Question about 2001 Buick LeSabre

Open Question

How to fix a 2001 buick lesabre light sensor

How to fix a 2001 buick lesabre light sensor

Posted by on

6 Suggested Answers

  • 56 Answers

SOURCE: 2001 buick LeSabre cruise control

no not a fuse may be the switch itself this is common and parts are not badly priced. replace the switch. It just pops out. The directions will tell you to take out the airbag first but it will sneek out of there.

Posted on Feb 13, 2009

messstat
  • 365 Answers

SOURCE: I have a 2000 buick lesabre. The fix engine soon

It NEVER was the camshaft sensor! Unless, you've removed the engine lately, which I doubt.
RUN to Advance Auto Parts and buy a can of "SeaFoam" and add to your gas tank per instructions...drive at least 100 miles and the problem should go away...IF it doesn't you'll have to replace the O2 sensors in the exhaust system...Any good mechanic should be able to do this for much less $$ than the dealership DO NOT go to the dealer for repairs!
Good Luck

Posted on Jun 22, 2009

honeymokey
  • 3113 Answers

SOURCE: 2004 Buick Lesabre speedometer not working

Yes it's on the right side othe transmission just above the passenger side cv axle. You most likley need to send the cluster off and have it checked. Model Electronics in NY.

Posted on Oct 09, 2009

Tnsiouxfalls
  • 617 Answers

SOURCE: 2001Buick LeSabre parking light

On top of the headlight housing are two large knurled black plastic knobs.Unscrew them counter-clockwise.Now the whole headlight housing may be removed. Set it on the bumper and you'll have easy access to the marker light.

Posted on Nov 12, 2009

  • 312 Answers

SOURCE: 2001 buick lesabre gas cap loose warning light

GM vehicles are fmaous for this warning. I had the same problem in my GM vehicle and had to replace the EVAP vent solenoid. Are you getting a DTC yet or just the tighten gas cap message? INspect the fuel cap to make sure it is not damaged and is installed properly. If it's damaged replace it. If all is good on the cap just wait for the DTC to show up but most likely you'll need to replace that solenoid.

Posted on Dec 22, 2009

Testimonial: "very helpful"

  • 1608 Answers

SOURCE: 2001 Buick Lesabre ABS light stays on even

What this means is that the abs module is seeing a problem in the abs system.This has nothing to do with the regular brakes.What you need to do is get the codes from the abs module and this will help in finding what could be causing the light to come on.When the abs light comes on the regular brakes will work normally but your abs brakes will be disabled.Let me know what codes you find and I can help or explain what the cause could be.Good luck.

Posted on Jul 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will do nothing. as if the battery wasnt hooked up. has new battery. no lights. NOTHING


2001 Buick Lesabre: Car Will Not Start Does Nothing Took ...

www.2carpros.com/questions/buick-lesabre-2001-buick-lesabre
Apr 22, 2007 - Car will not start does nothing took battery out to get tested because it would not jump start battery found to be good put battery back in ...

how to fix a buick century that wont crank - YouTube

? 2:44
https://www.youtube.com/watch?v=UWfvEouMMtc
Dec 18, 2009 - Uploaded by jay eltatertoto
how to fix a buick century that wont crank. jay eltatertoto ... How to easily fix a Buick that will not crank and security light flashing - Duration: 6:06. ... My Car Wont Turn Over - How To Test The Starter / NSS / Ignition Switch - Duration: 5:21. ... 2001 BuickCentury Custom - Duration: 19:44. uxwbill 19,621 views.

Car Won't Start Because of Anti-Theft System That Uses ...

repairpal.com > Problems > Buick > LeSabre

Feb 05, 2016 | 2001 Buick LeSabre

1 Answer

How do i fix my 2001 buick lesabre the engine stalls when driving it?


Usually when a computer controlled vehicle stalls while driving it's related to the Crank Position Sensor.

Sep 21, 2014 | 2001 Buick LeSabre

1 Answer

My 2001 Buick LeSabre has electronic load control. The air pump stays on, so my car is jacked up very high at the rear. What do I need to do to fix this problem? Read more: My 2001 Buick LeSabre has...


Your load control sensor under the vehicle is broken or has become disconnected so it thinks you have a heavy load and is constantly running the compressor. you have get under vehicle and look for the sensor it is connected between the rear suspension and the body.

Feb 09, 2011 | 2001 Buick LeSabre

1 Answer

Where is the oil sensor on a 2001 buick lesabre


The Oil Level Sensor is located in the side of the oil pan on the side closest to the radiator. The Oil Pressure Sending Unit is located in the engine block near the oil filter.

Jan 23, 2011 | 2001 Buick LeSabre

1 Answer

Where are knock sensors located on my 2001 Buick LeSabre 3.8L engine


bank #1 knock sensor on lower front of engine block near starter, bank #2 knock sensor on lower rear of engine block next to oil filter.

Jan 15, 2011 | 2001 Buick LeSabre

2 Answers

Lights in the radio doesn't light up


you have to rewire your car its not hiting the power wire all the way

Jun 02, 2009 | 2001 Buick LeSabre

1 Answer

2001 Buick Lesabre


Do you have check engine light on???if so scan it OBD 2 yue$$ding isn't the way to go,if you don't have a check engine light on then perhaps coil pack!!! coils do run intermittent some times! and not trip the eng light on !!!!this would be a great place to start.Hope this helps

Dec 26, 2008 | 2001 Buick LeSabre

Not finding what you are looking for?
2001 Buick LeSabre Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...