Question about 2002 Mercedes-Benz C-Class

2 Answers

Non start my dad has a 1995 merc c220 petrol auto. the other day the engine stalled while driving along and wouldnt restart. it was left for an hour then was able to start. when i got the car home i had it running for about 40 mins then it cut out again and now it just wont start. i have checked for a spark and found it wasnt sparking. i have checked out the crank pos sensor and all checks are ok but tried a new anyway but still do not have a spark. any ideas? thanks keith. also the car has done 170,000 miles and the auto box fluid and filter have never been replaced (not sure if this will help) many thanks keith

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

C220 turn signal off i do not which fuse is which. it says number 6 but i can not tell which it is, please advise

Posted on Jan 13, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Crank position sensor, roughly about £50 from mercedes.

Posted on Nov 24, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Merceds W202 C220, it only crancks but doesnt start. i've changed spark plugs but still wouldnt Start

You are either not getting fuel or the crankshaft position sensor has failed. on some mercedes the fuel pump will not run if the computer does not see rpm. so the easiest and cheapest attempt to repair is replacing the crankshaft position sensor. it is located at the back of the engine near the transmission bell housing.

Oct 20, 2017 | Mercedes-Benz C-Class Cars & Trucks

1 Answer

I have a 1995 chevy lumina ls . i was driving down the road and came to a stop sign. it stalled out , this done it several times. then a few days later i went to go start it and it wouldnt start, i moved...

You may have a defective neutral safety switch. The switch is located on the outside if the transmission case and it is where the cable connects from the shooter inside the car. This covers the no start, the stall is likely due to a dirty throttle valve and idle speed control valve.

Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control.
Below is a picture of the switch I mentioned.


Sep 25, 2012 | 1995 Chevrolet Lumina

2 Answers

The gas gauge does not work on my 1995 c220. How do I troubleshoot the problem?

Most likely its the seding unit in the tank. Pull it and move the float to check.

Jun 12, 2010 | 1995 Mercedes-Benz C-Class

4 Answers

Hi there,i have a c200 elegance 2005,i seem to be having problem after problem and my pride and joy is becoming a money pit!! well here goes,it wont rev past 3000 revs, i was told this would be the mass...

You must be having a check engine light or maintenance coming up on the dashboard, if yes the best way to start troubleshooting this problem is to run a diagnostic test on the vehicle.Also after changing the mass air flow meter did you reset the ECM ?If not then this is required after any repair you do.Hope this helps.

Mar 17, 2010 | Mercedes-Benz CLK-Class Cars & Trucks

1 Answer

Starting and running

check if the power to the fuel pump gets constant power when switched on it may have a electrical problem you may need to get a auto elect tech to help you

Aug 04, 2009 | 2004 Dodge Ram 2500

Not finding what you are looking for?
2002 Mercedes-Benz C-Class Logo

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

77194 Answers

Joseph Prosser

Level 3 Expert

771 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides