Question about 1987 Isuzu Trooper

1 Answer

How do i adjust the clutch on a 87 isuzuz trooper

Does anyon know how to adjust the clutch thanks noel

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 94 Answers

The cluch is operated by a cable, the adjustment is at the fire wall in the engine compartment [drivers side] on the cable. To adjust the cable loosen the lock nut, then loosen adjusting nut for more freeplay or tighten for less freeplay. Freeplay is checked at clutch pedal, it should have approx. 1/2 to 3/4 inch of freeplay.

Posted on Nov 24, 2008

  • Jerry gross Oct 29, 2016

    Many thanks for the helpful information.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I adjust the clutch in my 1993 Isuzu trooper? I have about an inch left until I can't shift anymore....


ok, there are 2 clutch systems.
cable
and hydraulic. (its self adjusting but when bad, not)
the cable type adjust like all cars made, with this.
its a nut on the end of cable, called setting free play every 30k.
if hydr.
the is the MC fluid dropping?, if yes, its bad. it or slave or both.

ill attempt to rear online FSM for you (alldata.com) so can you if you want.
yup, the book shows it had both types. (im sure its a cut of year,but 1994 is a long time ago )
with the below data, it seems the cable ended in
  • 1992-95 Pick-Up and Amigo with 2.6L engine-6.7-7.1 in. (171-181mm)
  • 1992-95 Pick-Up and Amigo with 3.1L or 2.3L engine-7.3-7.7 in. (185-195mm)
  • 1988-91 Pick-Up and Amigo-7.3-7.7 in. (185-195mm)
  • 1985-87 Pick-Up-8.12-8.51 in. (206-216mm)
  • 1981-84 Pick-Up-6.5-6.8 in. (164-174mm)
  • 1987 Trooper II-9.1-9.5 in. (231-241mm)
  • 1985-86 Trooper II-8.12-8.51 in. (206-216mm)

the above is free play cable on all of these cable cars.

so yours is Hydraulic, if you read the operators guide
it told you to check this, along with the brake MC
same way. full to the line
i bet its not......
if it drops (same with brakes)
that is bad news, it has leaks.
it can leak 2 common places.
off the slave cyl, end, driving to work, not ever seen.!
or off rear of MC down fire wall. is it?

or rust cause leaks in lines. or loose fittings......
all of this is checked first.. looking.....

MC = master cylinder.....

Aug 25, 2015 | Isuzu Cars & Trucks

1 Answer

Check engine and trans light are on a 2001 Isuzu trooper 2 X 4, I took it to auto zone the diagnostic check showed loose band on transmission I know that I need a torque wrench to adjust I need to know...


The band adjustment in not a torque adjustment. Drop the main pan on the transmission. You will see the valve body with filter on it. At the rear drivers side you will see a round dome piece with a flat flange with four bolts in it. Remove the bolts and take this cover off. Now you will see a round piston with an adjustment screw in it. Break the jam nut loose and tighten the allen bolt in until tight. Back off five complete turns and reset jam nut. When you have the pan off, take note of how much clutch material is in it. If you have a lot it could be time to replace the clutches. Also it is a good idea to put in a new filter if you are in there. Good luck

Oct 07, 2010 | 2001 Isuzu Trooper

1 Answer

I have a 94 Trooper. I bought it new. It now has


No most of the time the clutch can be adjusted

Mar 05, 2010 | 1994 Isuzu Trooper

1 Answer

Where is the clutch fluid tank on a 96 isuzu


usally on front of master cylinder if is auto u put it down dip stick

Oct 05, 2009 | 1995 Isuzu Trooper

1 Answer

Isuzu Trooper Clutch Pedal Issue


either it is a clutch fluid line busted (most likely)or its you clutch master you can start it anyway give a little gas in 1st and start it shut it off b4 starting i drove my volvo 740 home like that once nerve wrecking but save towing money

Jun 19, 2009 | 1993 Isuzu Trooper

1 Answer

Clutch goes all the way to the floor no pressure


You need clutch fluid. Locate your clutch fluid reservore and check it. If this is not the case your clutch needs to be adjusted or replaced.

Apr 25, 2009 | 1993 Isuzu Trooper

1 Answer

Clutch on 91 trooper


Hydraulic clutch= Bleed the System
Cable clutch= adjust the cable

Feb 27, 2009 | 1987 Isuzu Trooper

1 Answer

95 Trooper clutch pedal travel only operates on the last third of


i used to have the same problem with my izuzu trooper there is an adjustment bolt at the back of the pedal near the fire wall of the car that has to be tightened if its not that then your slave cylinder might be going and you should get it replaced

Feb 22, 2009 | 1995 Isuzu Trooper

1 Answer

Clutch release cylinder


just remove the brake line from the cylinder before you unbolt the the slave. just reinstall and bleed as if it were a brake system . if you have a problem bleeding let me know i has a small trick that will help, but if you bleed it normaly i would do it this trick my cost you to make a tool.

Jun 11, 2008 | 1991 Isuzu Trooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

838 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...