Question about 1992 Honda Accord

2 Answers

Removing the inside door lever, front driver's side

How do I remove the inside door lever, driver's side, on my Honda accord 92. Every other screw came off but the lever will not, even after removing the allen scew on the plastic cover.

Posted by on

  • Anonymous Mar 15, 2014

    The lever on inside front door is stuck causing it not to close

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 26 Answers

By lever, I take it you are refering to the handle that opens the door.

If this is what you are talking about, remove the screw under the plastic cover. Slide the whole assembly to the front of the car and pull the assembly out; there are two clips holding the assembly to the door. You have to push hard to slide the assembly.

Posted on Nov 16, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 275 Answers

Some of them have plastic hooks on them also try sliding it up down left and right it should pop loose and you will be able to pull it out

Posted on Nov 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver side mirror replacement


Instructions1.
    • 1
Remove thedoor panel. Refer to your Honda Accord repair manual for theinstructions in removing the door panel. Unhook the rods and connectors on theinside of the door panel and set it on the floor.
    • 2
Remove thefilm covering the access to the side mirror. It's difficult to avoid damaging thefilm while removing it so you will need to purchase a new piece of filmcovering when you buy a new side view mirror.
    • 3
Reachthrough the service hole into the mirror housing with a screwdriver. Loosen thescrew that holds the mirror. Twist the screw out with your hand.
    • 4
Reacharound the door and support the mirror with your other hand. Continue to twistthe screw out, then catch the mirror as it drops out when you remove the screwcompletely. Put the screw in a safe place so you don't lose it.
    • 5
Installthe new side view mirror by positioning it where the old mirror was. Insert thescrew you took out in Step 4 and twist it in with your hand. Insert ascrewdriver into the service hole to tighten the screw.
    • 6
Replacethe film covering that was damaged when you took out the old mirror. Push itinto place in the indentation on the door.
    • 7
Sit in thecar seat and adjust the mirror so you can use it properly.

Jul 06, 2012 | 2005 Honda Accord

1 Answer

92 Honda accord drivers side door won't open. And


IF DOOR WONT OPEN FROM INSIDE THEN IF YOU LIVE UP NORTH RUST IS PROBLEM.....TAKE A FUNNEL POUR BRAKE FLUID WHERE THE LATCH IS....WAIT 1-2 DAYS AND DOOR WILL OPEN.....SHORT TERM FIX

May 23, 2012 | 1992 Honda Accord

1 Answer

Front interior driver side door handle in my 1994 Honda Accord LX is broken. How do I replace it with a new one?


remove the inside panel of the door. the arms that attach to the handle will need to be removed , ( they are little plastic clips that usually are very brittle,, so use care in removing them. ) replace the handle with the new one,, Its really pretty easy once you get the inside panel off and an actually see what your doing, good luck

Apr 22, 2011 | Honda Accord Cars & Trucks

1 Answer

I need to replace the passenger side mirror on my '99 Accord. It has power widows/locks. I have the replacement piece in full, but hesitate to begin removing the door panel w/o some knowledgeable advice....


you have to remove the door panel and upholestry as well as the side shield blocking the bolts to the mirror.

1.)remove door upholestry by unscrewing the screws,
  • under a hide cap by the door handle,
  • under the door opening lever
  • and some other places Look closely
  • remove the clips by prying the panel back.
  • remove electrical jacks connecting to the switches of the door
2.)remove the side shield blocking the bolts to the mirror

install new mirror.

Mar 04, 2010 | 1999 Honda Accord

1 Answer

Unable to unlock the driver side door on a 1991 Honda Accord


You likely have a "link rod" that has either broken it's clip, or come unclipped from the lock and handle assembly. It could also be a broken door handle itself. It's very difficult to tell untill you have the door panel off to inspect. First, pull the door panel. Should be one screw in the inside door handle (#2 phillips), and 1 or 2 (can't remember) in the inside of the hand grab (also #2 phillips). To get the door latch and lock assembly off the door panel, after removing the screw push the assembly forward (towards the front of the car) and pull outward lightly on the back of the latch assembly. Once off, you will see two metal link rods with plastic clips on them, one for the door release and one for the lock. To remove the rods from the clips, look for the "open end" of the clip and push it. This will swivel the clip out of the way and the rod will lift out of the hole. About 90 degrees of rotatiojn should be enough, and from what I remember, they will rotate (looking down) counter-clockwide to release the clips After that, it's just door panel trees. If I remember correctly, there are between 8 and 10 of them. Start at the door catch/latch and work your way around. If you have a door panel removal tool, use it. If not, a single, or even better a pair of thin (1 inch wide) putty knives can be used. Flat blade screwdriver is the last resort. Once the door panel is off, check the other ends oif the link rods you just took off. If one isn't connected, bingo. If it is, then remove the door latch from the door frame using a 10mm socket and an extention. I believe there are 3 bolts holding the latch to the door. Check the opperation of the latch off the car using a screwdriver to act as the door striker, and opperate the levers the link rods move by hand. If the latch is bad, replace! the Stick

Dec 10, 2009 | 1991 Honda Accord

1 Answer

Take apart honda accord drivers side door


inside the handle there is ONE screw covered by a piece of plastic. remove the plastic and then remove the screw. pull handle out and disconnect it from the door latch bar. replace in reverse

Sep 17, 2009 | 1997 Honda Accord

1 Answer

How do you remove the door panel drivers side front on a94 accord


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Jul 15, 2009 | 1994 Honda Accord

1 Answer

'92 Honda Accord driver's side door won't open from interior


1. This may require removal of the interior door panel which should not be too difficult to figure out where all of the screws are.
2. Take your time and don't get too wild when forcing or pulling anything. If it fails to come off there is probably yet another clip or screw you missed. Many of the screws are hidden under little caps.
3. I would find a wrecking yard near you that has the part and know ahead of time if you must pull the donor part or if they pull it for you.

May 31, 2009 | 2000 Honda Accord

1 Answer

How do i fix my locked driver side door


Check the door 'pull' that you pull out to open the door on the inside. It is probably broken. I believe there is one screw to remove, which allows you to slide the plastic base off the pull, exposing the end of the lever, which may allow you to see if it's broken.

Apr 16, 2009 | 1991 Honda Accord

1 Answer

2005 Honda Accord


behind the inside door handle by removing the inner cover you well find two screws remove them by the inside grab handle on the door there is a small rubber mat remove the mat on the upper right corner is a trim piece it just pops off once the screws and trim is removed use a small screw driver and go below the door panel and wedge it between the panel & door and pull back on the screw driver until you here a pop the door panel is held on by plastic clips :caution--when removing the panel DO NOT YANK ON THE DOOR PANEL. THE INSIDE DOOR HANDLE IS STILL ATTACHE D TO THE DOOR PANEL. if you dont unhook this cable before removing door panel you will break the plastic end of the cable if you break this you will have to replace the cable then this well involve removing the latch because the cable is hooked inside the latch hope this helps

Nov 11, 2008 | 2005 Honda Accord

Not finding what you are looking for?
1992 Honda Accord Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...