Question about 2000 Chevrolet Blazer

1 Answer

Lifters knocking i have a 2000 blazer this morning it would not start. how long and how much will it cost to get it fix?

Posted by on

  • kelvinluvjan Nov 12, 2008

    I have a 2000 LS blazer this morning it would not start.My lifters have been knocking I think they need replacing can you tell me how much it will cost to fix my lifters and how long it will take to fix it.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,450 Answers

It is all gonna depend on who you take it too. the no start could be a fuel pump gone out. listen and see if you hear the pump run when you cut key on it should run for about 5 seconds. As far as the lifters a set of lifters will be about $100 plus you will need intake gaskets it should pay around 5hrs labor

Posted on Nov 12, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 94' Chevy blazer 4x4, 4.3 L Vortec. It started knocking out of the blue.


No this is a bullet proof engine, but things like this do happen from time to time.

Apr 08, 2017 | Cars & Trucks

1 Answer

Knocking noise


Yes the lifter or one of the valves could be damaged. No the valve cover and maybe the cylinder head would need to be removed to repair depending on what the actual problem is.

Jul 17, 2013 | 2000 Volvo S80

1 Answer

2000 chevy blazer viberates bad


check hub bearings,tie rods,rotors,CV joints.

Mar 10, 2013 | Cars & Trucks

1 Answer

2000 chevy blazer -starts great-idles great when after start in idle-misses when accelorating until shift-then misses occasionally until it warms up-then runs perfrct at any rpm-continues to run perfect...


check see if one of the coil packs have a crack in it. if so replace it if you start the car in the dark with hood poped the crack will show right now looks like a light show

Aug 02, 2011 | 2000 Chevrolet Blazer

1 Answer

2009 Ford Flex when started first thing on a cold morning it ticks/knocs really really loud, once it warms up the ticking goes away to a very light tick. The dealership ruled out an exhaust manifold leak....


It does sound like a valve lifter problem to me also. It should be covered under warranty. It's a mechanical failure of a component of the drivetrain. Ask them to show you the specific exclusion if they say it's not a warranty problem.Powertrain warranty is 60 months/60,000 miles ( which ever comes first).

Mar 30, 2011 | 2009 Ford Flex

1 Answer

Engine knocking on a 2000 Chevy blazer LS. I did a tuneup and no knocking sound at first, drove for 50.5 miles and parked it next morning I started it and it sounded like the lifters were rattling and a...


I don't know what engine you have. If it is the v6 then you probably have the death knock my v6 just did that last month! a new crate motor cost 1200$ and put it in your self.

Oct 17, 2010 | 2000 Chevrolet Blazer

1 Answer

Engine knocking right after a tune up on a 2000 hevy blazer LS


I would say look at each of your plugs. Knocking noise usually come from pre-ignition. So your most likely not getting a good spark in one of the cylinders.

You could have:
Fouled a plug with a piece of engine dirt
Changed the gap while placing it in the engine
Broke a plug wire
Also check to make sure the plugs are in the same heat range (ie exact replacements)

Feb 20, 2010 | 2000 Chevrolet Blazer

2 Answers

2000 chevy blazer (4.3 engine) has a hard time starting in the


dirty fuel filter or faulty pump....just a guess...

Feb 15, 2010 | 2000 Chevrolet Blazer

2 Answers

1996 chevy s10 4.3 vortex lifters knocking at start up but goes away after 10 minutes idling. changed oil and filter oil pump reads 58-60psi at idle and seems to be working.


High milage? Try engine cleaner, run for couple hundred miles and then use an additive like Restore. If it's just dirt this may help. Make sure you are using the correct viscosity oil for winter temps. If it's from wear only parts replacement will fix it.

Feb 07, 2010 | 1996 GMC Jimmy

2 Answers

Were can I find the fuel pump collison switch on my 2000 chevy blazer? I quit a week ago started the next morning, quit again yesterday, pump not running relay checks out, jumper pump does not run?


You do not have a switch like a ford. If you have power for three seconds when key switched on and no fuel pressure you will need a pump. I think its the gray wire on yours. Test at the pump connector

Nov 13, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

Related Topics:

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...