Question about 2004 Chrysler Pacifica

1 Answer

Removing the stereo

How to remove the stereo from a 04 chrys pacifica?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 43 Answers

These instructions are available at

Posted on Nov 13, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Locatiom of pcm 04 pacifica

Behind the front left wheel splash shield 1. Disconnect the negative battery cable. 2. Raise vehicle and support. 3. Remove the left front wheel. 4. Remove the left front splash shield.

5. Unlock and remove the 4 connectors . 6. Remove the 3 mounting screws . 7. Remove the PCM.

Dec 01, 2016 | 2004 Chrysler Pacifica

1 Answer

How do I remove and install heater blower motor

04-08 Pontiac Grand Prix - Blower Motor Resistor ... - YouTube

? 7:32
Oct 8, 2012 - Uploaded by GPVlog
04-08 Pontiac Grand Prix - Blower Motor Resistor ReplacementPart 1 ..... Loosen, but do not remove the two frontward screws, then remove the single rearward .... Pontiac Grand Prix StereoRemoval 2004-2008 - Duration: 4:27. by Factory Car Stereo ...Pontiac Grand Am ,HVAC, Heater Fan will not turn on.

04-08 Pontiac Grand Prix - Blower Motor Repair (Part 1 ...

Dec 03, 2015 | 2004 Pontiac Grand Prix

1 Answer

04 pacifica front blower stopped working,back blower works doing a delay count down

chances are it is the blower motor resistor, it is located under the glove box and can be identified as the small object that the fan wires connect to and since it is cooled by the blower you can reach in and make sure the fan blades will turn if you push them. blower are known to go out but that is usually due the bearings wearing out and it would have been screeching loudly for the last several months. if you want to check the fan motor you can make sure it physically spins and check for resistance on the 2 wires with a multimeter.
if you decide to replace the resistor yourself (which should take 15 min) buy the part from a local store as there are 2 different blower motor resistors used in 04 and 05 pacifica and no good way to identify the 2 different versions you can return the wrong part and present them with the part you removed from the car for them to match up

Dec 13, 2013 | 2004 Chrysler Pacifica

1 Answer

How do I install a vehicle speed sensor in a 2006 chrysler pacifica 3.5L

here is the link for the part you need.

Simple as pie. Once you have the part in hand, You will see where it plugs in near the intake. Just follow it to the other end, remove and replace.

Should be a 10mm bolt holding it down, and to remove the plug, just press the retainer tab and pull out. New plug snaps right in.

Dec 10, 2012 | 2006 Chrysler Pacifica

1 Answer

I have an 04 chrysler pacifica and once the gas level gets below a 1/2 tank it drops all the way down to empty?

you may have a problem with the fuel level sensor were the lower part of the sensor that indicates how much fuel there is below half a tank.the only way is to remove the unit from the tank and inspect for damage,it may have to be replaced.

Aug 12, 2011 | 2005 Chrysler Pacifica

1 Answer

Where is the alternator located in the chrysler 04 pacifica/

The alternator is hiding under the engine cover. You must remove the engine cover if you have one. Locate the power steering fluid resevior. The alternator is right behind it.

Oct 24, 2010 | 2004 Chrysler Pacifica

2 Answers

'04 Chrysler Pacifica battery won't hold a charge for long. Sometimes it will be fine for months and then not start. Other times it won't last more than a day. I was thinking it must be a parasitic drain...

First try to understand if there is a parasitic drain.

Once you exclude the drain, replace the battery, a battery with shorted cells can cause the drain.

The firmware has nothing to do with drainage, unless the unit is factory defective.

To measure drainage remove ignition key, connect the amp meter between the battery positive wire connector and positive terminal.A couple of milliamps drainage is normal, and is caused by instruments, car stereo memory, ECU etc.
Start removing more fuses , and open the wiring at different points , trying to locate the problem.
Remove the fuses and see if you have drain by connecting a meter to read amps on battery, if you have drain with no fuse, then the problem is insulated to wiring harness before the fuse, with something shorted between the battery and the fuseblock.
Also check car stereo and car amp HU, the HU can keep a unit on when the ignition key is off, causing drain.

Mar 03, 2009 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides