stays worm.

Jun 08, 2010 | 1995 Jeep Wrangler

2 Answers

Jeep 2007 Wrangler Unlimited X 4x4 4 Doors


Sounds like a short in the electrical system. Maybe even just a loose ground wire. On the other hand...It could just as easily be a bad ECM (BRAIN)! Warranty still in tact? I hope so. Diagnostic at a certified Jeep shop... Good Luck!

Apr 09, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

I have a 95 jeep wrangler the 4 wheel drive will not engage into 4 high or 4 low when you put the shiftter into the postion if feels like it goes in but does not engage and the light does not turn on...


My Wrangler had the same problem, it ended up being a vaccum leak on the front axle shift motor. It is located in the middle of the front passemger side axle tube.

Feb 22, 2010 | 1995 Jeep Wrangler

1 Answer

95 2.5 jeep wrangler stalls consistantly and will restart after 20-30 minutes. i've replaced fuel filter and fuel pressure regulator, cleaned cam and crankcase position sensors, checked fuel line and...


I had the same issue with my 4.0, I went through all the same BS you did and in the end it was a faulty fuel pump. Pricy i know but im sure thats your problem

Nov 15, 2009 | 1995 Jeep Wrangler

1 Answer

Check engine light code PO456


most likely the pressure sensor in the fuel tank for the evap system is defective.

Feb 25, 2009 | 2004 Jeep Wrangler

Not finding what you are looking for?
2005 Jeep Wrangler Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...