High preasure line for 1995 ford explorer 4.0?

Most likely the seals on either the pump or the rack and pinion. Could be a leaking hose between the two. Might be a loose or leaking hose connection at the pump or at the rack and pinion. If you lose the fluid in a short period of time it shouldn't be to hard to find the leak, and you are also smelling it burn when it hits the the exhaust pipes. Refill the system and with the engine running have someone turn the steering wheel back and forth while you look at the pump, lines, and at each end of the rack and pinion. you WILL find the leak.

you have a loose preasure line ...that bolt you left out find it and put it back

LOOK to see where it is leaking from and repair accordingly.

it sounds like it is pumping too much pressure, you need to take the vehicle to a power steering specialist & have the pressure adjusted otherwise you will just keep bursting hoses or the seals on the steering rack......hope this helps.....cheers.

RETURN TURN LINE GOES TO THE LEFT OF RACK PINION AND HIGH PRESSURE HOSE GOES TO THE RIGHT OF RACK PINION.LOOKING AT POWER STEERING PUMP HIGH PRESSURE HOSE THICK HOSE SCREWS INTO POWER STEERING PUMP.WHILE LOW PRESSURE HOSE HAS A HOSE WITH A CLAMP THE LOW PRESSURE HOSE HOOKS TO TOP OF POWER STEERING PUMP.LOW PRESSURE DONT SCREW INTO POWER STEERING PUMP IT IS HELD IN PLACE BY A HOSE SMALL CLAMP.

the return line is only held on by clamps at both ends or one end at the rack assembly,even though the fitting it connects to may have a nut fitting that threads into the rack.the pressure line always has fittings at both ends that can only be fastened onto the pump and rack by a wrench(or line tool).

you are leaking power steering fluid. the high pressure line is the most common problem with windstars. other leakable parts are the rack and pinion, power steering pump, low pressure line or power steering reservoir.

YOU CANT USE A REGULAR FUEL LINE ON POWER STEERING AS A HIGH PRESSURE HOSE.BECAUSE POWER STEERING PRESSURE IS 1000 PSI.YOU HAVE TO BUY THE POWER STEERING HIGH PRESSURE HOSE IT HAS NUMBER OF PLIES MATERIAL WEAVES TO MAKE IT STRONG.IT WAS MADE FOR POWER STEERING HIGH PRESSURE.YOU DONT HAVE A BLOCKAGE .THE HIGH PRESSURE HOSE JUST WORE OUT.REPLACE IT .IT SHOULD FIX THE PROBLEM.

What are we talking about? Preasure side of AC compressor pump? Power steering pump?
If AC, then possibly from a leaking AC-high preasure switch on the back of the compressor. The leak could be simply the O-ring. You simply unscrew it and install the replacement making sure the O-ring is good and in place. The switch can leak also. This part is hard to find accept at the dealer. It has a 4-wire connector on it.

replace the high pressure line