Question about 2006 Mercury Mountaineer

1 Answer

Starting i have a 2006 Mercury Mountaineer. when i put the key in the ignition i can not get the key to turn so i can start it. i have pushed on the brake & the steering wheel. still won't work

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

To find out if the key is bad go to local lock smith and ask for a code key from the vin number they will tell you you need a chip that is correct but the key will open the door and turn on the ignition. if the new key works then your key is bad and the dealer can make you one for about 100.00 dollars if it still dont turn then the key cylinder is bad and it will need to be replaced good luck

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 Mercury Mountaineer . I was driving and all dashboard lights came on and made a beeping sound so I turned it off and It will not start. Is this a major fix? Computer switched twice.


Who switched the computer ? Where they programmed ? All dash board lights came on because vehicle engine stopped running ! Will not start how ? When you turn the ignition key to start position does any thing happen ? What I'm getting at here is it a no crank - no start or a engine cranks - no start . Big difference in diagnostic trouble shooting . As far as how much it would cost and is it a major fix ,nobody can say for sure .

Feb 28, 2016 | Mercury Cars & Trucks

1 Answer

Truck wont crank, checked relays, wont even turn over! battery is fully charged. turn the key and it goes dead


fuel pump shut-off reset switch located, and how do i reset it?

www.justanswer.com > Mercury
Find the answer to this and other Mercury questions on JustAnswer. ... The fuel pumpinertia switch is located on the Passenger side kick panel just nuder .... Mercury Grand Marquis LS: 2005 mercury marquis wipers will 10/7/2015 10/7/2015.
2005 Mountaineer Won't Start - Ford Explorer and Ranger Forums ...www.explorerforum.com > ... > Stock 2002 - 2005 ExplorersSep 15, 2009 - 5 posts - ‎2 authors2005 Mountaineer Won't Start Stock 2002 - 2005 Explorers. ... 2010 Mercury Mountaineer Premier, V8 AWD, 35k 2010 Sport Trac Limited, ...1998 Mountaineer Won't Start12 postsMay 24, 20112004 Explorer won't start, just clicks-not battery12 postsOct 17, 2010Won't start, loud rapid clicking sound19 postsSep 26, 200799 Mercury Mountaineer won't start...3 postsFeb 7, 2007More results from www.explorerforum.com2005 Mercury Mountaineer: all the lights come..car wont startwww.justanswer.com > MercuryI have a 2005 Mercury Mountaineer and it won't start. I get a clicking sound and all the lights come on but the car won't start. This happened to me before on a ...mercury mountaineer: wont start..new battery..gauges move ..

Nov 14, 2015 | 2005 Mercury Mountaineer

1 Answer

How to program new keys after replacing the ignition on 2004 mercury mountaineer


Sorry , but it is a dealer item or a locksmith( call and make sure they can do it first). It can be done though. You have to remove the tumblers from the old lock set, so any ford key will turn it. Insert the original key in, for so many seconds, I believe 30. Pull it out and insert the new key. for 10 seconds. Then put in the new lock set and it should start. You get up to 8 keys to do this. After that it is a computer reset. I have the computer to reset them, so it has been a while since i did the lock set relearn.

Dec 16, 2014 | 2004 Mercury Mountaineer

1 Answer

MY 2006 MERCURY MOUNTAINEER HEADREST WERE PUT IN BACKWARDS HOW DO YOU REMO OOE


Where they slide in at the top of the seat there should be a release button on each side. Press and pull at the same time and they should pull out. Then just push them back in

Aug 28, 2014 | 2006 Mercury Mountaineer

1 Answer

2005 mercury mountaineer stulled when i driving and it wont start


Use a bottle of yellow HEET dry gas to remove any moisture problem in the fuel.

Use starting fluid to aid starting.

Jan 13, 2014 | 2005 Mercury Mountaineer

2 Answers

Car will not start


solenoid stuck on top of the starter motor .try hit it as someone turns your key .if starts change your starter.

Dec 21, 2013 | 2006 Mercury Mountaineer

1 Answer

Do 2005 Mercury Mountaineers have keyless entry remotes?


one way to find out is to sit in your vehicle on the drivers side. lock all the doors, stick the key in the ignition and turn it to the on position without starting it then to the off position 9 timesrepeaditly if on the 8th or 9th time the locks unlock then lock or vice versa then the vehicle did come equipt from the dealer with keyless entry remotes. hope ive been helpful

May 15, 2011 | 2005 Mercury Mountaineer

1 Answer

2003 Mountaineer courtesy lights are stuck on


yea , the switch / knob to dim and brighten light's . mess w/ that

May 24, 2009 | 2002 Mercury Mountaineer

1 Answer

Ignition


Sounds like the battery is dead, you have just enough power to have the lights come on, but no cranking of the starter. Try putting the battery on a trickle charger, or hook up jumper cables to another car which is running. Let it run with the jumper cables connected for two mintues before you try and start your car.

Dec 21, 2008 | 2002 Mercury Mountaineer

Not finding what you are looking for?
2006 Mercury Mountaineer Logo

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...