Question about 1996 Toyota Land Cruiser

1 Answer

Toyota prado 1999

3.4 engine petrol, idle stays high at 1500, no other problem, there is no vacuum leak

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 39 Answers

Have you ever replaced the thermostat

Posted on Nov 14, 2008

  • hbonz50 Nov 30, 2008

    why did you rate this as inappropiate?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Toyota coaster it is a EFI.1HDE-FTE engine. While trottling it is fine but if I press the gas pedal and let go, the rev doesn't come down,it stays high, just keep a high rev,what could that be?


Do you have a check engine light on? Are you saying that the engine idle speed is excessively high? If that is the case have you checked for intake manifold vacuum leaks?

Jun 07, 2016 | Toyota Cars & Trucks

2 Answers

1999 Mercury Villager Causes Of High Idle?


usually it is a vacuum leak which is letting more air into the engine. With engine running, use a spray water bottle and mist around all vacuum lines, the power brake booster and engine seams. Then try any vacuum line to the transmission. Could also be a burst vacuum shift diaphram if so equipped.

Aug 31, 2015 | 1999 Mercury Villager

1 Answer

1999 toyota prado


where are you hands, we car blind here,

ball bearings are everywhere. car has 1500 to 3000 parts.
even the steering shaft has bearings.
inside car, outside car.
engine, transmissions, wheel bearings. axle bearings, CV balls.
where.

May 27, 2014 | 1999 Toyota RAV4

1 Answer

Gttarahave a 1996 toyota prado 2.7ltr petrol engine will not idle on petrol or gas but ok once the engine is warm what might be problem


CHECK OR TRY REPLACING THE FUEL FILTER, CHECK SPARK PLUG CONDITION,INJECTORS AND THROTTLE BODY MY NEED SERVICING, A FAULT IDLE AIR CONTROL SENSOR (IAC) MAY ALSO BE AT FAULT.

Aug 25, 2011 | Toyota Land Cruiser Cars & Trucks

2 Answers

My 99 dodge durango idles @1500 when i start it then when i rev it up past 2000 it stays idling @ 2000


Check for vacuum leaks, this is a common problem on the durango. Unmetered air enters the engine and creates a high idle condition.

Aug 21, 2011 | 1999 Dodge Durango

1 Answer

My 1992 toyota v6 pickup is idle high 1200 1500 rpms just had intake gaskit fixed


this is usually a sign of a vacuum leak, if they took the intake off they probably had to take off more than 1 vacuum hose, make sure all the hoses on the intake are in good shape and connected tightly, a good way to find a vacuum leak is to take a can of brake cleaner and just spray the hoses (1 by 1 preferably) as you spray the hoses see if you notice the engine either idle higher or lower, if this happens while your spraying a hose this will be the hose with the leak

Jan 15, 2011 | Toyota Pickup Cars & Trucks

1 Answer

1998 Chevrolet 5.7 Vortec Problems.


Most likely the intake gaskets are bad. they will sag in the middle over time and allow a vacuum leak between the head and intake. recommend replacing the gaskets with the steel instead of plastic ones.

Jan 19, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

Prado high rpm


just besides the air filter over the air intake there is small screw rotate it anticlockwise and see if the rpm comes down or else change the iac (idle air control motor) immediately.

Nov 12, 2008 | 1996 Toyota Land Cruiser

2 Answers

I have a 88 chevy pickup 1500 with a 4.3 liter engine. I have high idle problem. I would do it once in a while and quit. Now it up and wont idle down. I have new throttle position sensor, map sensor. all...


is the check engine light on ? if it idling high chances are you have a vacuum leak take a can of carb cleaner and spray the egr valve and if the engine rpm changes replace egr valve the throttle body may also be plugged pull the vacuum line off the map sensor start vehicle and see if you have vacuum if not remove throttl body and clean vacuum passage hope this helps

Oct 05, 2008 | 1999 Chevrolet K1500

Not finding what you are looking for?
1996 Toyota Land Cruiser Logo

480 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...