Question about 1995 Nissan Pickup

2 Answers

1995 nissan truck

Can i replace the 5 speed with an automatic?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 41 Answers

Yes but why would you want to?

Posted on Nov 24, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 599 Answers

Yes

Posted on Nov 13, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 ford f150 truck 302motor what trannsmission did ford install


Hi There,

It should be either a 4R70w or E4OD, check the trans code on the drivers door decal and compare it to this list.

Transmission codes from 1995 Manual M = manual 5 speed overdrive (Mazda?) E = Automatic E40D G = C6 auto U = 4R70W (4spd auto with overdrive) C = manual 5 speed close ratio (Z-F) W = 5 speed H.D. Overdrive Transmission codes start with "TR" then are followed by one of the letters above.

Oct 08, 2013 | 1986 Buick Electra

1 Answer

Truck starts but will not stay running


Try doing this service.

Engine stalling and rough run issue at low speeds

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control



Jun 23, 2012 | 1995 Nissan Pickup

1 Answer

1995 nissan automatic truck faltering in reverse


This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner from NAPA or Carquest or others (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to raise the base idle control.

May 30, 2012 | 1995 Nissan Pickup

1 Answer

Where is the mass air flow sensor on 1995 nissan maxima 5 speed


It's strapped on with two clamps, inline, on the intake tube, immediately after the air filter.

Mar 14, 2011 | 1995 Nissan Maxima

1 Answer

I have 1995 nissan sentra automatic no reverse


great little cars, but you will need to price a transmission overhaul or used replacement. happy holidays

Dec 30, 2009 | 1995 Nissan Sentra

1 Answer

Nissan starter


Try replaceing the starter realy but if itsa 5 speed try bypassing the clutch safety switch with a paper clip and you might see that it will start, the clutch switch is on the clutch pedal, if it's automatic it's on the brake switch.

Jun 25, 2009 | 1998 Nissan Frontier

1 Answer

How to change transmission fluid????


Transmission Fluid Replacement Replace transmission fluid as follows:
  1. Operate engine until reaching operating temperature.
  2. Turn OFF engine.
  3. Remove the drain plug.
  4. Drain the transmission fluid into a suitable container.
  5. Install drain plug.
    • Torque to: 22-29 lb-ft. (29-39 Nm)
  6. Refill fluid to specified level.
Fluid Type Specifications 4 Speed Automatic Transmission - Nissan Matic "D"
5 Speed Automatic Transmission - Nissan Matic "K"
NOTE: Using Automatic Transmission fluid other than Genuine Nissan ATF will cause deterioration in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the NISSAN new vehicle limited warranty

Jun 20, 2009 | 2004 Nissan Altima

2 Answers

Transmission


Transmission
Typo and model:
1.- 4-speed automatic AW-30-40 (6cil start of 1993)
2.- 4-speed automatic 42RE ( 6cil 1993)
3.- 4-speed automatic 46RH ( V8, 1993-1995)
4.- 4-speed automatic 44RE ( 5.2L V8, 1996)
5.- 4-speed automatic 46RE ( 5.9L V8, 1998)
6.- 5-speed automatic 45RFE( 4.7L V8, 1999 in WJ)

Enter the VIN in here: http://jeep.avtograd.ru/VIN/vin_en.asp

Also cHeck this info: http://www.jeep.com/en/4x4/systems_by_vehicle/

Good luck!!!

Dec 05, 2008 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Nissan Pickup Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...